Question about 2004 Chevrolet TrailBlazer
The intermidate doesn't work but high speed does
I've got the same problem on a 2003 Chev Express van. It is an intermittent problem so I can't really test it. I believe it is a faulty pulse module. The dealer wants $138 for it but I found it in an auto parts store for $33.
Posted on Jun 20, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Sounds like the multifunction switch located on the
steering column for windshield wiper/washer control.
At any rate it is more than likely a dealer part, but
can be purchased and replaced by a good mechanic.
You would need a repair manual if you want to try it
yourself considering air bag sensor and what not.
Posted on Feb 10, 2011
Tips for a great answer:
Feb 11, 2017 | GMC Cars & Trucks
Feb 09, 2016 | Cars & Trucks
Body control module (BCM)
Wiper PCB relay
Wiper high PCB relay
Windshield wiper motor
Windshield washer fluid pump
Windshield washer fluid level switch
WPR fuse 25 A
WSW fuse 10 A
Low Speed Operation
When the wiper switch is in the low speed position, ground is applied through the switch internal resistor and the wiper switch low signal circuit to the body control module (BCM). In response to this signal, the BCM energizes the WIPER PCB relay by applying battery voltage through the wiper relay control circuit to the coil side of the relay. This allows battery positive voltage from the WPR fuse to flow through the switch input side of the WIPER PCB relay and out to the switch input side of the WIPER HIGH PCB relay. Since the wiper high relay is de-energized and its switch contacts are normally closed to the low speed control circuit of the windshield wiper motor, the motor will operate at low speed.
High Speed Operation When the wiper switch is in the high speed position, ground is applied through the windshield wiper switch high signal circuit to the body control module (BCM) indicating the wiper high speed request. In response to this signal, the BCM then energizes the wiper PCB relay, as stated above, and the wiper high PCB relay by applying ground through the control circuit to the coil side of the relay. With the wiper high relay energized and its switch contacts closed to the high speed control circuit of the wiper motor, the motor will operate at high speed.
Wiper motor high speed operation and the wiper high speed PCB relay can also be commanded ON/OFF by using a scan tool. Refer to Control Module References.
DTC B3715 02: Front Wiper Relay Drive Circuit Short to Ground
DTC B3875 00: Wiper High Speed Relay Circuit
DTC B3922 00: Front Wiper Function Select Circuit
You could Have a switch problem , BCM problem ,PCB relay problem , the pcb relays are non serviceable an the whole under hood fuse box would need to be replaced . Malfunctioning motor bad ground some where etc.....
Dec 20, 2015 | 2008 Chevrolet Impala
Oct 15, 2014 | Cars & Trucks
Sep 15, 2014 | 2008 Jeep Patriot Sport
Nov 05, 2011 | 2006 Chrysler PT Cruiser
May 28, 2011 | 1996 Ford Taurus
Dec 18, 2010 | 1997 Honda CR-V
163 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: