Question about 2005 Toyota Sienna LE

1 Answer

Slip indicator light and beep locking of the front wheel

While making a left turn at 10 mph the slip indicator light came on and a beep and locking my front left wheel for a couple of seconds

Posted by on

  • Frank
    Frank Mar 28, 2014

    make sure that all 4 tires have the right air pressure, my sienna also needed brake pads all around, air pressure was off by as much as 5 lbs. I also cleaned the abs sensor at the wheel point, put everything back togheter and it seems that it solved my problem. thank you for all the support

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 366 Answers

Sounds like it looses wheel sensor signal from the front left wheel, thinking its slipping. either a defective wheel sensor or loose connection somewhere on/in the wires between wheel sensor and control unit

Posted on Dec 06, 2014

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2926 Answers

SOURCE: RAVA 4 2006

If the vehicle did not have this condition before the brake pads were replaced, then one of the brake sensors either on the left or right side is not connected, not mounted correctly or has debris in the notches causing a false wheel spin condition. Double check the connections and mounting on the sensors. Use a code reader that is ABS compatible, and check for trouble codes associated with the brake system. The vehicle will not accelerate if the ABS system is sending a false wheel spin condition, that is how the vehicle is controlled during a spin, the accelerator is backed off automatically to allow the vehicle to straighten itself out.

Posted on Dec 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trac light came on on a left turn about 10 mph it flash and it beep and lock my front left wheel


Senor issues. Car thinks it is slipping. Pull the fuse for the TCS and see if that clears code and make your car derivable. If not, then try disconnecting the battery for 10-20 minutes. Otherwise, take it the dealer.

Mar 21, 2014 | 2005 Toyota Sienna

1 Answer

Steering wheel Lock When Driving


If you can still turn the wheel when this happens, the problem is usually with the power steering pump or the steering rack. First step would be to check the engine serpentine belt to make sure it is not slipping - if there is any sign of cracking or wear, replace it. If it seems loose, check the belt idler - it may be warn out and sticking.

Jul 02, 2017 | 2004 Chevrolet Malibu

1 Answer

Wen I began driving my 2000 ford focus zx3.and reaches speed of twenty MPH my abs indicator light comes on and my left front ABS begins to engage itself to attempt to stop my car. This situation continues...


If the abs light comes on before the front wheel starts acting crazy then it sounds like a different problem..Because when the abs light comes on it turns the system off..it shouldnt activate while the lights on..Check out that wheel and make sure there is no other problems

Sep 04, 2011 | 2000 Ford Focus

1 Answer

No indicators working found fuse box which fuse?


When you are talking about "indicators" we could assuming that your are refer about signal lights. This work with "flashers" devices.

For 1996 Audi A4 2.8L SFI 6cyl the Flasher is located in front seating area, driver side, under dash, behind dash lower panel, mounted above driver side of steering column.

About generic fuses, open the driver side door. Remove panel on left side of dash. Fuse box is behind panel:

Fuse # / Description / Amps
1 / Heated washer jets / 5
2 / Turn signals flasher unit / 10
3 / Headlight washer, illumination of glove compartment, engine compartment, climate control, automatic transmission, instrument cluster / 5
4 / License plate light / 5
5 / Instrument cluster, seat heating, test connection for cruise control, bulb monitor for auto-check control, Automatic transmission display, switch lighting, mirror switches and actuators, airbag warning light, outside temperature indicator, Climate control / 10
6 / Central locking system / 5
7 / Anti-lock brake system / 10
8 / Vacant
9 / Mirror heating / 10
10 / Vacant
11 / Cruise control (automatic transmission) / 5
12 / On board diagnostic system / 10
13 / Brake lights / 10
14 / Interior lights, reading lights, anti-theft alarm system, vanity mirror / 10
15 / Instrument cluster, power windows, climate control, automatic transmission / 10
16 / Anti-lock brake system, Anti-Slip-Regulation / 5
17 / Heated door locks / 10
18 / High beam right / 10
19 / High beam left / 10
20 / Low beam right / 15
21 / Low beam left / 15
22 / Tail and side marker right / 5
23 / Tail and side marker left / 5
24 / Wiper and washer system / 25
25 / Blower for heating, climate control / 30
26 / Rear window defogger, mirror heating / 30
27 / Rear window wiper / 15
28 / Fuel pump / 15
29 / Engine timing / 20
30 / Sun roof / 20
31 / Tail lights, cruise control, automatic transmission / 15
32 / Engine timing / 20
33 / Cigarette lighter / 15
34 / Engine timing / 15
35 / Trailer receptacle / 30
36 / Fog lights / 15
37 / Radio / 20
38 / Luggage compartment light, central locking system / 15
39 / Emergency flasher / 15
40 / Horn / 25
41 / Anti-lock brake system / 25
42 / Vacant
43 / Vacant
44 / Seat heating / 30

Hope this helps (remember to rate and comme this free answeer).



Jun 16, 2011 | 1996 Audi A4

2 Answers

How do you bleed the power steering system?


Lift the front of the car if you can. Makes it easier. turn the steering wheel 10 to 20 times. all the way left , then right, this will purge most of the air. the rest will come out in a couple of days. and this is if you haven't aireated the fluid already. (pink in color). If you have then it will take a couple of days to purge.

Feb 11, 2011 | 1998 Dodge Neon

2 Answers

Hi, I have a check front tire pressure warning on my 2009 saturn vue hybrid I filled up the tire it's not low at all, how do I get rid of the indicator warning? Thanks Amanda


The TPMS light (Tire Pressure Monitoring System) for that vehicle should function as follows.

If the light is on and steady, it means that the pressure in one or more of the tires is too low, and if the light is flashing, then it indicates that one or more of the tires are over-inflated.

1. Turn the ignition key to the "On" or "Run" position but do not start the vehicle. (If the vehicle has an electronic keyless ignition then place the ignition switch in the "ACCY" position)

2. Press the "Lock" and "Unlock" buttons at the same time on the vehicles remote key fob, and keep holding the two buttons down until you hear the horn beep, and usually this takes around five seconds. The horn beep will indicate that the learn cycle has begun.

3. Re-learn the TPMS system. Deflate or inflate air into the driver-side front tire for approximately 8 to 10 seconds and then listen for the horn to beep one time. (the horn might beep before the 8 to 10 second re-learn, or it could even take as long as 30 seconds after)

4. Repeat steps 2 and 3 for the remaining three tires. Also, the remaining three tires must be checked in the exact following order, the passenger-side front tire, the passenger-side rear tire and finally the driver-side rear tire. After the final TPMS sensor has re-learned then the horn will beep twice.

5. Listen for the horn to beep twice. When the horn does beep twice, it wikll be the indicator that the TPMS system has re-learned and reset.

6. Turn the ignition switch to the "Off" position, and then be certain that all four tires have the correct tire pressure as recommended on the drivers door, and the next time that the ignition is turned on, the tire pressure light should be reset.

Let me know if you require any further assistance.

Sep 23, 2010 | 2009 Saturn VUE

2 Answers

After flat tire, tire pressure warning will not go out even after making sure pressure is at 44psi. How do I reset dash?


44PSI?? is that what your car recommends...


1. check and make sure that your tires are inflated to the correct pressure

2. turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns off and then release the switch.

3. now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

Aug 14, 2009 | 2006 Hummer H3

1 Answer

Problem with my cruise control and ABS light on 03 Explorer


Anti-Lock Control —Vehicles Built After 03/2002 The 3-channel anti-lock brake system consists of the following components:
  • front wheel speed sensors
  • front wheel speed sensor rings
  • hydraulic control unit (HCU)
  • Anti-lock brake control module (ECU)
  • rear wheel speed sensor
  • rear wheel speed sensor rings
  • yellow anti-lock brake warning indicator
The 4-channel anti-lock brake system with traction control and stability assist system consists of the following components:
  • active brake booster with integral solenoid
  • brake booster release switch
  • front wheel speed sensors
  • front wheel speed sensor rings
  • hydraulic control unit (HCU)
  • stability assist module (ECU)
  • stability assist event indicator
  • lateral accelerometer
  • longitudinal accelerometer (4x4)
  • rear wheel speed sensors
  • rear wheel speed sensor rings
  • steering wheel position sensor
  • yaw rate sensor
  • yellow anti-lock brake warning indicator
  • brake pressure transducer
  • traction control switch
---------------------------------------------------------------------
I suspect the abs issue is causing the speed control not to work if it happened at the same time the cruise control stopped working. When the yellow ABS light comes on, it means the ABS is dactivated. You may have a faulty accelerometer which senses acceleration and yaw (side to side lean). I have not seen a bad one but you said it is sensitive to acceleration.
I would unplug it and see what happens. The connector should have a small tab to depress so you can pull the connector out.
Here is where it is:

Accelerometer Removal and Installation
  1. NOTE: The accelerometer is located under the center, rear passenger seat carpet. (I think you have to remove seat for access).
    Cut the carpeting along the perforations.
  1. Disconnect the electrical connector.
  1. Remove the nuts and remove the accelerometer.
cd31596.gif
Have dealer hook up tester and pull fault codes if you can't find an easy solution.
Some background info
  • A malfunction in the anti-lock brake system will cause the anti-lock brake control module to shut off or inhibit the system. However, normal power-assisted braking remains.
  • Malfunctions are indicated by the yellow ABS warning indicator in the instrument cluster.
  • The anti-lock brake system is self-monitoring. When the ignition switch is turned to the RUN position, the anti-lock brake control module will carry out a preliminary self-check on the anti-lock electrical system indicated by a three-second illumination of the yellow ABS warning indicator in the instrument cluster.
  • During vehicle operation, including normal and anti-lock braking, the anti-lock brake control module monitors all electrical anti-lock functions and some hydraulic operations.
  • Each time the vehicle is driven, as soon as vehicle speed reaches approximately 20 km/h (12mph), the anti-lock brake control module turns on the pump motor for approximately one-half second. At this time, a mechanical noise may be heard. This is a normal function of the self-check by the anti-lock brake control module.
  • Pedal pulsation coupled with noise while braking on loose gravel, bumps, wet or snowy roads is normal and indicates correct functioning of the anti-lock brake system.
  • Warning Lamp Indicator
    The anti-lock brake system (ABS) uses the yellow ABS warning indicator to alert the driver of a malfunctions in the ABS.
    The yellow ABS warning indicator will come on to warn the driver that the ABS has been turned off due to a symptom that exists in the ABS. Normal power assist braking remains but wheels can lock during a panic stop while the yellow ABS warning indicator is illuminated.

    -----------------------------------------
    Please report back, I am curious if that is what it is. Good luck

    Mar 03, 2009 | 2003 Ford Explorer

    1 Answer

    Differetial locks for 94 land cruiser


    91-97 Land Cruisers had a factory option for front and rear locking differentials. This is a seperate switch and is usually located to the left of US model Land Cruisers. The center dash button locks your transfer case differential changing your Land Cruiser from all wheel drive to four wheel drive depending if you have ABS or not this button either says ECT or Center Dif Lock. If you do not have the Front/Rear locking differential option then your Land Cruiser has open Front and Rear. Hope this answers your question.

    Jan 19, 2009 | 1994 Toyota Land Cruiser

    Not finding what you are looking for?
    2005 Toyota Sienna LE Logo

    107 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Toyota Experts

    yadayada
    yadayada

    Level 3 Expert

    76109 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8270 Answers

    Are you a Toyota Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...