Question about 1995 Nissan Maxima

1 Answer

Heat fan Indoor fan doesn't run on high

Posted by Anonymous on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Could be the blower motor resistor - they have a tendency to burn out. Symptoms are losing one or more speeds on the blower fan. It's an easy replacement, the resistor is accessible under the dash.

Posted on Mar 22, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cooling fan motor gets hot when running high speed why


Check the bearings. If the friction is high the fan will not run at rated speed. When it runs slower it uses more current and gets hotter...

Disassemble, clean and lubricate to make sure fan runs full blast and does not burn out.

Or if the fan has two windings, one for starting and one for running it is possible that the high speed run winding has some shorts in it resulting in more current and more heat.

Oct 13, 2015 | Cars & Trucks

1 Answer

2001 chevy cavalier radiator fan doesn't run


unplug fan sensor if it runs then most likely needs replaced if not buy a used fan at a scrap yard maybe 40.00

Mar 26, 2013 | 2001 Chevrolet Cavalier

1 Answer

My 1998 Subaru the heat comes on and off gauge goes up to high then back down but doesn't over heat?


need a drive to be honest so i would know whats wrong ,ask a local mechanic to have a look as it could be a cooling fan or a thermostat maybe even the water pump drive shaft to impeller come loose

Jan 03, 2013 | Subaru Cars & Trucks

1 Answer

Radiator fan runs too much


You more than likely installed a high temp thermostat, which takes more heat to open than the factory one.
One way to solve this is to install a lower temp thermostat. Or you could try another temperature sending unit, That should run your fan like normal again. But if it doesn't try to swap your fan relay out.

Nov 18, 2011 | 2002 Jaguar S-Type

1 Answer

Extremely high pressure on low side and no reading on high side


You have a restriction in the system. Orifice tube, accumulator, dryer, evaporator, or condensor. Make sure your fan clutch is good as a faulty fan clutch that doesn't get rid of enough heat from the radiator can cause this because the condensor is mounted in FRONT of the radiator. The fan clutch should AWLAYS have some drag and should completely STOP within 2 seconds of turning the car off.

Jul 17, 2011 | 2000 Chevrolet S-10

1 Answer

06 Kia Sedona overheats when ac is on. If the ac is off the van will return to normal temps. Had the compressor just replaced and v-belt. Both fans appear to be running when ac is on.


Does the engine over heat or the gauge goes to hot. Really hot. Since the A/C is on , this puts an extra load on the engine. This is why the fans come on when the A/C is turned on. This is usually low speed fan mode. High speed doesn't come on untilll 220 to 230 degrees. Most vehicles. Cars don't over heat untill the gauge gets in the red, when it starts getting close is time to worry and stop. I guess the question to you would be, What does the temp gauge read?

Jul 02, 2011 | 2002 Kia Sedona

1 Answer

Air/heat not blowing from vents, can feel the heat but it's not blowing, I turn the knobs to high blow and it won't do anything, its cold outside,


if the fan does not increase speed as turned up replace resistor assembly usually in heater housing under dash.if doesn,t nave separate resistor assy.it is the fan switch

Feb 11, 2011 | 2002 Buick Century

1 Answer

The heat only works when its on high..when the fan is on.. when its on low or med there no heat blowing??


You have a bad resistor on the fan. High is the only speed that doesn't run through the resistor.

I hope this helps you.

Feb 02, 2011 | Chrysler Sebring Cars & Trucks

2 Answers

No heat


How about the thermstat

Feb 06, 2009 | 1998 Ford Escort

Not finding what you are looking for?
1995 Nissan Maxima Logo

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14251 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...