Question about Hyundai Accent

Open Question

My windshield wiper stopped working. They will twitch but not move.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

commanderzod
  • 112 Answers

SOURCE: windshield wipers and washer

Check your fuses

Posted on Nov 05, 2008

  • 1 Answer

SOURCE: WINDSHIELD WIPER FLUID WILL NOT COME OUT BUT WIPERS DO MOVE

I just had this problem and took the car back as I had just bought it. They told me there was a build up of sludge in the washer bottle that had blocked the pipes. They cleaned the pipes and the washer bottle out and it's working like new now!!

Posted on Jan 14, 2009

SOURCE: why isnt my windshield wiper working?

Easy fix. Very very common chevy issue. the wiper motor goes but no wipers, or they work one time and not the next. drove me nuts for two years. It is the wiper control module. The board actually get moisture in it cracks the sod-er joints they are there go get magnifying glass. hair line cracks in the board. how ever good new auto zone advance auto who ever carries the board 30 bucks. located back of the fire wall by the wiper motor. three torx screws. remove torx. care full not to bend prongs when pulling board. replace with new screws and cover and board. seal new cover with silicon rtv so forth to re prevent moisture. when it rains, rain drops on this board by the top crack and will reoccur. but this is sure fix. did my truck and my buddies. Make sure to use silicon or don't waste your time. Been good ever since 1 year now.

Mike

Posted on Feb 03, 2009

  • 2 Answers

SOURCE: 07 Kia Sportage 4x4 V6 Front windshield wipers stopped working.

o yeah take back to dealership where they will fix it for free

Posted on Aug 17, 2009

  • 246 Answers

SOURCE: ford f150 windshield wiper bushing diagram

sounds like a loose nut. there are nuts that hold the wiper arms on, they may be under a cover but theyre at the base of the wiper arm. also there's a nut that holds the wiper linkage onto the wiper motor. if you can move the wipers independently, it's the nuts connecting the wiper arms.if you move one arm and the other moves with it, it's the nut holding the linkage to the motor.

Posted on Feb 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Wiper motor


Possible wiper linkage has broken/seperated from wiper motor. The wiper cowling covering the linkage assembly will need to be removed to inspect/repair

Feb 13, 2016 | 2008 Chevrolet Impala

1 Answer

2005 mercury mountainer windshield wipers won't work at all the rear windshield wiper works...the front windshield wipers just stopped in the middle of the wind shield


sounds like a wiper motor or might be a bad ground try to tap on the wiper motor with a hamer and is it starts to move you will need to replace it

Mar 06, 2015 | Mercury Cars & Trucks

1 Answer

1998 Porsche Boxster windshiled wiper stopped working


Could be loose wiper arm. Are the blades heavy. Too big of wiper blade will cause problems

Nov 15, 2012 | 1998 Porsche Boxster

1 Answer

How do i find the right fuse that is connected to windshield wipers 2001 isuzu rodeo?


If they try to move the fuse is not the issue, You need to check the linkages, they are under the panel where the wiper spindles sit, the plastic ends can break and stop them working.

Mar 12, 2012 | 2001 Isuzu Rodeo

1 Answer

Windshield wipers stop working


At the base of the wiper arm there is a plastic cap,pop this off ,underneath there is a nut that holds the arm in place ,if it gets loose the post will turn inside the blade.Just turn the wipers off and tighten the nuts with the blade in the parked position.

Jan 23, 2012 | 2003 Chevrolet Impala

1 Answer

My windshield wipers stopped working they stopped in the middle of my windshield 2005 kia sorento


does the wiper arms move free if so the linkage assembly has come apart you have to take the plastic part under the windshield off along with the wipers arms to have access to the linkagage ,if the arms ar hard to move possible motor damaged or fuse burnt do basic first check fuses then do the process of elimination ,motor ,linkage good luck

Oct 10, 2011 | 2007 Kia Sorento LX 4x4

2 Answers

Driver's side windshield wiper stopped working duing a heavy rain. I can move it by hand easily. Has the linkage come loose?


Hello, I would say that is exactly what has happened. If you can move the wipers with no resistance it's likely one of the bolts has come loose. Both wiper arms are linked to one wiper motor.

Mar 07, 2010 | 2004 Chevrolet Cavalier

1 Answer

My 92 jeep wranglers windshield wipers stopped working


the wiper needs to be tighten some more, there is a nut that holds the wiper to the motor tight that nut.

Dec 21, 2009 | 1992 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...