Question about Chevrolet Suburban

1 Answer

Replace check engine fuse

Where is the location of the fuse

Posted by on

  • Kyle Jenik
    Kyle Jenik Mar 19, 2014

    For the check engine light

  • Kyle Jenik
    Kyle Jenik Mar 19, 2014

    in a 1996 Suburban

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 189 Answers

There is no such fuse- post the real problem please

Posted on Dec 23, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Were is the fuse location for the the fan for a 2006 pt cruise limited ed


fuse location for the the fan Mitsy, Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Engine cooling fan, 50 amp fuse,at the power distribution center or relay box at engine compartment.
Heat/ Defrost fan fuse number 7 inside drivers dash fuse box.

How To Install Replace AC Heater Fan Speed Resistor Chrysler Pacifica 04...

2008 PT Cruiser Fan Relay Location

Mar 24, 2016 | Cars & Trucks

1 Answer

Low power on toyota 2007 camry. Do I need to reset by reinstalling the new battery?


The fuse and relay box is located in the engine bay area. Please lift up the cover by pressing front and rear locks, and find the ECTS fuse (10 Amp). Location and diagram of the fuse is printed underside the cover. Remove the fuse, check the fusible link. Replace it with the same rating, if it is blown.
After replacing the fuse, remove the EFI fuse in the same relay box or remove the battery terminal for 10 Sec.
Fix the fuse back to its place or reconnect the battery terminal.
Start the car. It should now perform well.
If the problem persists, retrieve the error code and put it here.
Hope that works.

Jul 24, 2014 | Toyota Camry Cars & Trucks

1 Answer

Wont start, clicking and all dash lights on. relpaced starter no go.


check the starter and ignition fuse. starter fuse is located in the fuse box in your engine bay, ignition fuse is located in the kick panel which is right under your steering wheel.

May 17, 2012 | 2006 Dodge Durango

1 Answer

97 jeep patriot Malfunction light on when driving


Open the fuse panel that is located under the steering column by pulling down on the fuse cover using your hands.

  • 2 Locate the fuse for the ECU (electronic control unit) using the fuse diagram on the underside of the fuse panel cover.
  • 3 Turn the ignition on without cranking the engine.
  • 4 Pull the fuse for the ECU using the fuse puller located in the fuse panel.
  • 5 Wait five minutes and replace the fuse. Wait for the check engine light to go out.
  • Oct 15, 2011 | 2007 Jeep Patriot Sport

    1 Answer

    Where is starter located for 1999 olds alero? and how can I turn it on from starter?


    YOU HAVE TO REMOVE AIR INTAKE DUCT AND RESONATOR TO GET TO THE STARTER TOP BOLTS AND SAFELY RAISE SUPPORT VECHICLE ON JACK STANDS.MAKE SURE VECHICLE ON A LEVEL SOLID GROUND.REMOVE ENGINE LOWER SPLASH SHIELD.AND REMOVE THE STARTER.I STARTER NOT WORKING.CHECK BATTERY VOLTAGE FIRST.SHOULD BE 12.6 VOLTS.IF NOT HAVE BATTERY TESTED.AT ANY AUTO PARTS STORES.IF BATTERY WAS WEAK.HAD TO REPLACED.START THE ENGINE.WITH NEW BATTERY CHECK TO MAKE SURE ALTERNATOR CHARGING BATTERY.VOLTS AT THE BATTERY WITH ENGINE RUNNING SHOULD BE 13.5 TO 14.5 VOLTS.IF NOT ALTERNATOR FAULTY.IF BATTERY AND ALTERNATOR GOOD REMOVE.TAKE STARTER TO AUTO PARTS STORE HAVE THEM CHECK OUT ALTERNATOR.IF ALTERNATOR GOOD.REPLACE BOTH BATTERY CABLES AND CHECK THE STARTER FUSE AND RELAY AND CHECK THE 40 AMP IGNITION SWITCH BATTERY FUSE IN THE FUSE AND RELAY BOX UNDER HOOD IN THE ENGINE COMPARTMENT.LOOK AT FUSE COVER IT WILL GIVE YOU FUSES AND RELAYS LOCATION. WARNING BEFORE REMOVING NEGATIVE BATTERY CABLE. TURN OFF RADIO TO KEEP FROM LOCKING IT OUT.

    Dec 15, 2010 | 1999 Oldsmobile Alero

    2 Answers

    Emergency flashers and turn signals stop operating


    The interior fuse box locations - 1995-97 Town Car 93146g31.gif
    The engine compartment fuse box locations - 1995-97 Town Car 93146g30.gif
    The interior fuse box locations - 1995-96 Continental 93146g34.gif
    The engine compartment fuse box locations - 1995-96 Continental 93146g35.gif

    Sep 24, 2010 | 1995 Lincoln Town Car

    1 Answer

    How do i replace the check engine light in a 2000 honda accord, it is burnt out


    Hello, The following steps will show you how to do that:

    1. Check to make sure your engine is off. This may sound like common sense but this is important.


    2. Check to make sure your gas cap is tighten. Take it off and place it back on until you hear the gas cap click.

    3. Open the passenger side door. Look for the fuse box located on the side of the dash board. You'll see it says fuse. Open the fuse box.

    4. Look on the backside of the fuse panel door. You should see a lists of the arrangement of the fuses. Locate the fuse that says "Clock." This should be fuse number 13. Use tweezers or preferably a fuse puller. Pull the fuse.

    5. Leave the fuse out for about 10-30 minutes. Place the fuse back in. Your car system will reset. The clock and radio settings have returned to default settings and check engine light should be off.

    Thanks


















    Jul 29, 2010 | 2000 Honda Accord

    1 Answer

    Location of engine fuse panel


    yes he was right ,their is a black box just back a bit from the battery ,

    Jul 24, 2010 | 1996 Volkswagen Jetta

    1 Answer

    2001 F350 just died and won't start??? Replaced cam sensor, been trouble shooting. Any sugestions????


    first check all fuses.replace all burnt fuses check the big main fuses in distribution box in engine compartment,if this is a diesel engine.I would start looking at a direct injection module 100% its usually located on driverside inner fender 2"x8"x10" dimensons

    Mar 18, 2010 | 2001 Ford F350 Super Duty SuperCab

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    14 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    76164 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8273 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...