Question about 2006 Cadillac SRX

1 Answer

Shakes when running

The truck shakes when running

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cadillac Master
  • 40,764 Answers

Check for unbalanced tyres or tyres with side wall defects . Check suspension for wear and have a wheel alignment done.

Posted on Mar 18, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

09 Passat epc engine light came on and car is shaking


run the fault codes
indications are injector problems either wiring , or blockage
check fuel pressure as it could also be from low fuel pressure , problem pressure regulator , blocked filter or EVAP venting problem

Aug 04, 2016 | 2009 Volkswagen Passat 2.0T

1 Answer

My 2003 yukon is shaking what can it be ?


A vehicle shaking is usually sigh of misfire, but I it would take three pistons out to make a v8 shake.
If you run it, see if the exhaust smells like rotten eggs. If so don't run it or it could blow the cat converter.

May 10, 2016 | Cars & Trucks

1 Answer

2003,dogde neon,shakes when in drive,,i put it in netral,it stops?


Hello Greg, It's only a guess, but I think you might have a misfire on one or more cylinders causing your shaking problem. If your check engine light is on you may want to run a code scan.

Aug 28, 2014 | Cars & Trucks

1 Answer

What would cause truck to shake very hard or rough when starting?


I really need to know the mileage.....?..also the question isn't very clear ...Is the whole truck shaking roughly or is the engine shaking roughly or is it both the engine and truck shaking..?..Since I am not sure I will answer what I can....Ok......If the truck is shaking while sitting still at idle the engine/trans mounts could be worn and or loose mounting hardware...If the engine is running roughly at idle causing all to shake that bad it could be a number of things causing it as usual...Quite often a faulty plug wire/and or bad plug will make it have a misfire because it will be running on only 5 cylinders..If that's the case it could be more than one bad...A vacuum leak will cause it to perform in the same manner...however all cylinders will be firing..Normally a vacuum leak is easy to pinpoint..however it could be a faulty IAC valve..(IDLE AIR CONTROL)..The idle air control is designed to hold a high idle at start up then slowly bring idle down to proper Rpm.....A faulty TPS (THROTTLE POSITION SENSOR) will also cause a rough running problem..And let's not forget the O2 sensor..(OXYGEN SENSOR)..The O2 sensor controls air/fuel mixture...and yes an exhaust manifold gasket will make it run rough but not too bad...It has a rough running sound more so than causing it to horribly shake..It will shake but not to bad..
it is located at the exhaust side of engine..The exhaust manifold is mounted to the engine exhaust port..the exhaust pipe is mounted to the exhaust manifold and the muffler/cat converter is mounted to the exhaust pipe...You can check the plug wires quickly..With engine running carefully remove plug wires 1 at a time..If the sound of engine gets worse the wire you removed is good..after verifying it is good or bad plug wire back on then pull the next wire..and so on..If you pull a wire off and there is no change in engine operation that is the bad wire..If that is the case change all plugs and wires...One at a time..(It is a good idea to make sure all wires come off easily before starting engine..old wires will come apart easily..grasp wire tightly at boot and twist left to right while pulling..)as far as the other components I spoke as well as many others,the best,easy way is to have it hooked to a scanner and they can check/test all components for proper operation...Now..If it runs good but is shaking the engine/trans mounts are worn as I stated earlier..any loose engine component will cause an engine shake also but you should notice it at a glance...engine mount bolts/nuts being loose can be tightened without changing mounts if caught in time..Trans could be coming loose.also worn clutch will cause vibration...Send more info and I can guide you to remove and replace any faulty components you may find to save you money.........Brooks/Metalpoet.....

May 17, 2014 | 1993 Chevrolet S-10

1 Answer

My car runs at low speed but the car still shaking,Maintain on time, has spent three years Toyota corolla,I want to know what the shaking will what are the reasons?


There are two types of car shake
1, stop idling shaking, this situation is generally low or lack of cylinder engine idle speed. Misfiring need to check the spark plug and the high voltage line! In addition, the nozzle and the solar term door dirty is easy to appear this kind of circumstance! Wash!
2, the driving time jitter, the chassis and a relationship! Because the rod or swing arms open, do a four wheel positioning can be solved!
source: obd2 tool car diagnostic tool

Dec 02, 2013 | Cars & Trucks

1 Answer

Trans mount?


The moun sounds like it is probably bad. But you are addressing SHAKING. Most motors don't SHAKE. It may have a miss to it or not be running smoothly. It may need a tune up or have bad gas. Just remember this car is 12 years old and may need some simple TLC.

Jan 31, 2010 | 1998 Ford Escort

1 Answer

When put into drive the car shakes and stalls. It


I have a 1989 5-series BMW which sometimes stalls after changing from reverse to drive. It also sometimes shakes when first driving in reverse before changing to drive.

Jan 30, 2010 | 1992 Mazda Protege

1 Answer

When i start car it sputters and shakes until 45 mph.


spark plugs wires needs complete tune up also synthetic oil change not designed to run on regular oil then check bearings

Dec 20, 2008 | 1992 Lexus Es 300

Not finding what you are looking for?
2006 Cadillac SRX Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...