Question about 2005 Chrysler Town & Country

1 Answer

Dashboard flickers and engine stalls

Dashboard flickers, radio dies, and engine stalls often when the air conditioning is on

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Chrysler Expert
  • 405 Answers

CHANGE CAR BATTERY AND OR CHECK ALTERNATOR OUTPUT FIRST

Posted on Jan 07, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 Grand Cherokee larado dies when you slow down or are stopped. Some bucking/stalling when driving it. We have replaced trottle sensor and igination coil; change air filter; but we did just install a new...


The ac compressor does put an additional load on the engine.
Any minor problem with performance can be amplified with the ac on.
I would check fuel pressure and look at the idle air control valve.
Also check the computer for trouble codes.
Both 6 and 8 cyl engines use a cap rotor and wires arrangement, so it wouldn't hurt to make sure those components as well as the spark plugs are in good working order.
The bucking on the road and stalling at stops could be two different issues.

Jul 21, 2012 | 1997 Jeep Grand Cherokee

1 Answer

Rough idle no check engine light on starting to stall when making turns at low speed like in the drive thru radio lights flicker


did not specify rpm, but sounds likely to be a idle control valve, it adjust engine rpm when a demand or load is apply like turning your wheel, so the engine dont die. try cleaning it, if not enougth carbon build up found in it, replace valve.

Dec 05, 2010 | 1999 Ford Explorer

1 Answer

My 2002 Trailblazer is stalling out (not dieing out) the rpm's drop and it sounds like it is going to die and then the rpm's come back up and it is real bad when the defrosters or the air conditioning is...


Well the radio must come out and sent out for repair, nothing you can do to fix this. As far as the other problem goes I suggest you clean the throttle valve and the idle speed control air bypass valve with throttle valve cleaner.

Jul 26, 2017 | 2002 Chevrolet TrailBlazer

2 Answers

Car shutting off when air condition is turn on causing it to stall


There is a switch that works the computer upon turning on the air conditioning. Upon turning the AC on the switch sends a signal to the computer to increase the RPM's to the engine so it will not die out

Jan 16, 2010 | 2002 Chevrolet TrailBlazer

1 Answer

My engine in my '03 toyota matrix xr dies.


check the mass air flow sensor it is hooked with air cleaner

Feb 23, 2009 | 2003 Toyota Matrix

1 Answer

Check Engine Light is on. Pops O2 sensor but car is acting funny.


This sounds like the loss of electrical power because of the lights.Any chance of a broken engine/transmission mount allowing to much movement and breaking a connection? Along this same line, look for a vacuum leak that occurs while in gear. If the o2 sensor code is for a lean condition a vacuum leak could case it and the drivability condition /stalling you are getting. Hope this helps and rate me please!!

Jan 13, 2009 | 2002 Ford Taurus

1 Answer

Engine Light goes on then clicking under dashboard -- engine stalls


could simply be your battery is about to die and the voltage is getting too low.
if the engine light is going on then take it to a mitsubishi dealer and they can read the stored error code.

Jan 07, 2009 | 1992 Mitsubishi 3000GT

1 Answer

Engine stalls when brake is pressed


is this while in motion or setting still? if in motion it could be the torque converter clutch. I'm just trying to help

Jun 05, 2008 | 1993 Chevrolet K1500

Not finding what you are looking for?
2005 Chrysler Town & Country Logo

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...