Question about 2004 Ford Ranger

1 Answer

I have a problem with a 2004 ford ranger 2.3 that would crank but would not start. It has spark and I have changed al that I think would be the problem like the crank and cam sensors and also the iac

Need some help thanks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Ford Expert
  • 150 Answers

Have you checked to see if you have fuel pressure. Sometimes the fuel pump will run but if it is worn out and is not pumping any pressure. Listen for the fuel pump to see if it runs when you turn the key on.Then check the fuel pressure at the engine to see if fuel is getting to the engine with pressure and volume. I hope this helps.

Posted on Dec 14, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 21 Answers

SOURCE: 2002 7.3 F350 WONT START

starter might be going bad that can cause it to drain the batterys

did you check to see if it is getting fuel if it has duel tanks the valve to switch tanks can go out and that can stick in a position were it doesnt allow any fuel to pass it could be the pump too

Posted on Aug 27, 2008

  • 208 Answers

SOURCE: 2000 ford explorer 4.0 x-engine is stalling, missing and lose power while driving

I personally would check the fuel pressure. Then I would go back to the coil. I have seen brand new bad coils out of the box. The symptoms of a loss of power point to this component, especially if the car idles well, but loses power when accelerating. Please do not rate this reply - we all are left to grasp at straws since you have changed pretty much everything. Good Luck. Please post the final fix of the problem.

Posted on Oct 28, 2008

co7196
  • 3433 Answers

SOURCE: my ford ranger idles low and spits gas out the exhaust

Hello,
First confirm it is either gas or eastter. Wayer/condedste collects at the tail oip as a byproduct of the caralyctic converter on cold rngine It normally occurs on firts start of a cokd enginw. the ebgine idles low because it is col, but should reyutn to normsl after warm uo.. If for sure iys gasolinem and the engine runs eiygh, then angihector is bad, good luck. I hope this helped yyou

Posted on May 15, 2009

motor1258
  • 6674 Answers

SOURCE: 1997 ford explorer cuts off while driving down

If you confirmed spark is there, and you hear fuel pump working, I'd still try spraying WD-40 in throttle body intake for a couple of seconds, when it won't start, just to see if it kicks over, just in case pump is running but not up to pressure. If it fires for a second or 2 with WD-40, then you know lack of fuel is the problem.

Posted on Jun 11, 2009

  • 1 Answer

SOURCE: 2001 FORD TAURUS 24 VALVE DOHC MOTOR WILL NOT START

i have a 2001 taurus 24valve dohc 3.0 engne i have a bad coil pack what steps do i need to do to change the coil pack

Posted on Jul 18, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Both coils do not fire on 1 and 4. Will start but only running on 2 cylinders. Could both coils be bad or should I look elsewhere?


Part 3 -How to Test the Ignition Module and Crank Sensor ...

easyautodiagnostics.com > Ford > 2.3L
Mar 1, 2012 - Spark plugs for cylinders #2 and #3 get spark at the exact same time. ...voltage -12 Volts) to both individual ignition coils within the coil pack. ... Ford Mustang or Ranger (or 2.3L Mazda B2300), this is what you'll need ... for this 'Switching Signal' at the coil pack... but you can also test this ... 1991, 1992, 1993.

How to Diagnose a Misfiring Cylinder (2.3L Ford Ranger ...

troubleshootmyvehicle.com > Ford > 2.3L
Apr 3, 2012 - Bad Fuel Injectors can cause a Misfire Condition. ... the ignition system on the 2.3L Ford Mustang or Ranger consists of 2 ignition coil packs, ...

2002 ranger misfire rough idle - Discussion on Topix

www.topix.com > Ford Ranger
Jul 27, 2007 - My truck is giving the code misfire in number 4 cyl. I replaced my spark plugs, Wires, Coil packs (both of them) and all my fuil ... three (3.0L v6) go bad, the fuel/air mixture gets messed up. Judged: 2. 2 ... My truck runs rough only at idle. ...code for ford ranger 2002, 2.3 5speed. truck runs like a champ but that ...

Extremely stumped! I need the best and brightest 1994 Ford ...

answers.edmunds.com > Edmunds Answers

Jan 31, 2016 | Cars & Trucks

1 Answer

I have a 1988 ford ranger. i didn't have jumper cables and had to get to work. i pulled the battery out of my subaru and started the ranger off of it. when i was putting my battery back in i was in such a...


put the battery on charge and try it if it cranks but no spark then its the ignition module i think ,never had this happen before ,yes i have dropped cable as well iam not perfect .but never had one that wouldnt start ,hence check the spark ,could have answered this on live chat but iam trying to save you 10€

Jan 09, 2010 | 1988 Ford Ranger

1 Answer

TWO DAYS AGO 94 RANGER (4 CYL) SOHC...STOPPED ON ROAD. CRANKS BUT DOES NOT START. HAS FUEL PRESSURE. CHANGED FUEL FILTER. CHANGED AIR FILTER. CHANGED ONE OF THE DISTRIBUTOR COILS...TWO SPARK WIRES WERE NOT...


If all the coils are giving spark now,then you moat likely have gas fouled plugs now,so change them out with new ones,all 8 of them.If you do not have spark on all plug wires,pull the timing belt cover,and align the cam shaft and the cam,to see if the belt has jumped.If It hasn`t,replace the crankshaft sensor.

Oct 17, 2009 | 1994 Ford Ranger Supercab

1 Answer

2001 ford ranger after it sits for a few hours it


No not the fuel pump. You most likely need to do a tune uo. New spark plugs, wires, fuel filter, air filter. Deffinently change out the spark plugs. I would suggest using autocraft, autolite (fords brand} or some densos or ngk for better performance. Hope this solves your problem.

Aug 30, 2009 | 1998 Ford Ranger SuperCab

1 Answer

How do I remove a 2004 ford ranger xlt crankshaft pulley?


the crank sensor may not be working. it controls the spark.

Jun 07, 2009 | 2004 Ford Ranger

2 Answers

1991 ford ranger not getting any spark


probably the coil , but have your alternator checked first

Oct 07, 2008 | 1991 Ford Ranger Supercab

1 Answer

2004 ranger fuel pump


did you replace the fuel filter as well

Sep 27, 2008 | 2005 Ford Ranger

2 Answers

MY 2001 FORD RANGER WONT START. INGENE ROTATE AND IS GOT A GOOD SPARK. I CHECK FUEL POMP AND IS WORKING. DID NOT CHECK FOR PRESSION , DID NOT CHECK FUEL FILTER.I CHANGE AIR FLOW SENSOR STIL SAME.


2001 Ranger parked 2 months in my garage. Has always started on first time. Today it did not. Fuel tank full. New Battery installed. It will not fire up. How do I solve this?

Aug 03, 2008 | 2001 Ford Ranger Regular Cab

Not finding what you are looking for?
2004 Ford Ranger Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...