Question about Chevrolet 1500
Drivers side interier door handle I replaced it but can not find the screws for the handle can you help
Take one off the other working door and go to home depot, lowes, or any place that has a nuts and bolt section they should have some also at any auto parts store.
Posted on Mar 19, 2014
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
On almost all GM's there will be a screw in the recess that the handle sits in. After removing this screw, gently wiggle this cup out of it's hole and there should be a metal rod attached to the back of it with a small clip. Unclip this and it's out - installation is the reverse. Just don't lose the clip or let the linkage rod fall down inside or you will have to remove the door panel. It shouldn't take five minutes to replace and most parts stores now carry GM door handle assemblies. Good Luck!
Posted on Jan 11, 2009
The center section does come out it has little tabs front and rear you have to bend it very carfully.GOOD LUCK
Posted on Sep 16, 2009
Testimonial: "Guru thanks, that worked. Panel off but can't access the back side of the exterior door handle to replace the screws that hold it on? Any ideas? "
the linkage behind the handle either the retaining clip broke or popped off need to remove the door panel to check and fix
Posted on Mar 13, 2010
Testimonial: "Thanks I thought it might be a cable or linkage. Much thanks"
Remove screw from inside door grab handle. Remove door panel by carefully prying out plastic clips. Drill or chisel off pop rivets holding the handle on. Pull handle out far enough to disconnect linkage and remove handle. Install new handle and secure to metal panel with new pop rivets or sheet metal screws. It may be easier to reconnect linkages by removing the metal panel also.
Posted on Apr 26, 2010
something puts bcm into safe mode. take neg. battery cable off and touch it to pos. post for 30 sec. leave unconnected for 6 hrs then reconnect. should work after that. just did mine. dealer wanted 400$ to change door switch
Posted on Mar 06, 2011
Tips for a great answer:
Feb 08, 2016 | GMC Cars & Trucks
Dec 26, 2015 | Cars & Trucks
Feb 05, 2018 | 2006 Chevrolet Silverado 1500 2WD
Feb 25, 2018 | 1999 Chevrolet Silverado 1500
Dec 15, 2009 | 2005 Chevrolet Silverado
Mar 31, 2009 | 1999 Chevrolet Silverado 1500
Jan 11, 2009 | 1999 Chevrolet Silverado 1500
Jan 06, 2009 | 2000 Chevrolet S-10
60 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: