Question about 1992 Buick Park Avenue
Back is really bouncy on rear passenger side
Pretty sure your car has struts on the rear and the shock function is part of the strut. Replacing struts is more difficult than replacing shocks and they should be replaced in pairs.
Posted on May 13, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I'd have them checked first to determine if it is actually the shocks, or possibly just a loose or cracked line, which should be a pretty inexpensive fix. If it turns out to be shocks, weigh it out then.
Posted on Dec 12, 2008
Removal & Installation
Here are links to more diagrams. Best of luck on your repair.
Posted on May 20, 2009
SOURCE: 2003 buick lesabre AC problem
You have to find the motor that controls the blend door and open it manually to find out which one is bad there are 3 blend doors on the HV/AC system one will be where the heater core is. The other will be between the vented air and AC? heating system then the third door will operate vents in dash and defrost condition. If you have someone operate them AC system heating system and watch the blend door motors, the one you find not moving will be the one that has the problem. They have vacuum and electrical motors, if it is a acuum motor you can move the door manually with your hand, if it's electric you will have to disconnect the rod by removing the pinch clip off of the rod.
Posted on Jul 10, 2009
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
Posted on Sep 29, 2009
The compressor is actually under the hood in the engine compartment. Think its on the drivers side at the front corner. Fairly small aluminum looking unit with small tube lines running from it to the rear of the car.
Posted on Dec 28, 2009
Tips for a great answer:
Nov 21, 2013 | 2000 Lexus LX470
Sep 22, 2017 | 1995 Buick Riviera
Jan 08, 2018 | 2001 Buick LeSabre
Feb 12, 2012 | 1994 Cadillac DeVille
Dec 02, 2010 | 1999 Buick Park Avenue
Nov 11, 2009 | 1992 Buick Park Avenue
Mar 09, 2009 | 1999 Buick Park Avenue
232 people viewed this question
Usually answered in minutes!