Question about Acura Integra

1 Answer

1989 acura Integra has no pulse to the injectors

No pulse to the injectors

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Filmmaker:

    Uploaded 5 video answers.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 35 Answers

I believe I answered this problem in a previous post.

Posted on Apr 28, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mas66
  • 104 Answers

SOURCE: 1996 acura integra idle surging?

Check this out, http://www.hondahookup.com/forums/showthread.php?t=147179
Step by step guide to diagnosing idle issues on your honda.

Posted on Oct 25, 2008

  • 1779 Answers

SOURCE: acura integra engine torque specs

56 ft lbs torque main bearings, NON v-tech engine.

Posted on Jan 15, 2009

  • 153 Answers

SOURCE: timing belt diagram fo 1990 acura Integra

78338863have fun

Posted on Oct 07, 2009

YellowNo5
  • 268 Answers

SOURCE: acura integra rs no spark no fuel pressure

Could be the main relay. It's behind the dash up above your gas pedal. Look for a gray and brownish box with one large plug in it. Should be easy to find since you don't have cruise control. It will be secured with one 10mm. You can bring it into reach with it still plugged in. Try starting it while tapping on the little plastic box. If it starts, pry off the cover with a flat head screwdriver and re-solder the broken connections. The break in the solder will be on the side with the sharp little things. It will be smaller than a hair. To find it you will need to wiggle it. Have plenty of light. Just hold the soldering tool on the broken one until the solder puddles around it and you're fixed.

Posted on Apr 29, 2010

HondaCRX
  • 252 Answers

SOURCE: acura integra using too much gas

Hi GailKol

Is there a yellow light on the dash? Is the car very slow and struggles to rev?

It sounds to me that the ECU (car computer) is in 'limp home' mode. You need to read the ECU's code, usually by the ECU flashing lights, then look at the manual for the reason.

First up, reset the ECu by removing the negative battery lead for 30 minutes or remove the large 75AMP fuse. Run the car and see if the light returns or that it is still consuming too much gas. Then...>

One of the most common reasons for poor gas mileage on Acuras/Hondas is the O2 sensors in the exhaust manifold. These can breakdown instantly and cause rough running and poor gas mileage. There are two on the two exhaust banches. If you change one it is best to change both.

Check the air filter for dirt, clean it or buy a new one.
Take the air filter housing off and run car cleaner through the intake manifold.
Clean the EAVC valve which is in the intake manifold while you are there.
Drive the car and take you hands off the wheel, if it pulls to one side then the brakes are seized (usually rear ones) and needs overhaul/new ones, this will cause very poor gas mileage.

Check the cheap/free stuff mentioned above first. I hope this helps and don't give up on your Acura. You have one of the best driver's cars there of the last 25 years :)....I'm very Honda biased :)


Posted on Aug 01, 2010

Testimonial: "Thanks for the good advice. Will check it out."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can i put a 1994 acura integra ls trans to replace a 1989 acura i


I don't think this would be possible wihtout some hassles.

The engine type build changed twice between the 89 and the 94 series integra.

I would suggest you speak to Honda specialised mechanic before you purchase the 94 tranny.

Also check out the Honda forums as they ahve guys who have done some handy things with the ol integra

Feb 09, 2010 | 1989 Acura Integra

1 Answer

Extreme fuel sonsumption+ Idle Bog


try putting fuel injector & carburetor cleaner that mite solve the problem

Mar 11, 2009 | 1989 Acura Integra

1 Answer

Acura integra 96


piston ring is one reason why no power and burning oil

Jul 25, 2008 | 1996 Acura Integra GS-R

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...