Question about 2000 Chevrolet Blazer

1 Answer

Starts 2 seconds then stalls.Battery has been out for a while

Battery has been out for a while waiting for transmission fix.Checked all elec.connections, checked fuel pressure,OK,checked vacuum hoses, found one bad and replaced it,used starting fluid and it didn't make any difference.Replaced TPS

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 266 Answers

Probably accelerator sensor. Get the broken codes from Pep Boys enquiry. Usually free

Posted on Mar 20, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 206 Answers

SOURCE: '90 3.1 lumina euro idles ok but tries to stall when accelerated.

If the cat is red then it is probably plugged if the motor can't exhale it wont run at high rpm

Posted on Apr 12, 2009

  • 432 Answers

SOURCE: tahoe starts and then stalls

If you have low pressure and the pump runs for an extremly long time then that would be my guess as well.Relay only turns it on or off.

Posted on Jan 24, 2010

  • 97 Answers

SOURCE: car starts and cuts out after 2 to 3 seconds. fuel

When the ignition switch is turned on the pcm turns on the fuel pump by energizing the fuel pump relay. The PCM keeps the fuel pump on as long as the engine is cranking over or running.It does this by recieving pulses from the ignition module. If there are no referance pulses the PCM will turn the fuel pump relay off in 2 seconds with the ingnition on.

Most models also include a secondary control path through the oil presure switch witch will turn the fuel pump on after it detects oil presure.cranking time will be longer if the fuel pump doesn't recieve current until oil presure switch contact is closed.

Posted on Jan 28, 2010

  • 1 Answer

SOURCE: 1989 Z24, 2.8v6 intermittent stalling while

89 chev cavalier 4 cyl auto 2.0 when going down road 50 mph slam on breaks car stalls start car put it in gear it stalls what is wrong it seems to do it when its hot only why

Posted on Apr 11, 2011

  • 2 Answers

SOURCE: 1997 Chevy Cavalier Starts and then dies after a few seconds.

when u replaced the computer it tripped the anti-theft system because the code stored in the new computer no longer matched the ignition. when the anti theft system is triggered on a cavalier it allows the car to start

Posted on Mar 12, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 chrysler new yorker, car starts for 2 to 3 seconds and stalls, headlights flash off and on and turning signals flash, how do i fix it?


I owned a LHS and 94 New yorker both cars did this, have the door locks checked for a loose wire for the alarm system, something is telling the security system there is a breach, you must lock the doors, shut the door and then open the car door by unlocking it with the key or it will continue to do this. Mine had loose wires and the door lock would not sense the key so I used the passenger door in the same way I described above. IT will NOT Start and run if this is an issue until the alarm is reset by doing as I described. Good luck BTW both cars suffered from failing transmissions, very weak trans in these cars.

Jul 30, 2014 | 1995 Chrysler New Yorker

1 Answer

Motor shuts down


stalls,
lots of causes of stalls, i have a list of over 50. could add to it easy.
Portuguese = Bobina (ignition coil)

Jeeps have a RELAY called ASD, and that is its job to SHUT Down.
here is a list.
1: check all fuses first on both fuse boxes
2: battery charged to 12.6v, rested. (good spark plugs not 18years old
3: crank and see ASD close, if yes, then see if it drops out with 5 seconds cranking, it might drop out in 2 seconds.
this is the 2 second rule.
when you see it drop out , that means the ECU sees ERRORS.
bad spark , bad CMP, bad CKP or Immobilizer errors. SKIM.
4: we then connect any OBD2 scan tool to the OBD2 DLC 16pin
connector , and crank again for 5 seconds.
the scan tool will (may) show DTC errors, these errors tell you
WHY the ASD was dumped. (stalled)

ill stop here, as we need above facts to proceed.
http://www.fixkick.com/nostart-flow/ASD.html

Mar 14, 2014 | 1996 Jeep Grand Cherokee

1 Answer

Car stalle Security light on


Try your spare key.It could be that the primary key you have been using needs to be reprogrammed,which can be done by contacting a dealer.Turn the key to the "On" position in order to reset the pass lock system.Wait for fifteen minutes with the key in the "On" position.If the security light disappears, turn the key to the "Accessories" position and wait for a couple of seconds.Turn the key to the "Off" position and take it out from the lock cylinder. Wait a couple of seconds and turn the car on.--------------------------------------------------------------------------------------
Autel MaxiDAS DS708

Jan 08, 2013 | 2001 Pontiac Grand Am SE

1 Answer

2003 Impala starts, runs 2 seconds, stalls


in theft mode.. the fix..... try to start when eng. dies leave key on for 10 min turn off then on but dont try to start do thes 3 times on the 3rd time veh should start and run.

Jan 02, 2013 | 2003 Chevrolet Impala

1 Answer

1994 Grand Jeep Cherokee Limited Edition 8 Cylinder Stalls each time it Starts? Help


replace your idle air control valve their about 25.00 to 30.00 dollars easy fix its located on backside of your throttle body 2 screws

Dec 01, 2012 | 1994 Jeep Grand Cherokee

1 Answer

1993 Ford E-350 Starts and runs for about 45 seconds then stalls and wont restart for hours. Put computer on it and get code 542 fuel pump secondary. I have new fuel pump and have checked and re attatched...


regulator most likely. Need to check fuel pressure both when running and after a stall. My guess is 20 lbs when it starts, 0 after it stalls. Replace that fuel filter also.

Apr 25, 2009 | 1993 Ford Club Extended

1 Answer

Car starts, drive a mile, stalls.


try haviing your alternator checked advance auto parts can check it while its on the car and the can check the battery too. if thats not it it may stall due to a loose battery connection or a loose ground strap. if it stalls and everything turns of (electrical) it may be a connection or ground strap.

Aug 14, 2008 | 2002 Dodge Intrepid

1 Answer

Stalls when put into gear


Its possible it could be other things causing the problem, but seeing as you've checked most of the likely causes, it is most likely your Torque-Converter. The lockup clutch in your Stator-Fan located inside the Torque-Converter could be siezed, causing the car to stall.

May 16, 2008 | 1993 Ford Aerostar Extended

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...