Question about 2006 Dodge Durango

1 Answer

Eng.missing on four cyls on left bank

Tried spraying cleaner in throttle body it runs good thin goes back to missing after

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Dodge Master
  • 513 Answers

Use a noid light to check for power to the injectors on that side. Noid should flash with engine turning over, if no signal check the fuse for the injectors .If it is blown check inj wiring for short to ground. There is also a connector for the left injectors located on the harness in the back. Make sure it is connected and tight.

Posted on Dec 04, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
motor1258
  • 6674 Answers

SOURCE: doesn't want to start in 1st gear. auto trans starts in 2nd

As in won't start in park, but will turn over in 2nd? If so, safety neutral switch at transmission.

Posted on Sep 26, 2009

  • 159 Answers

SOURCE: engine running, put it in drive, wont start in

The transmission is in limp mode,usually causeed by gov pressure sensor bad or fluid other than atf+4 was used.

Posted on Sep 27, 2009

roniecon
  • 6927 Answers

SOURCE: 1999 dodge stratus 2.4

Have you checked the alternator output?It should read 13.65,to 14.25 volts,at the battery,with the engine running,and the head lights on,and the heater on high.If it is less than this,the alternator is bad.The engine has to have a lot of volts to run,and run correctly.The ignition system requires this.Check this and let me know what the reading is.

Posted on Jan 01, 2010

stormydreamz
  • 4 Answers

SOURCE: throtel intake blowing out air while cranking

yes it should suck the gas in not blow it out.

Posted on Jun 15, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Honda 2004 accord slows down between 20 and 40 miles when spray throttle body with brake cleaner it runs again why


Try using a carburetor cleaner instead, as it has some lubricants in it's makeup that can actually help the moving parts.

Mar 09, 2015 | 2004 Honda Accord

1 Answer

2010 nissan with 4.0 eng. surges and rpms jump around when eng. is warm.


Steve,

Any Codes?

Check for vacuum leaks with a can of carb cleaner engine running - when engine race up or bogs down there is a leak. Spray all around intake, vacuum hoses, brake booster, and throttle body.

Master Tech Lee

Dec 07, 2014 | 2010 Nissan Frontier

1 Answer

I'd like to get step to step instructions on how to clean the throttle body in my 2010 Jeep Patriot


  1. Purchase "02 Sensor Safe" throttle body cleaner spray;
  2. Drive the vehicle a few miles, bringing it to full operating temperature, then park it in your driveway with the engine still running;
  3. Gain access to the throttle body, and hold your thumb on the butterfly linkage so that you can open the throttle butterfly when the engine begins to load;
  4. Begin by spraying throttle body cleaner spray on all linkages around the throttle body. If the engine begins to bog because it is aspirating throttle body cleaner, quickly open the throttle butterfly to keep the engine running.
  5. Once you have cleaned all around the throttle body, spray cleaner DIRECTLY INTO THE THROTTLE BODY, opening the throttle sufficiently to keep the engine running. It will run rough during this process but try not to let the engine stall.
  6. If the engine stalls, restart it, and continue cleaning the throttle throat until you see clean metal.
  7. Pour some fuel system cleaner into the gas tank and drive the car a little more before parking it. Try to find an excuse to accelerate hard, WIDE OPEN THROTTLE momentarily if safely possible (as when accelerating to merge into traffic on a highway).
  8. Drive back home.
  9. Done.

Jul 19, 2014 | Jeep Patriot Cars & Trucks

1 Answer

Enging just sputtered then quit


If you have throttle body injection (TBI), look at the spray pattern of the injector spray when someone cranks the engine over. You should see a fine mist cone pattern of the injector spray (downward) into the throttle body. If the cone pattern looks good, check for spark-maybe the ignition system has developed a fault. Post back if you need more help. What year and what size engine, 4 cylinder 2.5L, or a V-6?

Jan 25, 2014 | Pontiac 6000 Cars & Trucks

2 Answers

How do i clean the throttle body on a 2006 montana sv6? and where is it. thanks


the throttle body is where the black round air recieving hose that goes to the throttle body which is on top of the engine, it normally has 2 medium size metal bands, 1 on each end, that tightened up or loosen. " in order to get to the throttle body, loosen the bands with a screwdriver, then remove the hose,then , you can clean the throttle body, with a throttle body spray cleaner, that you can purchase at a auto parts store.

Jun 24, 2011 | 2006 Pontiac Montana SV6

2 Answers

Help on finding out wind star coads PP0171-/-P074-/-P0401


first PO171 o2 bank 1 s1 lean PO174 o2 bank2 lean
PO401 cyl 1 misfire
when an engine misfires the oxygen sensor will read the oxygen from that cyl sensor doesnt read fuel so every misfire is a air pump to diagnose we have to fix misfire first check the coil wires and plugs for cyl 1 use spray bottle with water run engine hot at idle spray wires with water if enging runs rough shakes or stalls then replace the wires dont spray with to much water if the wires are real bad you may not be able to restart engine

try this first once fix misfire clear codes and drive it

plz comment vote reply if you need more help

Jan 17, 2011 | Ford Windstar Cars & Trucks

1 Answer

Dear Sir, I have a 1997 Jeep Cherokee Sport, 6 cylinder 4.0 liter. I recently tried cleaning my throttle body with carb cleaner while the vehicle was running. After spraying a half can of cleaner in the...


do a compression check on the engine, and replace the bad sensor, i take the throttle body off to clean it and some sensors are touchy about cleaner, i fear maybe something got on the egr valve pintle

May 26, 2010 | 1997 Jeep Cherokee

2 Answers

My 93 jeep grand cherokee runs rough while in idle


Injector cleaner that goes in the tank is ****. I would take the injectors off and have them cleaned by a profesional for about $30-$40. Or you can do it yourself but it is a task.

May 20, 2009 | 1993 Jeep Grand Cherokee

3 Answers

Jeep stalls



I had the same problem... frustrating.

I picked up a repair manual at the parts store. I took off the throttle body and cleaned it with throttle body cleaner spray. I changed the Idle Air Control Valve (idle speed motor) which was very clogged. While I had the throttle body off I also changed the Map Sensor and Throttle Position Sensor. The manual will walk you through the steps. I had never done anything like this before. If I can do you so can you.
My Jeep has never run better. Good Luck

Sep 26, 2008 | 1991 Jeep Comanche

Not finding what you are looking for?
2006 Dodge Durango Logo

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...