Question about Nissan Pickup
I do not think my titan has a plug under the dash. It does not have a factory tow package. If it does I can not find it.
You are right the plug is not under the dash had the same problem.
I did not get a factory tow package. But the truck was wired, when I had the hitch added had to buy the tow relays from Nissan to get the lights to work for the trail.
Now for the electric break I spend a lot of time look for the plug under the dash it is not there. Found it under side panel on drivers side by parking break. It was not put where the manual show. It has been a couple of years so I don't remember the number of the plug it was female 3/4 X 1/2. I use a test lamp to find the lead from the break by pushing on break till I found the lead then buzzed the break lead to 7 way plug at hitch. If I remember right it was blue.
You can go online to get a wiring diagram search for(7 way trailer plug wiring diagram)
Hope this helps.
Posted on Mar 15, 2015
I don\'t think it has wiring provided in the factory for the tow package either. Looking at the schematics, they appear to be different with no provision for connections. The aftermarket have a wide variety of tow packages available which are simple enough to install if you ability.
Threr is one which you have to drill a large hole in the rear bumper to fit the receiving end of the connector. This is designed so that a wide selection of adaptors can be plugged into it. The adaptors are designed to fit the fixture in the bumper and the other end is shaped to plug into what ever connector you are towing. You will find this knid of fixture on nearly any factory package.. (NO WIRES DANGLING UNDER THE VEHICLE.) additionally, when not in use, there is a spring loaded cover which closes over the fixture to keep contaminants from entering Although I am a Nissan Master techniton, I chose a long wheel base 1 ton long wheel base cab and chassis Toyota with a 3.0 V-6 which I opened the back of the cab and installed a sleeper. Then built a flatbed with removable sides. I use this to pull my Nissan 300Z race Car. I have one of these fixtures on my truck because I don\'t always use the same trailer and the connectors to the trailer for the lights and electric brakes are different. The kits come with a controler for the electric brakes which you can mount where ever you wish and the controller has adjustments to control sensitivity of the trailer brakes so you can adjust the trailer to stop with the truck about the same time instead of wearing out your brakes from the extra load. With my Toyota loades with an extra engine, transmission and diff. Air compressor. Generator. Tool box, pop up tent, oils and other fluids and other misc Items. Between the trailer, the truck and it\'s load it grosses out at 11,800 lbs.When we go to Texas world speed way, we take 45 south where where there are very few cops. We cruise at 80-85 mph in the truck without a problem If the trailer brakes don\'t work, it would take me a significant time to stop because my truck is rated for 9,500 lbs.I run the living piss out of it and it has given me no problems at all/Hmm How did I get on the subject of my Toyota flatbed? OH, it\'s because I use the trailer brake setup I described which has been flawless. There are places that specialize in selling truck accesories only. From camper top and wheels to a variety of tow packages.Check them out. Good luck..
Posted on Jun 29, 2014
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
it is pretty easy to find,take off the fuse box cover and it's to the right of the steering colum,it's just a plug hope this helps
Posted on Mar 12, 2009
You'll have to follow the BROWN wire from the factory connector(with the running lights on of course) to the trailer connector and make sure you are getting power all the way to the two lamp fixtures. If so you've probably got two burned out 1157 bulbs or an inline fuse in the factory harness/ trailer harness.Good Luck, Dana
Posted on Aug 25, 2009
if you go to the parts store they make them ready to plug in you will have to just unplug the tail lights and plug the wire harness inplace of it then itll plug back into the original spot.
Posted on Apr 23, 2010
Tips for a great answer:
Mar 14, 2015 | 2004 Nissan Titan
Mar 19, 2014 | Nissan Pickup Cars & Trucks
Jun 26, 2017 | 2004 Dodge Ram 2500
Sep 05, 2011 | 2006 Nissan Titan
Jun 05, 2010 | 2005 Nissan Titan
Apr 22, 2010 | 2004 Nissan Titan
Mar 20, 2010 | 2008 Nissan Titan
Oct 24, 2009 | Chevrolet Silverado 1500 Cars & Trucks
231 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: