Question about 1999 Honda CR-V

1 Answer

When I turn into a parking space or onto a street it sounds like something clicking or vibrating even when i push my clutch in

When I make a sharp turn it sounds like my muffler is vibrating or is wanting to stall

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Master
  • 448 Answers

Most clicking/popping noises when turning indicate a bad ball joint in the front axle. The CV joint has a boot over it that will eventually rip, causing the grease inside to be slung out. Dirt and moisture will get in there and cause the smooth joint to pop when under stress, like turning.

Posted on Jul 02, 2014


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 7353 Answers

SOURCE: Loud vibration sound when making tight turns, i.e.

is it AWD? if so have the rear diff fluid replaced, its special fluid from the honda dealer, the rear diff may be bad.

Posted on Apr 23, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What sound do you hear when universal joint is going BAD on a 2006 Ford 500

Typically you will hear clicking in the turns, such as when you pull in or out of a parking space, sometimes you just get a lot of vibration.

Feb 13, 2016 | Ford Cars & Trucks

1 Answer

Nissan serena 1999 .3 diesel vibration while accelerating and while taking foot off gas pedle also when using clutch but fine while cruising

bad axel shaft or the clutch is off balance. check for play in axel you will hear a clicking sound when turning sharp if the axel is worn

Nov 03, 2013 | Cars & Trucks

1 Answer

Please help! Ford fiesta courier van mk4 broke down after tapping noise.

What was the water temp reading before you parked. You just seized the front carrier bearing. (right front). But if you overheated the engine before you parked. You blew a head gasket, resulting in a hydro locked condition. That's why the starter will not turn engine over when you tried to crank it. ( Expensive!)

Feb 27, 2017 | Ford Fiesta Cars & Trucks

1 Answer

I was driving 40 mph and I heard something that sounded like a bolt hitting the street from off of my car and a loud sound was coming from under the front end of my 2002 dodge neon. When my car is rolling...

Hi, the problem is either a wheel bearing or driveshaft joint. You will need a mechanic to repair the car, as these repairs require experience and special tools. To verify the problem, you can get under the front of the car and grab the half-shafts--there is one on each side going to the middle of the wheel hub. Pull the shaft up/down or side to side. There should be no movement at all. If there is movement, you are holding the bad shaft. A mechanic can tell if the problem is with the shaft itself or the bearing in the hub. Please let me know if you have more questions, and thanks for using FixYa.

Mar 17, 2011 | 2002 Dodge Neon

1 Answer

Vibration rattle coming from the front behind and under dash

hi, the inner wheel arch linings should be made of plastic,( if my memory serves me correctly ), make sure that all of the plastic rivvets are in place, doesnt sound like a very serious problem, it sounds more like cosmetic than mechanical

Aug 19, 2009 | 2001 BMW 330

5 Answers

So... are you ready for my clutch question? I had the clutch on my 5 speed 2001 Elantra replaced with new components. The clutch would vibrate or pulsate at the pedal when depressing it. Also a clicking...

So, are you ready for some help with your clutch problem? I will give rhe shop the benefit of doubt and assume they didn't check everything..They did the simple process of parts replacement which it will never be known whether or not you even needed a clutch.. Should we continue?

Jul 08, 2009 | 2004 Hyundai Elantra

2 Answers

New clutch in Ford Escort wagon, new problems

Take it to a real mechanic. The last guy must have been a parts re-placer and messed up other components.

May 19, 2009 | 1994 Ford Escort

1 Answer

Popping noise

Inner tie rods could make the same noise your describing. Do this......with your car in park and at idle, slightly turn you wheel from left to right, just a slight ****. 1/16 of a turn. Increase the pace from left to right, then slow down the pace. You should feel a bump in the steering wheel almost like something is tapping it. If so, have your inner and outer tie rods checked. Actually, have the steering gear checked also for leaks and wear.

Nov 01, 2008 | 2000 Chrysler LHS

1 Answer

Hummer H2 front tires rub when making sharp turns

If it definitely wasn't doing it before you took it in to the dealer and it was after they worked on it, then it must be related to what they have done and should be repaired by them. I recommend that you take it back again, ask to speak to the service manager and explain that you want it sorted out. If you get no joy from him, make an appointment to see the Dealer Principal (or overall manager, whatever his title is). I find it hard to believe that any reputable dealer would tell you that there is nothing wrong/nothing they can do when it MUST be something they have done in the first place. While the rubbing is probably not going to cause that much damage to the tyres, it is not exactly desirable either! If you still can't get any help from them, you could get another mechanic to look at it give you a second opinion. If they need to charge you for doing so, then you should be able to get reimbursed by the dealer once it is proven that there is an issue.

Sorry I can't help more.

Oct 31, 2008 | 2003 Hummer H2

2 Answers

Gearbox from clutch

have you checked the clutch mechanism? for me sounds like the clutch doesn't engage properly or fully rather. Ask your mechanic to check the clutch system fully and check whether it fully engages, or do this check for yourself. Bring car onto a flat surface and shift to 1st while engine being switched off, start it while pressing the clutch (fully down to the floor board) and then release parking break and check for following
whether vehicle is moving
RPM decreases a bit
does engine get loaded and start vibrate or rattle a bit

Jun 07, 2008 | 1987 Peugeot Liberte

Not finding what you are looking for?
1999 Honda CR-V Logo

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides