Question about 1994 Isuzu Rodeo

1 Answer

Quit firing changed alternator,, tuned up, the plate is good what can be the problem

Not firing

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.

  • Expert
  • 48 Answers

Hi, you need to be more descriptive with your request.

Posted on Mar 25, 2014

Testimonial: "we checked the control module and it is good.sometimes it starts then quits we notice the coil stop firing and they are all new.and they say it is a control module relay but were is it located."

  • 3 more comments 
  • ianjvr Mar 25, 2014

    Hi, you need to be more descriptive with your request.

    SANDRA DEJEAN Mar 25, 2014

    6 cyclinder 1994 isusuzrodeo quit firing at times and we dont believe its the timing cause it runs good andwe changed all 3 coils and had control module check and it is goodwe understand its soppose to have a control module relay but dont know were its located at or is it anything else that sends a signal to the control module to make uit fire and if so where is it located at

  • ianjvr Mar 26, 2014

    Ok, if you send me your email address, I can send you a workshop manual. this can guide you as it will be quite difficult to explain what steps to follow and where to look. It will help as well so you not searching blindly.

    SANDRA DEJEAN Mar 28, 2014

    my email is

    SANDRA DEJEAN Mar 28, 2014

    sorry my email is


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Car starts hard then idles roughly for 2-3min then stalls and dies

It sounds like some thing you have done if the fault started after the tune , did you check the gap on the new plugs, check the firing order as it may be messed up . 4 cylinder 1342 6 cylinder 153624 in direction of rotation.

Dec 03, 2015 | 1996 Nissan Altima

1 Answer

How to tune my 2001 Oldsmobile Intrigue gl

not sure what you mean by how to tune. just change the plugs, plug wires, fuel filter, air filter if needed. this is the usual tune. the good shops will clean the throttle body/plate as well.

Jan 27, 2015 | Oldsmobile Cars & Trucks

1 Answer

2006 Honda crf x. Ran great then bogged till it quit. Drained gas and there was no water, checked fire on plug and it had none, checked another plug and also none..... What is the likely next issue? Also...

If there is no fire on the plugs then the coil pack is probably out and needs replaced. Check the points, if any, and relays/fuses to the ignition. Those are some alternates I thought of last second.

Jan 13, 2013 | Cars & Trucks

1 Answer

Car won't fire

check your fuses as a start then check relays and then fuel pressure because the filter could have only 1000 miles on it and have problems with it and it could also be the coil pack died on it .

Jul 02, 2012 | Hyundai Sonata Cars & Trucks

1 Answer

Code says number one cylender miss fireing just did tune up still miss fireing

Depending on your vehicle is the coil pack good? If so with car running unplug the alternator and see if the engine smooths out, if so replace the alternator. The alternator can have a short inside causing a misfire code, if coil pack, wires, and plugs are good.

Feb 13, 2011 | Ford Mustang Cars & Trucks

2 Answers

Cyl. 3 miss fire code po303

my money would be on the coil cover, especially if it had been a long time since the last tune up. it is certainly worth trying, as this is part of a routine tune up anyways. good luck!

Mar 18, 2010 | 1999 Pontiac Sunfire

2 Answers

2003 dodge durango is hard to start. it turns over and over before it fires

tune up time change plugs wires pour injector cleaner into gas tank change fuel filter

Mar 08, 2010 | 2003 Dodge Durango

1 Answer

Alternator over charge the battery ,i have a tune up done on the van but no fire i put it on the machine result igin coil change it no better

If the alterantor is OVER-charging the battery (or not charging it, either way) then the regulator is most likely bad. These are not generally replaceable, so you have to replace the whole alternator.

i hope this helps,

Oct 21, 2009 | 2000 Dodge Caravan

2 Answers

Tune up and clean the throttle plate

Ford is notorius for bad breathing.There EGR system is terrible, it always causes a lot of carbon build up in the throttle plates. The best thing to do, is to take of the throttle body assembly and digg out the carbon thats restricting the air flow. Also, it is a good rule or thumb to clean the throttle plate with carb & throttle cleaner with a tooth brush. Add a bottle of fuel injector cleaner to a full tank of gas. While your doing all this you might as well change the EGR valve. If you follow the air intake pipe from the air filter box, it should lead you to the throttle body assembly. The EGR valve is located on the passenger side by the fire wall underneath the heater hoses and AC lines. Good luck, Ford engineers must have been drinking when they designed their vehicles, they don't make anything easy.

Mar 31, 2009 | 1991 Ford LTD Crown Victoria

Not finding what you are looking for?
1994 Isuzu Rodeo Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

75051 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides