Question about Cars & Trucks

1 Answer

What tool is used in removing transmission lines on radiator in a ford economy van

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 201 Answers

Open-end wrench probably 7/16ths they also make a slotted box-end for metal lines

Posted on Mar 20, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

junkman1249
  • 552 Answers

SOURCE: removing tranny lines from radiaor

on some fords a special tool is required to remove the lines. but it is not expenzive

Posted on Dec 09, 2008

alicantecoli
  • 22156 Answers

SOURCE: How do I remove the radiator from a 2003 S60?

cant say i have worked on one of these YET but if their is no obvious connection just a compression join then take it off the other end as it could be all one piece with the rad

Posted on Feb 13, 2009

oneStan
  • 430 Answers

SOURCE: removing the transmission cooling line fron

These lines just run straight through the radiator to provide cooling. You can bypass the radiator by adding a transmission fluid cooler, during the cold weather in a pinch, a replacement transmission hose with 2 clamps can be connected between the 2 transmission lines to correct leakage, but in warm weather, the fluid suffers if it doesn't get the benefit of a cooler.

Aftermarket coolers are relatively inexpensive, especially compared to the long term benefit of keeping the fluid degrees cooler, prolonging the life of the trans.

good luck

Posted on Feb 22, 2010

BCAS1298
  • 3092 Answers

SOURCE: removal of transmission cooling lines from

Yes, it's call a line disconnect tool, Napa has this tool part # 7759086 cost about $8.00.Also can be used for fuel filter line.

Posted on Jul 07, 2010

  • 12 Answers

SOURCE: Is there a special tool

Yep! You can rent one from your local parts store or just buy a Disconnect Set. But get the Aluminum set, don't waist you time and money on the plastic set. Autozone sells it for $9.99. Hope that helps.

Posted on Dec 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change a radiator out having trouble with the transmission line and heater line. I'm removing the radiator to replace and I'm having trouble with losening the lines from the radiator


You need to get the ford quick disconnect tools needed to disconnect both lines. Should be able to get these tools at any auto parts store.

Apr 04, 2011 | 1999 Ford Taurus

1 Answer

How do I remove the radiator form my 1997 ford taurus do I have to remove the bumper?


No,

Section 03-03: Engine Cooling 1997 Taurus, Sable Workshop Manual
REMOVAL AND INSTALLATION Radiator Aluminum Core, Crossflow
SPECIAL SERVICE TOOL(S) REQUIRED Description Tool Number Fuel Line Disconnect Tool Set T90T-9550-S
Removal
svh~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Do not mix Standard (green) Coolant with Extended Life Coolant (orange). If mixing occurs, drain engine cooling system and refill with originally equipped coolant type. If this contamination occurs, the service interval of Extended Life Coolant will be reduced from 6 years/150,000 miles to 3 years/30,000 miles.
  1. Disconnect battery ground cable (14301).
  1. Remove battery (10653) as described in Section 14-01 .
  1. Remove clip retaining contant control relay module and position module aside.
  1. Remove battery tray (10732) as described in Section 14-01 .
  1. Remove radiator cap (8100).
  1. Raise vehicle on hoist as described in Section 00-02 .
  1. Remove radiator splash shield.
  1. Drain engine cooling system as described in this section.
  1. Remove the radiator mounting bracket assembly.
  1. Remove lower radiator hose (8286).
  1. Partially lower vehicle.
  1. Remove upper radiator hose (8260).
  1. Remove radiator overflow hose (8075).
  1. Remove upper A/C condenser core retaining bolts.
  1. Remove upper transmission oil cooler tube clips.
  1. Remove lower transmission oil cooler tube (7C410)(EPN=7C410)using 3/8 Inch Fuel Line Disconnect Tool T90T-9550-C.
  1. Raise vehicle on hoist.
  1. Remove lower transmission oil cooler tube clips.
  1. Remove lower transmission oil cooler tube (7C410)(EPN=7C410)using 3/8 Inch Fuel Line Disconnect Tool T90T-9550-C.
  1. Remove transmission oil cooler bracket and position transmission oil cooler aside.
  1. Remove lower A/C condenser core bolts and position A/C condenser core (19712)aside.
  1. Remove radiator support bracket.
  1. Remove radiator (8005).

Jan 13, 2011 | 1997 Ford Taurus

3 Answers

Do you have to drain the oil & trany when removing the radiator & do you need special tools for removing the oil & trany lines that are connected to the radiator?


no you dont need to drain these units ,but i cannot comment on the pipe connections as i have never done one ,but on a jeep and a astro van i have done they had plastic connections that break if your not carefull ,sorry iam vague but iam in europe and dont work on many american cars

Dec 28, 2010 | 1999 Chevrolet Express

1 Answer

Removal of transmission cooling lines from radiator. my repair manual says i need a special tool.


Yes, it's call a line disconnect tool, Napa has this tool part # 7759086 cost about $8.00.Also can be used for fuel filter line.

Jul 07, 2010 | 1997 Ford Taurus

2 Answers

How to change radiator in 1992 ford explorer


Radiator Removal
  1. Drain the cooling system by removing the radiator cap and attaching a 9.5mm (3/8-inch) inside diameter hose to the draincock nipple, located at the lower rear corner of the radiator tank. Then, open the draincock and allow the coolant to flow through the hose into a suitable container.
  1. Remove the rubber overflow tube from the radiator and store it out of the way.
  1. Remove the shroud's or finger guard's two upper attaching screws. Lift the shroud out of the lower retaining clips and drape it on the fan.
  1. Loosen upper and lower hose clamps at the radiator and remove hoses from the radiator connectors.
  1. For vehicles with automatic transmissions:
    1. Disconnect the two transmission cooling lines from the oil cooler fittings on the radiator. Intermediate flare fittings as shown remain as originally installed.
    1. Disconnect the transmission cooler tube support bracket from the bottom flange of the radiator by removing the screw.

  1. Remove the two radiator upper attaching screws.
  1. Tilt the radiator back (rearward) approximately 25mm (one inch) and lift directly upward, clear of the radiator support and the cooling fan.
  1. If either hose is to be replaced, loosen clamp at the engine end and slip the hose off the connections with a twisting motion.
  1. Lift the shroud off the fan and remove from the vehicle.
  1. Remove the radiator lower support rubber insulators.


8a0d173.gif

Jun 12, 2010 | Ford Explorer Cars & Trucks

1 Answer

How to remove and replace radiator on 1998 ford taurus


  1. Disconnect battery ground cable.
  2. Remove the battery.
  3. Remove clip retaining constant control relay module and position module aside.
  4. Remove battery tray.
  5. Remove radiator cap.
  6. Raise vehicle on hoist.
  7. Remove radiator splash shield.
  8. Drain engine cooling system.
  9. Remove radiator mounting bracket assembly.
  10. Remove lower radiator hose.
  11. Partially lower vehicle.
  12. Remove upper radiator hose.
  13. Remove radiator overflow hose.
  14. Remove upper A/C condenser core retaining bolts.
  15. Remove upper A/C transmission oil cooler tube clips.
  16. Remove upper transmission oil cooler tube (7C410) using 3-8 inch fuel line disconnect tool 310-041 (T90T-9550-C).
  17. Raise vehicle on hoist.
  18. Remove lower transmission oil cooler tube clips.
  19. Remove lower transmission oil cooler tube using 3/8 inch fuel line disconnect tool 310-041 (T90T-9550-C).
  20. Remove transmission oil cooler bracket and position transmission oil cooler aside.
  21. Remove lower A/C condenser core bolts and position A/C condenser core (19712) aside.
  22. Remove radiator support bracket.
  23. Remove radiator.

May 07, 2010 | 1998 Ford Taurus

3 Answers

Where is the drain plug for a 91 ford aerostar mini van. I need to remove some fluid due to over fill.


Drain plug for what? Radiator? Engine? Transmission? Power Steering?

Being more specific will only ensure a more accurate description to advise you as to your needs.

We have people that want to help you...

Feb 19, 2010 | 1991 Ford Aerostar Extended

2 Answers

How to remove a radiator from a ford taurus


Disconnect battery ground cable. Remove battery. Remove battery tray. Remove clip retaining contant control relay module and position module aside. Remove radiator cap. Raise vehicle front end as high as possible. Remove radiator splash shield. Drain radiator. Remove the radiator mounting bracket assembly. Remove lower radiator hose. Partially lower vehicle. Remove upper radiator hose. Remove radiator overflow hose. Remove upper A/C condenser core retaining bolts. Remove upper transmission oil cooler tube clips. Remove lower transmission oil cooler tube. Raise vehicle. Remove lower transmission oil cooler tube clips. Remove lower transmission oil cooler tube. Remove transmission oil cooler bracket and position transmission oil cooler aside. Remove lower A/C condenser core bolts and position A/C condenser core aside(be careful not to loosen the AC condenser lines. Remove radiator support bracket. Remove radiator out through the bottom of the vehicle.
Installation
Position radiator. Position radiator support bracket and tighten nuts. Position A/C condenser core and tighten lower A/C condenser core bolts. Position transmission oil cooler tube and install transmission oil cooler tube bracket. Install lower transmission oil cooler tube. Install lower transmission oil cooler tube clips. Install lower radiator hose. Install radiator mounting bracket assembly. Tighten bolts. Install radiator splash shield. Lower vehicle. Install upper tranmission oil cooler tube. Install upper transmission oil cooler tube clips. Install upper A/C condenser core retaining bolts. Tighten bolts. Install radiator overflow hose and tighten clamps securely. Install upper radiator hose. Position constant control relay module and clip securely. Install battery tray. Install battery. Connect battery ground cable. Fill and bleed cooling system. Start engine and inspect for leaks.

Nov 25, 2009 | 1998 Ford Taurus

1 Answer

Removing tranny lines from radiaor


on some fords a special tool is required to remove the lines. but it is not expenzive

Dec 08, 2008 | 1997 Ford Windstar

1 Answer

Replace radiator 81 6 cyl ford van


Drain the radiator, Remove the upper and lower radiator hoses, Disconnect the trans. cooler lines. These are "hard" lines connected to the radiator approx. 5/16 lines. Remove the mounting bolts of the shroud (if equipped) Remove the mounting bolts for the radiator and lift straight up. Installation is the reverse. Be sure to fill your radiator with a 50/50 mix of coolant to water. Start and run van and check for leaks.

Jun 12, 2008 | Ford E-150 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...