Question about 2003 Volvo S60

Open Question

Ignition turns over but car will not start

My ignition turns over but the car will not start.

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

OK so my car starts by pushing and popping clutch..does not start by jumper cables..when you turn ignition, everything comes on but the ignition has no pressure while turning key..no resistance.


the ignition is functional in that it is completing the ignition circuit or else it would not start from pushing
could be a problem battery ( have a load test done ) bad ground points , faulty starter relay
if the ignition switch is not operating right when it is turned to the start position it could be not making all the circuits needed to crank the engine and supply power to the ignition

Nov 11, 2016 | 2005 Chrysler PT Cruiser

Tip

How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe


Hi, on most vehicles, the airbag light should come on for at 6 seconds, and then go off if the system is working properly. If there is a fault or a problem in the system, the light will remain illuminated, or flash continuously. If the airbag light does not work properly, some vehicles have an audible tone that sounds indicating a problem with the airbag light system. When the light is on (or the tone is sounding), the airbag will NOT deploy, even in an accident. <br /> The flashing light on your car is telling there is a problem. <br /> <br /> <b>How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe </b> <br /> Ignition Key Method: <br /> <ul> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 2 seconds.</li> <li>START Car (the light may be blinking slower than before).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 3 seconds.</li> <li>START Car.</li></ul> <br /> <b>This is a little easier</b> To reset the light simply turn the iginition to the on position, (you dont need to start it). All the lights should stay on for thier diagnostic check. As soon as the airbag light goes off, before it starts flashing, immeditatly turn the car off. Repeat this 3 or 4 times (turning to on then off) and the light should go away

on Dec 07, 2010 | Infiniti G35 Cars & Trucks

1 Answer

Car wont start turn ignition to start nothing happens,checked relays,turned on ignition jumped starter car started right up.wont start by useing ignition


Try replaceing starter relay with another of your relays. make sure they have the same part number on them if you switch them and it starts replace relay with new.

Feb 20, 2015 | 2004 Lincoln Aviator

1 Answer

My 97 geo prism starts when you put the car to ignite but after that it won't stay running what could it be


First turn of the key energize the car electrical circuits for some circuits radio ets. 2nd turn of the key energize the the starting cycle, when you turn the key to the third spring loaded start mode it completes the circuit to the starter solenoid which engages the starter and start the car, the spring in ignition return the key to ignition on.
Maybe you have a malfunction in the ignition on position. Dont have a large bunch of keys hanging in your ignition, it sings back and forth when the car is in the start mode and cause havoc to your ignition switch.

Jan 12, 2014 | Cars & Trucks

1 Answer

97 cavalier cranks will not start theft light stays on


Is the security light flashing? If so, turn ignition on and wait for 10 minutes and light should stay on solid. Then try and start the car without turning the ignition back off. Then turn off ignition and wait 1 minute. Then turn ignition on and see if security light is flashing. If not try and start your car. If it is flashing, try waiting again with just the ignition on and see if it goes out.

Nov 24, 2012 | Cars & Trucks

1 Answer

My 94 Taurus will not turn over. Lights work...I replaced starter then ignition switch. Car will not turn over. It has a history of intermittent starting problems. It may or may not start. Now it...


They have a bad ignition problem. Its more than likely the ignition. Turn the key on, Then right below the ignition theres a hole. take a long skinny phillips screw driver and push it up through the hole and you will hit a release for the ignition. Push it up as you pull the ignition out. Then try to start the car with a flat head screwdriver. Write back if that doesn't work but i have a feeling it will.

Jul 10, 2011 | 1994 Ford Taurus

1 Answer

Ignition switch stuck will not turn wont ether way


Two causes for this:
(1) steering wheel needs to be turned, then try key again.
(2) faulty ignition switch in need of replacement (including a new set of keys).
When starting a car, the ignition is locked if the wheel has been rotated, which is an anti-theft
feature: the car thinks its being stolen when the wheel is turned while there's no key in the ignition.
To fix: turn the wheel back and forth, returning it (one way or another) to the original position
when the car was turned off, and unlocking the ignition, allowing you to start your car.

May 29, 2011 | 1996 GMC Yukon

1 Answer

The car cranks too much and sounds as though


your fuel pump is getting weak. when you turn your key to the on pos. you should hear a hum from the back of the car. GM's are good for having the fuel pump go out. and you can test it or take it to a shop and have it tested.

Apr 06, 2010 | 2004 Pontiac Grand Am

2 Answers

Need to remove the ignition because it wont turn to start. How do we get the ignition out. Or how to fix so we can turn rhe key and start the car


need to remove the ignition because it wont turn to start. How do we get the ignition out?. Or how to fix so we can turn rhe key and start the car

Jul 04, 2009 | 1996 Chevrolet Cavalier

1 Answer

Car ignition wont start or turn


Could be a bad lock cylinder or broken ignition switch (under the dash on top of the steering column). If you disconnect the switch from the control rod that comes from the cylinder and the cylinder turns you need a new switch.

Jun 17, 2009 | 2002 Cadillac Deville

Not finding what you are looking for?
2003 Volvo S60 Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...