Question about Toyota Land Cruiser

1 Answer

I have a 61 series cruiser, which is 24 volt. The motor won't shut off after the ignition is turned off, we thought it may of been the ignition switch so we have replaced this only to have not fixed o

The clutch and brake also went as we pulled into the driveway

Posted by on

  • 2 more comments 
  • Leanne Gray
    Leanne Gray Mar 20, 2014

    Thank you very much for your help.

  • Leanne Gray
    Leanne Gray Mar 20, 2014

    I feel a little bit silly as I did not notice that the alternator fan belt had come off :(

  • Bill Boyd Mar 20, 2014

    that belt drives the power steering pump and also a vacuum pump on the alternator that produces vacuum for the brakes --may explain why the brakes failed-- The clutch may be just cocidence and needs a bleed of the air

  • Leanne Gray
    Leanne Gray Mar 20, 2014

    Thank you for your time Bill very much appreciated

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Toyota Master
  • 40,764 Answers

Check the stop solenoid on the fuel pump is operational. If it is a turbo diesel check for a delayed shut down to allow the turbo to cool off.

Posted on Mar 20, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2002 pt . I have no problem with it, started it and put in gear, went to pull out and it shut off, now it won,t start back up, put new battery in, new switch, still nothing,


Possible starter failure if the engine doesn't crank. You can try tapping on the starter motor using a blunt object while turning the key to see if it starts. If it starts, suspect a defective starter motor. If it is a manual transmission, you can push start it in gear

Nov 21, 2015 | 2002 Chrysler PT Cruiser

2 Answers

I just replaced a fuel pump in a 2008 pt cruiser. Getting good power to the pump. Asd relay is good. Wiring is good. Still won't pump fuel. Thoughts?


Check to see if there is a fuse for the fuel pump, then check if there is a impact shut off switch like the fords, and sometimes the fuel pump will run till after the ignition is cranked over....

Nov 08, 2014 | 2008 Chrysler Pt Cruiser

3 Answers

1995 Isuzu Rodeo won't start all of a sudden.


Check connection battery,could be starter.

Jun 05, 2013 | Cars & Trucks

1 Answer

Flasher relay on HJ60 24 volt keeps burning


Check for a grounded wire somewhere in that circuit. This happens most often when something was added like an AMP or Alarm and power is tapped from that circuit causing it to have too much current pulled through it.

Nov 20, 2011 | 1986 Toyota Land Cruiser

1 Answer

1998 Ford Explorer, 4.0 SOHC No Spark. Engine will crank but it won't start. Replaced the Crankshaft Sensor, Coil Pack, & Spark Plugs. Still no spark. What next?


You are at thhe right trail what controls spark is coil pack crank sensor sparkplugs and plug wire but the most important is power . I mean 12 volt connections and ground This includes checking fuses you need a simple volt meter doesnt have to expensive or fancy just to pick up 12 volts let start with fuses in the engine juction box (there not mark to what it belongs to) make sure none are open. especially fuse 19 and 24 , next go to the crank sensor make sure the tabs are snuggly on now to the coil pack there is a red and light green wire this comes from ignition and feeds 12 volts at the coil pack measure that voltage is it 12 volts if not correct it this is from ignition switch ( you can make a tool that feed 12 volt with a wire and a fuse in series and attatch it to battery and the primary wire this is known as hot wire) next go to the ECM wiggle the wires see if that get a connection going if not go back to the ICM here are the wire you are to measure the tan light green, this is from ECM and it is pulsed it measure 5vlts to 0 volts switched then measure the tan orange the same thing 5 volts to zero,then tan white again 5vlts to zero. any one of these 5 to zero fails you fix is the ecm

Aug 21, 2011 | 1998 Ford Explorer

1 Answer

No charge?


The batteries on the diesel 'cruisers are strange in that under normal running the two are wired in parallel. When you turn the key to the "start" position, the battery relay wires them in series to provide 24 volts to the starter. Therefore, if either one of the batteries dies, you won't be able to start the truck as both batteries are required in order to provide 24 volts.

The wiring diagrams are available in Toyota publication RM315E. A search of the ih8mud forums should provide you with a download link.

Mar 06, 2010 | 1994 Toyota Land Cruiser

1 Answer

Looking to put remote start and bypass module in 2007 saturn vue need wiring diagram


12 VOLT CONSTANT ORANGE (+) IGNITION SWITCH HARNESS STARTER YELLOW(+) IGNITION SWITCH HARNESS STARTER 2 N/A IGNITION 1 PINK(+) IGNITION SWITCH HARNESS IGNITION 2 N/A IGNITION 3 N/A ACCESSORY/HEATER BLOWER 1 ORANGE (+) IGNITION SWITCH HARNESS ACCESSORY/HEATER BLOWER 2 N/A KEYSENSE LIGHT GREEN (-) See NOTE *1 IGNITION SWITCH HARNESS PARKING LIGHTS ( - ) N/A PARKING LIGHTS ( + ) BROWN (+) @ BCM, PIN B10, GRAY 24-PIN PLUG, See NOTE *2 POWER LOCK RED/BLACK (TYPE A) @ BCM, PIN A8, 16-PIN GRAY PLUG, See NOTE *2 POWER UNLOCK ORANGE/BLACK (TYPE A) @ BCM, PIN A7, 16-PIN GRAY PLUG, See NOTE *2 LOCK MOTOR WIRE GRAY (+) IN DRIVERS DOOR HARNESS DOOR TRIGGER See NOTE *3 @ BCM, PINK 24-PIN PLUG, See NOTE *2 8957_VUE_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf DOMELIGHT SUPERVISION WHITE (-) @ BCM, PINK 24-PIN PLUG, PIN A1, See NOTE *2 TRUNK RELEASE N/A SLIDING POWER DOOR N/A HORN BLACK (-) @ BCM, PIN B2, PINK 24-PIN PLUG, See NOTE *2 TACH ANY WIRE NOT PINK or RED @ IGNITION COIL WAIT TO START LIGHT N/A BRAKE LIGHT BLUE (+) @ SWITCH ABOVE BRAKE PEDAL FACTORY ALARM DISARM DISARMS with FACTORY REMOTE ONLY ANTI-THEFT YELLOW (+), ORANGE/BLACK (-) and RED/WHITE (Not used) GM's PASSLOCK 2 System, these wires exit the Ignition Switch Tumbler together and are in the Main Ignition Switch Harness in the Column.

Feb 27, 2010 | 2007 Saturn VUE FWD 4

2 Answers

When i turn the key over it clicks but it wont start


I presume you have a good battery. The next thing I would check is the starter motor, then the ignition switch. If it doesn't start at all it may be the auto relay switch.

Feb 03, 2010 | 2001 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...