Question about 2000 Ford Windstar

1 Answer

The torque converter solenoid was bad in my 200 ford windstar the garage said i will be ok to drive. i drove it for a while and while driving my rpm went up to 5000 and now my van will not even move. do you think it may havt to do wit the solenoid?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 105 Answers

Trans problems are common with these vans unfortunatly you will probably have to rebuild or replace trans if you had solinoid replaced right away you might have saved it but not very likely

Posted on Jun 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 ford windstar will not move when put in drive or reverse


run the fault codes and look for a torque converter solenoid/servo fault. Check for a TCM problem.

Nov 28, 2014 | 2000 Ford Windstar

1 Answer

My 96 ford escort automatic acts like it jumps to nueteral while driving until it reachs running temp


Have you tried to replace the transmission filter and flush the transmission? you could also have a bad torque converter clutch solenoid. I have a ford windstar van that does that and it does that. I found out that the torque converter clutch solenoid is bad.

Jun 10, 2012 | 1995 Ford Escort

1 Answer

1999 ford windstar leaking fluid when hot.


Seal,s Leak So Sounds Like the torque Is Leakin Or Axle Seal Is Any Way Drive Add Fluid till It Drops Don,t change the tranny unless get,s bigger mess Other than that Drive it O/d Is ok Abs is wire Gone Bad don,t Worry Be HAPPY Don,t Worry Be HAppy DRIVE IT

May 27, 2012 | 1999 Ford Windstar

1 Answer

Driving a 2003 Ford windstar. Went to pass and


Very common on this make and model trans, pump drive splines inside torque converter strip out and pump is not turning, Most times there is no damage to pump shaft. Remove trans and remove torque converter, inspect the splines at the very bottom of the hub hole. If stripped out inspected pump shaft splines which are the smaller center splines coming out of trans, if ok replace torque converter and re-install trans, change out fluid, clean any metal from magnet and replace filter, fill with fluid and verify proper operation.

Mar 01, 2010 | 2003 Ford Windstar

1 Answer

98 trans. shift problem


Have the torque converter lockup switch checked, might be bad,
If the dodges are equipped with them.
I deal in GM products.

Aug 18, 2009 | 1999 Dodge Ram

1 Answer

Torque converter or wiring problem affecting speed


tcc solenoid is crapping out take it to a mehcanic or pull the pan solenoid body assenbly and replace the tcc torque converter clutch pressure solenoid

Jan 15, 2009 | 2000 Ford Expedition

1 Answer

Ford 2003 Windstar transmission problem


Windstar tranny problem: just got off phone with Northway Transmission of Queensbury, NY Technician said the torque converter had destroyed itself. the pump drive spline in converter broke and took out fins in torque converter it's going to cost me nearly $1600.00 car has only 45000mi on it and I caught it rather quickly and DID NOT TOW had car moved by flatbed/ramp truck otherwise they would have had to completly tear down transmission. (over $2300.00)

Jan 03, 2009 | 2003 Ford Windstar

Not finding what you are looking for?
2000 Ford Windstar Logo

Related Topics:

238 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...