Question about 1999 Chevrolet K1500

1 Answer

Tuuck is a 200 chevy 1500 and it shifts from first to second fine but when it goes to third it is like it is in neutral and will not go

I can reve the motor and it is like I am in neutral

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Welcome Back:

    Visited the website for 2 consecutive days.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 7 Answers

Sounds like tranny is going they always start that way just before they go.usually you will lose reverse also

Posted on Mar 20, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 109 Answers

SOURCE: 1978 chevy k20 4x4 truck

try checking your vacume lines..

Posted on Dec 02, 2008

  • 120 Answers

SOURCE: Chevy transmission won't shift into 3rd

front clutches bad needs to be rebuilt

Posted on Feb 13, 2009

localwonder
  • 6784 Answers

SOURCE: Hi, I have a 1998 Chevy 3/4 ton 4x4, automatic

Yes, you are correct. i would change the filter as well. check the torque converter for stress.

Posted on Feb 28, 2009

polarcycle
  • 1392 Answers

SOURCE: 4L60E won't shift to 3rd on 1993 Chevy Blazer 1500

Sounds like you have a bad shift solenoid. Not sure if the Chevys are a solenoid pack, or seperate, but it will need to be replaced.

Posted on Jun 02, 2009

  • 12761 Answers

SOURCE: Chevy Corsica 1995 gearshifting speed problem

ur computer probably wont show anything ur tranny problem can be anything fron needing a filter changed to vacuum problem to torque converter check the fluid for level if low fill up- before filling look and smell fluid it should be reddish in color not brownish [fluid burnt]if it smells burnt- need trans service can be just a filter and flush ,bad sensor-actuator or rebuild

Posted on Feb 13, 2010

Testimonial: "Thank you for your answer. My friend though almost the same about some of what you wrote and I will check it out. Thanks! :)"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi I have just compltely rebuilt a ts400 &it will not idle I have done vacume test pressre test chanhged fuel &pipes andtried 3 carbs new it starts ok a reves ok but not idle any clue thanks max


You are going to adjust your neutral switch in neutral by putting a smal nail inside your neutral switch that is the way to adjust it and one you retided the scruses thake out the nail

Dec 15, 2017 | Cars & Trucks

1 Answer

When driving truck bogs down when giving it gas.bring when in neutral and rev up the motor to 3grand is snappy like it should be. Wondering if its my tranny


if it reves up to 3 grand when you start it or while in park most likely it is the TPS "throutial Posisition Seneior".

Dec 20, 2010 | 2003 Chevrolet Silverado 1500

1 Answer

4.7l v8 reving from 500 rpm to 1500 rpm in neutral or park. What could be causing this. Had mechanic clean out air intake box, but did not fix


check idle air control motor for carbon. it may be clogging system. if it sticks it will not let vehicle idle right.

Jun 10, 2010 | 2005 Jeep Grand Cherokee

1 Answer

I was driving in O.D.,motor reved like it was in neutral,then went back into gear.Came to a red light.When I took off,I only had 2nd & 3rd gear.Parked 4 hours,took for a ride,everything fine.Fluid is...


could be something as simple as needing fluid and filter changed. next time you check the fluid give it a sniff, if it is smelling burnt then its time to change

Feb 23, 2010 | 1994 Pontiac Grand Prix

1 Answer

1993 Chrysler Le Baron 3.0


sounds like it is going into limp mode,

Dec 03, 2009 | 1993 Chrysler Lebaron

3 Answers

Does a 2002 Ford Explorer Sport have a "governor?" Just wondering because when the vehicle is in neutral or park the RPM will not go above 3000 but it will go higher if in drive.


This is called a rev. limiter. Most vehicles are equipped with these to prohibit over-revving in neutral and to protect the engine from damage. Its not a governor.

Aug 12, 2009 | 2002 Ford Explorer

1 Answer

01 VW Jetta Vibration Problem


Check the motor mounts. They might be worn or loose which can cause vibration felt when the engine is reved up or running at higher rpms than at idle.

Jan 13, 2009 | 2004 Volkswagen Jetta

1 Answer

I have a 300 tdi discovery 1996 with automatic gearbox. As I drive on the flat the car runs fine. when i try to go up any hill or really put my foot down the engine seems to choke itself up and warning...


check your motor mounts, do this by opening the hood and pushing the car back and letting it rock, if the motor moves more than an inch either way, your motor mounts are bad.

Nov 25, 2008 | Land Rover Discovery Cars & Trucks

Not finding what you are looking for?
1999 Chevrolet K1500 Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...