Question about 2006 Hummer H3

1 Answer

H3 hummer wet and wont start

I had my windshield replaced last week. We had a bad strom last night. This morning my front carpets are wet and the hummer wont start. Could this be related, what do I look for to try drying out, is it fixable?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 60 Answers

I'm not a Hummer mechanic but I would say it is related, and I would go on to suppose that the fuse panel got wet and caused your troubles. I hope you had a reputable glass shop install your glass because they will be responsible for any repairs and damages.

Posted on Mar 18, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
goofduck
  • 490 Answers

SOURCE: Hummer H3 rear lights staying on

if it is the brake lights that are on check the brake light switch on the brake pedal

Posted on Apr 21, 2009

  • 1 Answer

SOURCE: 06 hummer h3-water on passenger floor after a rain

Hey I have the same problem, but only when it rains, it comes from the sunroof then leaks into the carpet.

Posted on Aug 19, 2009

  • 1608 Answers

SOURCE: 2006 Humer H3, Won't start and electrical resets itself

Check the battery terminals real good.Make sure they are clean and tight.Check and see if any of the side terminals are leaking. As far as the blower motor.It is more than likely that the blower motor resistor is bad.It is located by the blower motor.Hope this helps.Good luck.

Posted on Dec 18, 2009

  • 14585 Answers

SOURCE: h3 hummer 2006 model.....hot floor board, passenger side

The hot floor is the catalitic converter. It may be bad, but you need to find out why it got hot. usually lean codes will be present with this problem. could be a bad vacuum leak. mass air flow sensor could be bad. as far as the water being a 2006 I do not think it is the windshield, probably the drain is plugged up for your a/c look under the hood, passenger side, there should be a tube that hangs down around where the a/c lines go in to cabin. you can try to back flush it or run something up in it to free it up. good luck

Posted on Jun 14, 2010

  • 594 Answers

SOURCE: my h3 hummer reduced power signal came on last

SCAN FORE ENGINE CODE

Posted on May 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 06 H3 it wont lock in 4x4 High or low


Hummer X Forum • View topic - H3 no 4x4 at all! - Hummer X Club

www.hummerxclub.com/forum/viewtopic.php?f=25&t=12166
Feb 15, 2010 - 15 posts - ‎7 authors Well another high center incident, #3 for Tink, in her 2006 H3. ... "No SERIOUSLY, don't follow me, you WON'T make it" ... The systems on the H3 are designed to try and lockup wheels via the brakes to allow max torque to the ... 2006 h3 wont start :/
10 posts
Dec 31, 2010
4 Wheel Drive Applications for H3 ...
15 posts
Feb 15, 2010
stuck in high 4 lock ?
12 posts
Apr 24, 2009
H3 Steering Problem
15 posts
Mar 25, 2009
More results from www.hummerxclub.com

Oct 01, 2015 | 2006 Hummer H3

1 Answer

2007 Hummer H3 intermittent starting problem


run the fault codes to get an idea of the failing sensor

Nov 21, 2017 | Hummer H3 Cars & Trucks

1 Answer

1995 GMC K2500 Suburban, engine wont start, it will click, not a battery problem, lights, windows, windshield wipers will all work when ignition is in off position. Wouldn't start last night, fired right...


Sounds like the starter solenoid or the starter itself - probably needs replacing but check the wiring at the starter first (loose connection, frayed wires, etc.).

Oct 08, 2017 | 1995 GMC Suburban

1 Answer

My father purchased a Hummer 2006 H3, 3 months ago... around 1700 miles have been put on I believe. Well it caught on fire last week...The Auto Repair shop said that the fire started in the 'Wire Harness,...


one night my wire harness melted.The next day my wippers wont work,my fan stoped working and my on star sys wont work GM said not there problem.

Nov 09, 2010 | 2006 Hummer H3

1 Answer

H3 hummer 2006 model.....hot floor board, passenger side


The hot floor is the catalitic converter. It may be bad, but you need to find out why it got hot. usually lean codes will be present with this problem. could be a bad vacuum leak. mass air flow sensor could be bad. as far as the water being a 2006 I do not think it is the windshield, probably the drain is plugged up for your a/c look under the hood, passenger side, there should be a tube that hangs down around where the a/c lines go in to cabin. you can try to back flush it or run something up in it to free it up. good luck

Jun 14, 2010 | 2006 Hummer H3

2 Answers

Water leaks in my 2006 hummerh3's right rear cargo area. My rear passengers seat belt gets wet and so does all around the cloth where the split seats are and also on the floor. I have taken it to hummer...


My 06 did this in the front and it was the drain tubes. If you paid to have it fixed, then they should look at it to see if one of the tubes came loose or maybe they didn't connect it properly. I am sure this is the problem (plugged or disconnected drain tubes) but I wouldn't want to pay for it every time it happens. make them fix it permanently!! Good luck with that!!

Feb 05, 2010 | 2009 Hummer H3

1 Answer

2006 Humer H3, Won't start and electrical resets itself


Check the battery terminals real good.Make sure they are clean and tight.Check and see if any of the side terminals are leaking. As far as the blower motor.It is more than likely that the blower motor resistor is bad.It is located by the blower motor.Hope this helps.Good luck.

Dec 18, 2009 | 2006 Hummer H3

2 Answers

06 Hummer H3 Wont Start


loose wire to fuel pump

Jun 09, 2009 | 2006 Hummer H3

Not finding what you are looking for?
2006 Hummer H3 Logo

162 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Brandon Johnson
Brandon Johnson

Level 2 Expert

251 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...