Question about Pontiac G6

Open Question

Code p00315 engine cranks and cuts of

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

98 ford f 150 cranks but won't start

May be the fuel cut off switch under the kickpanel

Apr 05, 2017 | Ford Cars & Trucks

1 Answer

The Engine runs well but at times it throtlles as if it the engine is cutting off, but it just continues on....

look for worn / broken wires in the harness to the cam / crank sensors as they may be loosing signal to the ECM which cuts off power
run the fault codes to check for reports

May 07, 2016 | 2004 Suzuki Swift 1.5

1 Answer

When engine is cold crank engine sounds like it missing when temp gets up to 140 or higher cut engine off crank 3 or 4 times and it may run like nothings wrong. Im puzzled?

This could be the signs of your Fuel Pump beginning to fail or the beginning failure of a Fuel Injector, or a poor O2 Sensor. Buy your own personal OBD Code Reader @ your local Auto Parts Store. For about $35 - 50 you can diagnose your own vehicle to get Fault Codes, and learn what the codes mean and how to remedy the Fault.

Apr 24, 2016 | Cars & Trucks

1 Answer

Engine cut out

Yes check little things 1st.
fuel filter clogged
is fuel pressure correct?
Loose wires in the ignition system
Check for codes
Hope this helps Mike

Feb 13, 2016 | Cars & Trucks

1 Answer

Where is the fuelpump reset button on a 1995 Isuzu rodeo 2.6

why not post the symptoms first, then ask questions.

its not a ford, is my first guess.
my guess. your engine will not start.?????????
the 4ZE1 engines.
"The 2.6L 4ZE1 SOHC eight valve engine features 120 hp (89 kW) and was available as an option to replace the 4ZD1 on four-wheel-drive models."
i dont think there is a reset. like seen on FORDS. its no ford.

if the engine wont start (right>?)
but cranks, great and fast....
and spark is good on all cylinders, not just one and is timed right.
then it's a fuel problem (guessing engine good i am, foolish i am...)
so does test fuel run engine for 3 seconds, ???? (need a video of it)
yes, ? then it's a fueling problem.
so next is fuel pressure cranking, you must crank it.
(on mine , i cant hear my fuel pump spin cranking, too noisy starter)
but if i stick hose in the gas filler next and mech 2 cranks, i can hear it spin, other cars, its very noisy, like my new chev, pu truck.

if not spec pressure check the voltage to pump cranking
12vdc, cranking, good, 0v bad.., 6 v bad, 8v bad.
see>? the voltage matters,! @pump pins.......
now if no voltage to pump ,then we scan the PCM. (flash codes )
if the PCM (ECU) seens spark missing , even if good or tacho signals bad, or cmp bad, or ckp bad or , TPS stuck at 4v
the ECU CUTS FUEL and some even cut pump.
this is by law, to stop crash and burn as seen on TV, (omg)

i dont like easter egg hunts, why do that to pro help, and free!

the car has an ECU and all have flash codes.
you insert the diagnostic jumper and crank for 5 seconds, and the ECU tells you why it cut fuel. (4/5 cases)
it will not , if spark plugs are shorted etc.
it will not if the TPS is stuck at 4v output. (unflood feature forever)
but will for 4 other failures.
ckp (if fitted)
tacho pin dead.
ignitor dead.
all efi cars 1988 to now, do that. The CEL lamp blinks. a CODE<
and cost nothing to look, on all cars up to 1995. when the blink codes go dead in USA> forever. (OBD2 tech) EPA laws.

Apr 18, 2015 | Isuzu Cars & Trucks

1 Answer

First wrench light now engine light on 2008MKX Lost some power I cut car off restarted now engine lite stays on car running fine now Also I justed cranked now engine lites off driving fine what's wrong

ray365m most cars have a check engine light but yours has a extra good wrench light you need to have the engine scanned for codes possible crank or cam sensor problem? if that

Jun 28, 2014 | Cars & Trucks

1 Answer

Ineria switch kes cutting off while trying to crank vehicle

Your best bet , take it to a qualified repair shop .

Jul 10, 2017 | Ford Expedition Cars & Trucks

1 Answer

Engine cut out while driving, won't start.

Lets start at the beginning.
If you have a V6 engine you have two cam sensors. And the problem could be the cam sensor(s) is not in sync with the crank sensor due to a problem with the sensor or the timing belt.
Code 340 is for bank one sensor one. You could have as many as 4 sensors depending on which engine you have.
The mass airflow meter code could keep the engine from starting.
The cruise control problem could be related to the cam-crank sensor issue or something else.
You should only have one crank sensor and it is usually near the crank pulley in the front of the engine.

Sep 29, 2012 | 2006 Dodge Stratus

2 Answers

My 2000 Grand Jeep Cherokee cuts off while i'm driving and it gives no kind of sign when it cuts off....

thanks for more info replace the crank sensor it is breaking down when hot once it cools off it will work again .when they go bad the heat from the engine will break down the sensor

Feb 22, 2009 | 2001 Jeep Grand Cherokee

1 Answer

My engine cuts off when driving

get a code check done,it could be a crank or cam sensor going down

Jan 02, 2009 | 2000 Audi A4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides