Question about 1994 GMC Sonoma

1 Answer

Does a vacuum line go to the transmission on a 1994 GMC Sonoma

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • GMC Master
  • 513 Answers

NO THIS TRANS DOES NOT HAVE A VACUM MODULE, IT IS COMPUTER CONTROLED

Posted on Nov 20, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1998 gmc sonoma push button 4x4 busting diaphram vacuum actuator

On top of the transfer case is a vacuum switch with 3 vacuum lines connected to it. This switch controls when vacuum is applied to the vacuum actuator. This switch can fail partly and allow fluid from the transfer case to be sucked up into the vacuum lines and anything connected to them as well. When you replaced the actuator before, did you notice any oily fluid inside of it?

Posted on Dec 23, 2008

rockitman187
  • 2559 Answers

SOURCE: vacuum diagram for 1994 GMC sonoma truck

a6c17b0.jpg Hope this is big enough to view

Posted on Aug 18, 2010

zappanut
  • 959 Answers

SOURCE: where is the pcm located

The PCM for what ?
There are several PCM ( part controle modules) in any given vehicle... Most are integrated in the ECU .

Posted on Sep 30, 2010

2coolrick
  • 560 Answers

SOURCE: does a 1995 gmc jimmy 4x4 have a vacuum line that

If your transmission is automatic, it probably has a vacuum controlled modulator located on the passenger side near the front of the transmission. It is a round component witha vacuum nipple on it's end and connects to a manifold vacuum source.

Posted on Oct 16, 2010

  • 1 Answer

SOURCE: is there a vacuum hose diagram for a 1992 gmc

I Have a 1993 GMC sonoma,when I give it gas,and try to take off in 1st gear,it's like it wants to stall.I've did the full tune up on it ,even the fuel filter,and still can't figure out what the problem is.Can you please help,Thanks

Posted on Feb 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1994 GMC Sonoma with 4.3 motor starter don't fit flush. What wrong ?


If the drive house on the starter is cast iron it for a standard tranns and will not line up.Because the bell housings on automatic transmission is different.

Aug 18, 2016 | 1994 GMC Sonoma

1 Answer

I have a 1994 gmc Sonoma goes into drive but wont change from 1st an the speedometer wont move stays at 0 what could be the issue??? was running fine in the morning later on the day this happen


GMC Sonoma 2WD Certified Reman Transmissions

www.certifiedtransmission.com/gmc/sonoma-2wd/
Certified Transmission welcomes you to our page with information about the transmissions our specialists remanufacture for the GMC Sonoma 2WD. Certified

Aug 17, 2015 | GMC Cars & Trucks

1 Answer

Fuel pump stays on in 1994 gmc sonoma


for sum reason it is not building pressure could be rubber line inside of gas tank.It could be pumping gas into oil pan because of bad regulator be sure your oil pan is not full of gas

Oct 01, 2014 | 1994 GMC Sonoma

1 Answer

94 gmc sanoma. heater dampers do not work properly. can hear a vacuum leak at rear of heater control switch. new switch at dealer is not available,junk yards no luck. the vacuum hose configuration is what...


From the feed line under the hood,have an
assistant(engine off) blow cigarette smoke into the line,you should be able to see exactly where the leak is.Often is is a hose,not the switch itself.

Oct 05, 2010 | 1994 GMC Sonoma

1 Answer

How to disconnect fuel line from 1994 Sonoma GMC truck that has been sitting for long time to clean out the fuel line


hi ... Raise and support the truck ... just enough to reach the fuel and vent lines. Disconnect the fuel and vent lines using the needle-nose pliers ...there clamps might need screwdriver might wanna drain the tank , if been sitting for long time water and rust mess up your fuel pump,causeing the fuel filter fail. thanks

Sep 30, 2010 | 1994 GMC Sonoma

1 Answer

Vacuum diagram for 1994 GMC sonoma truck


a6c17b0.jpg Hope this is big enough to view

Aug 18, 2010 | 1994 GMC Sonoma

1 Answer

I have a 1998 4-wheel drive gmc sonoma truck 4.3 eng. my 4-wheel drive stopped working do you have any idea what happen?


it could be a vacuum line leak, or the vacuum actulator, also check to see if you have oil in the vacuum line under the truck if you do it would be the vacuum switch on the top of the tansfer case.

Feb 15, 2010 | 1998 GMC Sonoma

3 Answers

No reverse after rebuild on 4L60E Transmission from 1995 GMC Sono


There isn't a modulator on this trans as it is electronic

You can have first gear going forwrd but no reverse. It is possible. The low/ reverse clutch isn't needed to go forward.

Jan 19, 2009 | 1995 GMC Sonoma

1 Answer

1998 gmc sonoma push button 4x4 busting diaphram vacuum actuator


On top of the transfer case is a vacuum switch with 3 vacuum lines connected to it. This switch controls when vacuum is applied to the vacuum actuator. This switch can fail partly and allow fluid from the transfer case to be sucked up into the vacuum lines and anything connected to them as well. When you replaced the actuator before, did you notice any oily fluid inside of it?

Dec 10, 2008 | 1996 GMC Sonoma

Not finding what you are looking for?
1994 GMC Sonoma Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...