Question about 2006 Kia Sorento

1 Answer

Crank sensor kia sorento

Hello, I have an 06 kia sorento, I replace the cam sensor, crank sensor and timing belt. I put it back together, but now it cranks and wont start. Can someone help?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 201 Answers

Double check timing because they are easy to time 180 degrees gff if engine not at top dead center

Posted on Mar 20, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
krolik7
  • 1 Answer

SOURCE: 2004 Kia Optima no start after timing belt, crank, cam sensor replacement

did you use aftermarket crank sensor? if so that might be your problem. dealer has several different ones, by providing vin number, but there is only one after market for all optimas 01-05. try to connect thick pink wire and thick orange wire together on the ignition failure sensor. you might have the same problem as me. good luck.

Posted on Jan 15, 2010

robshow
  • 367 Answers

SOURCE: 2004 kia optima

Try the ignition switch,

For the Crank sensor there is a small metal disc that mounts behind the sensor if that is cracked or dammaged or installed backwards you will get same results as if it wasn't Make sure the timing marks line up on your timing belt. www.kiatechinfo.com

Posted on Jan 19, 2009

  • 3 Answers

SOURCE: 2003 Kia sorento starts and then won't start

There is a black rubber button reset switch right next to the air box, press it sounds like the problem i had its a fuel pump reset (just in case of a wreck it kills the car) but there is a tiny ball in there and if it is rattled a little too much it will fall and you need to press the black looking button to reset it....took me like 4 months to figure it out

Posted on Apr 19, 2009

tommyboinow
  • 324 Answers

SOURCE: 2004 KIA SORENTO LIFTER TAPPING

it is common for the oil pump to go bad after changing the timing belt.

the pump is located in the oil pan, and nothing drives it, it works as a sucking action....

Posted on Nov 26, 2008

  • 34 Answers

SOURCE: 2004 KIA SORENTO, i HAVE

i paid $1200 to do timing belt & waterpump .i could of done work myself but warranty requires licensed shop to do it to comply. if funds are low go to a shop and apply for credit. firestone,midas ect.they are rip offs but if approved a payment plan helps the pain

Posted on May 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 03 kia sorento that i just changed the timing belt and water pump on. It drove fine for about 10 mins but then stalled. After 15 mins it starts, runs for 10 mins, rough again and stalls out.


run fault codes
check for wiring on crank shaft position sensor or cam position sensor/s
it will be something that was affected by the belt replacement procedure

Feb 14, 2017 | Kia Cars & Trucks

1 Answer

How to fix 2012 kia sorento camshaft sensor


replaced crank and cam sensor [Archive] - Sorento Nation - KIA ...

www.sorentonation.com/forum/archive/index.php/t-913.html

20 posts - ‎6 authors
replaced crank and cam sensors put back together cranked up very rough idle some tapping any ... 12-17-2012, 12:24 AM ... It's a 2006 3.5 Kia Sorrento. ... I found theproblem the SUV has a aftermarket alarm and remote start system I tripped ...

Kia Rio Crankshaft Position Sensor Replacement - YouTube

? 4:44
https://www.youtube.com/watch?v=hihQxMWuSFY
Mar 21, 2014 - Uploaded by Jason Roush
While looking for how to replace a Kia Rio crankshaft positionsensor, ... is on and i have a P0340 code, think this is theproblem? kia rio 2002.

Kia Sorrento/Sedona: 3.5 Litre Engine/Timing Belt/Crank ...

? 20:23
https://www.youtube.com/watch?v=CjaD_zYPrUA
Mar 29, 2014 - Uploaded by JamieJones TheCarMan
Repair and/or Replacement tips for timing belt, crank sensor,cam sensor, water pump and drivebelt ...

Crankshaft position sensor - 2003 Kia Sorento - RepairPal

repairpal.com > Questions > Kia > Sorento > 2003 Kia Sorento


Jan 20, 2016 | 2012 Kia Sorento Base 4dr SUV 2.4L 4-cyl....

2 Answers

Hi, Had loss of power in Kia Sorento 2006. Changed injectors but it wouldn't start. Checked injectors and put them back but it still won't start. Any ideas? Thanka in advance.


run the fault codes . check for cam/crank position sensor problem. check that the cam shaft is turning (broken timing belt/chain). check immobiliser is operating correctly

Feb 05, 2015 | 2006 Kia Sorento

1 Answer

I STILL have my problem...I have a 2006 kia sorento lx 4x4 with a mitsubishi 3.5 that I just replaced timing belt, water pump, idler pulley, tension pulley, tensioner, I also just replaced crank posit


because you have replace engines but I imagine that you have used the crank and cam position sensors on the 3.5 but connected up to the kia ECM there is a possibility that the ecm is not reading those position sensors and not providing timing for the ECM . It will be reading as broken timing belt. I would suggest a scan of the fault codes to determine if there any sensors not reading correctly. You may have to find a speed shop that has CPU programming capabilities to reprogram the ECM/CPU to the different sensors.

Nov 18, 2014 | 2006 Kia Sorento 3.5

1 Answer

My wife has a 06 sorento 3.5. The crankshaft bolt broke and I got it out replaced the harmonic balancer, the crank sprocket and the bolt. When I was putting on the new timing belt I rotated the motor by...


I would check the Crankshaft Position Sensor. If any of the blades on the crankshaft sproket were bent the will nick the sensor and throw everything out of wack. Its worth your time to buy a pair of camshaft lock tools. They hold the cams in place while you remove the belt. Also search youtube for sorento 3.5 timing belt. There is a mechanic that reallly knows his stuff and can show you a couple of tricks to make the job a lot easier. Good Luck. Oh and, good job on the crank bolt! Not an easy fix my friend.

Mar 13, 2017 | 2006 Kia Sorento 3.5

1 Answer

6cyl LX location of the crankshaft sensor


The crankshaft position sensor is bolted to the block about a quarter inch away from your crank. Not the crank pulley but the actual crank. This means removing the cover for the timing belt and the timing belt itself along with many other parts. I have a 06 kia optima and I had to replace my crankshaft sensor, believe me you do not want to try unless you are mechanically inclined. If you remove the timing belt cover and look right next to the crank there is a little plastic piece bolted on with 2 bolts. That would be your crank sensor. Don't take timing belt off until you have all components lined up oil pump, crank, cams, etc. Also mark your belt at the marks when they are lined up so when you put it back on you know its right. If you do decide to replace it and you need some advice let me know and I would be glad to help. Hope that info helps you out.

Dec 13, 2010 | 2005 Kia Optima

1 Answer

Does v6 sorento have timing belt


Your 06 Kia, with 3.5L engine V-6, has a timing belt, Kia recommends replacing every 60,000 miles, this is an interference engine, which piston to valve damage will occur due to timing belt failure, hope this was very helpful.

Aug 26, 2010 | 2006 Kia Sorento

3 Answers

2003 Kia sorento starts and then won't start


change your fuel filter. it seems youve done all the major actions but havent tried the common fix.

May 27, 2009 | 2003 Kia Sorento

2 Answers

LIFTER IS TAPPING AFTER WARMING UP AND OIL LIGHT IS COMING ON


sounds like your oil pump wnet bad, this is common when changing the timing belt.

Nov 26, 2008 | 2004 Kia Sorento

Not finding what you are looking for?
2006 Kia Sorento Logo

501 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...