Question about 2001 Jeep Cherokee

1 Answer

Turn signal and Hazzards issue

When using the turn signals or the hazard lights after a few minutes of being at a long light and blinking the light stops blinking and it just steady. It wont reset back to normal until I turn off the car. The lights outside work and they also stop blinking but stay on just steady. Any ideas?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 218 Answers

Turn signal flasher. Replace with a heavy duty one.

Posted on Mar 20, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: Left turn signal stops flashing when brake pedal is depressed.

there is a ground problem, most likely in the tail unit itself, but a ground problem is hard to find and easy to fix. reground the system, the turning unit, and the problem should stop. About the hazards, I don't know...... some times in older cars, that is the way it works. because the brake and hazard element in the bulb is the same and the old cars used a break in the power, but the new cars use a break in the ground. any way, chase the ground down first, it is usually the cause.

Posted on Feb 12, 2009

  • 6982 Answers

SOURCE: turn signals blinking fast and stop when brakes applied

likely not, but change /check anyhow....If problem persists, likely you will need to change the module that controls directionals (usually under dash to the right of steering column)

Posted on Apr 27, 2009

  • 393 Answers

SOURCE: Jeep Liberty Left Rear Turn Signal Not Working

sounds like the bulb you have is the wrong resistance the new noen bulbs will do this

Posted on Nov 16, 2008

catbob007
  • 70 Answers

SOURCE: !998 jeep Cherokee-no reverse lights...left turn signal

Replace turn signal switch on colum probubly emergrncy and turn combo check your back up switch on man transmission. if auto transmission check selector switch on linkage.

Posted on Jul 30, 2009

  • 436 Answers

SOURCE: 2001 jeep Tj pdc diagram trying to locate fuse for

sounds like it is either flasher or switch assembly.

Posted on Oct 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Toyota Prius hazard lights blinking constantly


i have a 2010 Prius that we bought new. It has had no problems, but I can tell you from my study of the Prius that pretty much nothing is simple. The easiest way to reset stuff is to disconnect the a start battery connection. You can look on the net how to start a Prius with jumper cables to the engine compartment, and disconnect the start battery there. If you are not comfortable with that, the start battery is in the rear near the spare tire. Disconnect the negative cable only, wait 15 minutes and reconnect. You may have to reprogram your radio push buttons, but so what. If this doesn't work, take it to a shop (maybe toyota dealership) that can read and interpret the trouble codes for a 2010 Prius. Enjoy the car, we do.

Dec 03, 2017 | Toyota Cars & Trucks

1 Answer

Alpha Romeo 156 My Left hand indicator light stays on continually, does not flash. and when I turn the hazard light switch on both indicators continually glow.


Generally speaking, symptoms of a bad or failing turn signal bulb are usually the culprit...in your case, either it's the front left or rear bulb. Varies for different vehicle makes...common signs include:
  1. turn signal light staying on solid
  2. or blinking very fast
  3. or either sides of the bulbs stop blinking altogether.
To test this, make sure you reconnect everything you disconnected.
Turn the left signal light on; go to the front of the vehicle, is the turn signal bulb illuminated? If it lights up, even though it is not blinking obviously the bulb is okay. If it doesn't, replace it- problem solved. You'll do the same procedure for the rear turn signal Is that lit up? If not replace the bulb and the problem is solved.
Another common failure is when the turn signal blinks really fast, same procedure as mentioned above.
If both bulbs for the left side and right side illuminate but don't blink, the problem is in the steering column turn signal switch.
If the left or right side blinkers don't work properly at all...then check the integrated hazard warning/turn signal flasher relay- that may be defective; again, that's usually the case if both sides of the signal light don't work.
If you are blowing any fuses related to the flasher system, you have an electrical overload in the turn signal circuitry.

Feb 12, 2017 | Cars & Trucks

1 Answer

My left turn signal will not stop blinking while car is running or completely off...please help!!


Hi BJ:
Interesting...........

- Hazard lights work when ignition is turned OFF.
- Signal lights Don't work when ignition is turned off.
- Is it possible that the Right signal bulb is burned out?
- I'd be checking the functions of all of the bulbs.
How did this problem start?
Please reply as a COMMENT to this post.
Cheers.

Jan 06, 2016 | 2003 Saturn Lw 4dr Wagon

1 Answer

Turn signal hazard lights work but not running lights


The parking lights should be on a different circuit from turn signals - hazard lights. The bulbs usually have two filaments, one for each circuit.
On most models there is a tail light fuse and relay that handles front and rear parking lights.

Jun 28, 2013 | Toyota Tacoma Cars & Trucks

1 Answer

Turning signals and Horn


Do the hazard flashers work, and have you checked the flasher unit ? ?

Jun 22, 2013 | 1998 Plymouth Breeze

1 Answer

Hazard stop flashing after 1 minute and stays on


Yes, I replaced the relay box and it worked.

Feb 17, 2012 | Cadillac CTS Cars & Trucks

2 Answers

Turn signal doesn't come on until I hit my hazard light on & off


it could be duel filament bulb that is blown and shorting inside the bulb to the other circuit, you may need to remove all indicator and hazard bulbs and check. I would also try a new flasher can

Apr 17, 2010 | 2003 Chevrolet Impala

1 Answer

I have no signals and when brakes lights are on, lose brake light to either side turn signal is set on


Hi!!

If you activate the turn signal switch and you step on the brake pedal, the turn switch (on the steering column) deactivates the brake light to make the signal light more visible. The bulb for the stop and turn lights is the same.

Turn hazard lights ON. If they don't blink, replace turn/hazard flasher, If one or more lights don't come on, replace bulb.

Check fuse and circuit wiring for broken or loose connections. If all looks fine, check following:

If front turn lights work fine, check brake/turn bulbs.

If turn lights come on but don't blink, replace turn signal/hazard flasher.

If front and back turn lights don't come on, replace switch on column.

Let me know how it worked out, Good Luck

Mar 24, 2010 | 1991 Plymouth Acclaim

1 Answer

Turn signals, Hazard lights


I would replace the bar switch assembly.

May 18, 2017 | 1998 Jeep Wrangler

2 Answers

Hazard Flashers, turn signals and brake lights quit working


please check your flasher relay. it is normally a three prong relay box.


tnx 4 using fixya,

drcool

Sep 02, 2008 | 1996 Lincoln Town Car

Not finding what you are looking for?
2001 Jeep Cherokee Logo

194 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...