Question about 2000 Mercedes-Benz CLK

Open Question

2000 mercedes benz clk430 dash lights

How do you access the dash to replace burnt out dash bulbs in the instument cluster......dave

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: Need Radio Code for CLK430 Mercedes Benz

Yes. Every time you disconnect the batterie you need to put radio code again.

Posted on Feb 27, 2009

  • 1 Answer

SOURCE: Replace Cabin Filter in my 2002 C240 Mercedes Benz

I have a 2002 C240 Mercedes and need to replace the cabin air filter. Problem, I don't know were it is located or how to replace it. Can you help me.

Posted on Mar 21, 2009

  • 14 Answers

SOURCE: reset oil change indicator 2008 mercedes benz E350

With the key in position 1, hit the odometer reset button on the left on the cluster 3 times in a row. The cluster should beep once. scroll through the multifunction display with the page buttons until the display shows the onboard voltage screen. It will say something like "UB: 12.2 V" scroll threw this menu with with the up/down until you reach the "service menu" page. scroll down to "confirmation" press +, confirm full service with +. Wait till it says service confirmed. cycle the key off and then back on to position 2. Scroll to the normal service menu where it normally says how many days or miles till next service. If the service was reset correctly, it will say "service display not possible" for a few minutes while it recalculates. You must cycle the key off and back on before it will back out of the onboard diagnostic mode. If you dont back out, the esp/abs/bas lights will illuminate when the car is started

Posted on Apr 13, 2009

  • 1959 Answers

SOURCE: need a diagram for serpentine belt replacement for mercedes benz

Below is a link for your diagram. Best of luck!

Posted on Jun 18, 2009

  • 8 Answers

SOURCE: all gauges on instument cluster not working

In most vehicles there is a wiring harness that runs under your dash to your heater etc. Sometimes the main plug comes loose. If you open up the steering column or somewhere down by your feet on the steering column is the main plug - look in your manual and track the wires with a tester ensuring you have power all the way to whatever is not working. If there is no power at the main plug then you might have a ground problem or a loose wire in the plug itself. Good luck

Posted on Jun 26, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Instrument cluster stopped functioning is there a fuse or relay

Instrument cluster removal - Mercedes - YouTube

? 2:09
Jan 15, 2010 - Uploaded by Lim Lai Aik my instrument panel lights not can I change the bulbs? thanks ... 1972 Mercedes-Benz 600 Kompressor - Jay Leno's Garage - Duration: 18:56. by ... How to convert Mercedes R129 SL ,w124 dash gauge lighting to LED ... Part 1/5 Mercedes S-Class W220 Instrument Cluster Repair - Duration: ...

Sep 24, 2015 | 1992 Mercedes-Benz SL-Class

1 Answer

1992 M.B.300 D Insterment gauge removeil

Use two hooked anythings and put in each side of cluster and pull straight out. It's only held in by four pieces of friction rubber. Two on top and two on bottom. When loose mark and remove bulbs, speedo cable.

Jun 07, 2014 | 1984 Mercedes-Benz Mercedes Benz 300 Class

1 Answer

Need to cahnge the bulbs in the instument cluster on a 2002 chrysler concorde

Remove dash trim around the cluster to access the screws holding in the cluster. on back side of cluster should be the blade type bulbs.5eccf67a-7e57-48ea-aa2e-67e4dccfc666.jpg

Dec 05, 2013 | 1991 BMW 3 Series

1 Answer

How do I change the dash light bulb for 1999 Nissan Altima GXE?

You will have to remove the cluster. Remove the trim around the dash in front of the cluster, remove the bolts holding the cluster in, then you can access the rear to replace the burnt out bulb.

Jun 18, 2013 | Nissan Altima Cars & Trucks

1 Answer

Dash light behind outside temp has gone out, how do you replace it?

pull out the instrument cluster by using the dash removal hooks. can be bought from mercedes dealer on any tool dealer like snapon or mac. all u do is to insert the hooks on either side of the instrument cluster usually on yhe lower sides and u will feel the hooks grab th instrument cluster. carefully pull the cluster out and disconnect the plug. you might have to have the steering wheel in the extended position to slide out the clucter. once you have the cluster out replace the bulb directly behind.

Sep 01, 2010 | 2000 Mercedes-Benz CLK

1 Answer


The bulb itself is located within the clock itself although have you checked your fuses ? to get to the bulb itself you need to get up under the dash to replace it

Nov 18, 2009 | 2000 Mercedes-Benz E-Class

1 Answer

Instrument cluster on my 2005 S500 back illumination went out, although all the gauges are still working inclusive of the on board computer

remove the cluster(should be able to insert Small flat head screwdrivers into slots on plastic trim of cluster. Lower your steering wheel down and remove key. wait approx 30 seconds until cluster is off( means that the interior c.a.n. has went to sleep) unplug cluster and see if the bulbs you wish to replace are accessible from the rear cover. if not remove retaining screws and un clip rear cover from housing. You should have access to the back lighting bulbs

May 31, 2009 | 2005 Mercedes-Benz CL65 AMG

1 Answer

Instruments lamps don't turn on in Mercedes 300E 1992

Make sure your dash "dimmer" is not turned all the way done, its a small rod thats twists clockwise to increase dash illumination, counter clockwise to decrease...
Next..the bulbs in the back of the gauge cluster might be burned out , if they are the original bulbs, thats probably the case...

Jan 11, 2009 | 1984 Mercedes-Benz Mercedes Benz 300 Class

Not finding what you are looking for?
2000 Mercedes-Benz CLK Logo

Related Topics:

327 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

81400 Answers

Joseph Prosser

Level 3 Expert

772 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides