Question about Toyota Pickup
I have a 1987 22r Toyota pickup that will run fine until 40-45 then won,t go faster
Check for a failed cat converter if you have one as it may be blocking the exhaust system. check carby for partially blocked main jet
Posted on Mar 21, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Rough idle until warm 22r
if it is a carburated engine it is probably the a.a.p. diaphragm in the carb. if you remove the air cleaner and look on the side of the carb that is towards the valve cover near the front yow will see a vacuum hose going to a cover that is fastened with 3 screws. if you pull the vacuum line off you will see that there is probably fuel being sucked into the line due to the leaking diaphragm. the vacuum source is temp controlled and cuts off when warm. but when cold sucks fuel directly into the intake. remove the 3 screws to replace the diaphragm, being carefull of the spring. good luck!
Posted on Dec 18, 2008
There ar two thermo vacuum switches on the intake manifold,one in the center top by the EGR pipe right next to the valve cover,and one center bottom on the outside right below the carburator,it may be that one of them is not fully opening/closing when the motor is cold.I'm not sure on this as I've never had this problem with my 22R's,hopefully this will point you in the right direction,if you want comment back and I'll research this further(it's 5 in the morn and I cant access my 22r manual)
Posted on May 01, 2009
There is an adjustment for the clutch pedal under the dash where the push rod goes thru the firewall. There is only aprx. 1/2" of adjustment so be careful when making an adjustment, if your clutch is slipping then you need to shorten the throw of the push rod.
Posted on May 07, 2009
First you have to bleed air from clutch fluid.
if it is not ok, Remove clutch agan & check pressure plate finger blance or damage.
Posted on Nov 18, 2009
Tips for a great answer:
Feb 13, 2013 | 1994 Toyota Pickup
Sep 10, 2011 | 1988 Toyota Pickup
Sep 01, 2011 | 1989 Toyota Pickup SR5
Apr 10, 2010 | 1986 Toyota Pickup 4WD
Apr 09, 2010 | 1986 Toyota Pickup 4WD
Mar 20, 2010 | Toyota Pickup Cars & Trucks
Jan 26, 2009 | 1985 Toyota Pickup
Aug 01, 2008 | 1994 Toyota Pickup
105 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: