Question about Cars & Trucks
I had this problem in a 94 suburban. The trailer light plug had a short that cause the aux power (12volt) short to the park lights.
Posted on Jul 03, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Blower won't shut off
You will need a Blower motor resistor and maybe a blower motor resistor connector end. If you look under the dash on the passenger side(may need to remove smooth black cover, vents will be sticking out) you will see a connector going straight up into the blower motor resistor(7 wires/slightly in front of blower motor). Pull out the connector and check for melted terminals/wires. If no melted terminals just replace blower motor resistor with part # 89019088 per GM to revert to part before 04 in order to stop blower motor resistor relay from hanging. Let me know if i can help more.
Posted on Jan 02, 2009
1994 Chevy Truck K 2500 Suburban 4WD V8-393 6.5L DSL
Fuel Cut Solenoid: Testing and Inspection
An inoperative shutdown solenoid can cause a no-start condition. Disconnect solenoid harness connector and with ignition switch in the "ON"
position momentarily touch solenoid harness connector to solenoid connector. If a "click" sound is heard, the solenoid circuit is operating
properly. If "click" is not heard, the system should be diagnosed as follows:
1. With test lamp connected to ground and the ignition switch in the "ON" position, backprobe the shutdown harness connector. If the test lamp
does not light check for open circuit form the ignition switch to the solenoid.
2. If the test lamp lights, check the ground circuit between solenoid stud and injection pump cover to see if connectors are clean and tight. If the
connections are not clean and tight repair and retest.
3. If the ground circuit is "OK", remove the injection pump cover. Connect a jumper wire between solenoid ground connector and ground. With
the ignition switch in the "ON" position, momentarily touch shutdown solenoid harness connector to shutdown solenoid terminal. If solenoid
operates, check for internal injection pump problem.
4. If the solenoid will not operate, replace the shutdown solenoid.
Fuel Cut Solenoid: Service and Repair
REMOVE OR DISCONNECT:
1. Remove pump cover.
2. Terminal contact nuts.
INSTALL OR CONNECT:
1. Solenoid in the pump cover.
- On the shutdown solenoid, make sure that the linkage is free.
- On the cold advance solenoid, make sure that the plunger is centered so that it will contact the check ball in the fitting.
2. Insulating washers on the terminal studs.
3. Terminal nuts and tighten to 1 Nm (9 in lbs).
4. Pump cover.
5. Inspect solenoid operation prior to installing the pump cover. Use a 12 volt DC power source.
Posted on Sep 10, 2009
If you are looking for the fuse box diagrams or any other diagrams for your Ram, check promanuals.net for a factory service manual for around 20 bucks or so. It's an invaluable tool for my Ram 2500.
Posted on Sep 26, 2009
SOURCE: On my 2007 GMC Sierra
I have the same problem on my '07 gmc 2500. I understand there is a problem with the "cannister filter for emission control of fumes from gas tank" (or something like that). Apparently, it is located near the gas tank which causes it to plug up easily from road dust. The fix is to relocate it with long hoses into the engine compartment area. Since the filter alone is $250 (or so I've been told) with labor it's a $350-400 fix. Supposedly, there is no damage that can be done so I'm just tooling along without worrying about it until I have to put the truck in the shop for something else. Seems there ought to be a recall for this, by government motors won't come out with it.
Posted on Jan 16, 2011
Tips for a great answer:
Dec 30, 2016 | 2007 Chevrolet Trailblazer
Dec 02, 2015 | Cars & Trucks
May 30, 2012 | 2001 Chevrolet Silverado 2500HD
Mar 21, 2011 | 2007 Chevrolet Silverado 3500HD New Cars
May 01, 2010 | 2007 Dodge Ram 2500 Mega Cab Laramie
Nov 23, 2009 | 1996 Chevrolet C2500
Nov 14, 2009 | 2000 Chevrolet 2500
Sep 30, 2009 | 2007 Chevrolet Silverado 2500HD
Dec 31, 2008 | 2007 Chevrolet Silverado 2500HD
May 20, 2008 | 2002 Chevrolet Silverado 2500HD
45 people viewed this question
Usually answered in minutes!