Question about 2002 Ford Ranger Regular Cab

1 Answer

2002 ford ranger will not start after driving 60 miles and over and stop will not start again until about an hour

Will not start again until about an hour then it will start

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Ford Master
  • 715 Answers

When your truck stops check for spark at the spark plugs, next check that you have fuel pressure at the shrader valve, If you have no spark check the ignition modular, if no fuel pressure test fuel pump PSI, if both are not present change the ignition modular in the distributor .

Posted on Mar 19, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 653 Answers

SOURCE: 2002 ford Ranger 3.0 v6 (auto) rear end noise when accelerating on curves.

Grab the bed of the truck and vigorously rock the vehicle from side to side. If you hear clunking in the axle, you probably need to check the carrier bearings in the differential. I had the carrier bearings, wheel bearings, and seals replaced in my mother-in-law's 1991 Ranger for $280, and it rides like a new truck. Well, ok, it rides like an 18 year old truck with a new rear end. I provided the wheel bearings and seals to the shop, and they provided the carrier bearing, lube, and labor. While the axles are out, check the surface where the axles ride on the bearings. If they are worn, there are undersized bearing available, but it is usually cheaper and easier to just by new axles.

Posted on Feb 12, 2009

localwonder
  • 6784 Answers

SOURCE: truck stalls while driving, will start again if wait ten minutes

Ok, this sounds like a weak fuel pump and clogged filter. if possible, you will need to change these two vital devices. I would also replace the air filter as well.

Inspect the injection system for faults as well. make sure all injectors are firing properly and on time. replace any injector that isn't functioning correctly.

Posted on May 29, 2009

  • 651 Answers

SOURCE: 1992 Ford Ranger XLT V6 wont start without ether

first go to an auto partstore and have the code checked. most do it for free. could be coil, fuel pump, fuel filter, air filter or even a bad gas cap. but the dianogstic test should pin point the problem.

Posted on Jul 01, 2009

  • 18 Answers

SOURCE: when do you change timing belt on 2002 Ford Ranger

It is recommended that you change the timing belt at 80000 miles, but I had one with over 200,000 miles that never had a problem.

Posted on Sep 24, 2009

  • 10 Answers

SOURCE: 1994 ford thunderbird 4.6 v8. engine light is

Can also be dirty injector. When computer recognizes the miss, the light will come on, recording the active fault in memory. Advance auto will read the fault codes for you for free. Just a note: the light will reset after 3 complete warm up / cool down cycles if the fault no longer exists. If ignition checks good, take a hard look at those injectors. May need a cleaning.

Posted on Feb 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2002 2 wheel has vibration in front end whan i go 55-60 miles per hour. alot of shake in the steering wheel also. what could be the culprit


Hi Mikey. Take the vehicle for wheel balancing and alignment. Get the technician at the centre to inspect the steering and suspension linkages while he's doing the alignment, but I think wheel balancing will sort out your problem. Regards John

Feb 23, 2014 | Ford Cars & Trucks

1 Answer

Engine lost power and then shutoff


Sounds like your ful pump is on its way out

Aug 17, 2012 | 2003 Ford F150 Regular Cab

1 Answer

I have a 1994 ford Ranger 4.0 V6 It runs great but after about an hour it starts acting like it runs out of fuel dies and wont start again, i can hear my fuel pump working , it has a brand new fuel filter,...


Fuel caps have breather holes in them - once clogged the fuel tank is sucked vacuum and the engine stalls. Check the fuel tank cap for clogged breather holes.

Jun 26, 2011 | 1994 Ford Ranger Supercab

4 Answers

Ford Ranger overdrive light flashes


Problem probably solved right here!

Jul 07, 2009 | 1999 Ford Ranger SuperCab

1 Answer

2002 Ford Ranger runs all day starting and stopping the engine, then 1 hour later starts and sputters off after trying to start. Weather was hot and humid but never have had this problem...any ideas??


if its not damaged spark plugs or cables then it could damaged or water in distributor, If there is a black coil it could be losing current wait until night time and start vehicle you will see current light up like a christmas tree

Jun 16, 2009 | 1987 Ford Ranger

2 Answers

2005 ford ranger


You are on the right track! Check all the ground connections! And there are many! Loosen off each and clean. This should solve your prob! Frankster016

Oct 23, 2008 | 2005 Ford Ranger

1 Answer

1996 ford ranger which is not driven regularly had to go about 40 miles on highway.Did not have to shift for about 35 miles when I was exiting the clutch felt like it was frozen I coasted to a stop.I could...


If the truck has been sitting, I would be looking into the bell housing for mouse nest. Chipmunks and mice love to make nests in there. Nut shells and other debris will interfer when clutch pedal is depressed. All that **** falls in between the pressure plate and slave cylinder. It's hard to clean out without removing transmission. Good Luck

Sep 15, 2008 | 1996 Ford Ranger SuperCab

Not finding what you are looking for?
2002 Ford Ranger Regular Cab Logo

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5471 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...