Question about 2011 Toyota Camry

1 Answer

Lean back system

Car turns on after a few seconds it loose power

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Toyota Master
  • 2,494 Answers

Fuel pump or filter could be blocked.

Posted on Dec 21, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine die


system too lean at idle suggests that you have a vacuum leak in system. Check vacuum hoses, under dash controls and the vacuum hose to the transmission. check brake booster for leaks.

Dec 30, 2014 | 2006 Hyundai Santa Fe

1 Answer

2003 ford escape over heats while idleing


There are a few things which should be happening to prevent both problems.

There is a fan relay which senses heat and then turns on the electric cooling fan. Around this time, an idle control should cause the RPM to increase to help circulate the water in the engine.

Sounds like the engine is getting too lean to run because these automatic controls are not working. The hot engine is running lean.

Apr 17, 2014 | 2003 Ford Escape

1 Answer

Power steering hose came loose right front part of car all the fluid ran out. Can I screw it back together/


Yes, if it just came loose, you can just screw it back in snug, the re-fill power steering fluid. Start the car, idle for a few seconds, then turn off and check fluid level beacuse the air will need to bleed out. power steering is a re-circulating system, so the air will just bleed out when it reaches the resevoir.

Oct 16, 2011 | Cars & Trucks

1 Answer

Car will start for a few seconds and cut off then wont start at all also has code p0174 and putters bad when i try to give it gas


this trouble code means your system is running to lean on bank 2, Basically this means that an oxygen sensor in bank 2 detected a lean condition (too much oxygen in the exhaust). On V6/V8/V10 engines, Bank 2 is generally the side of the engine that doesn't have cylinder #1. You will more than likely not notice any drivability problems, although there may be symptoms such as a lack of power, detonation (spark knock), and/or a hesitation/surge on acceleration

Feb 12, 2011 | 2004 Cadillac Seville

2 Answers

I was driving down the road and all of the sudden my 2000 dodge neon lost all power but would idle fine. as soon as i tried to step on the gas peddle the car would bog. I turned the key a few times and got...


CODE P1684 - BATTERY HAS BEEN DISCONNECTED.LOOK FOR LOOSE BATTERY CONNECTIONS. ARE BATTERY ITSELF HAS CELL PLATES SHORT INSIDE OF IT. CODE PO171 - FUEL SYSTEM LEAN. CODE PO462 - FUEL LEVEL SENSOR NUMBER 1 LOW INPUT. ALL YOUR PROBLEMS HAS TO DO WITH CODE P1684. CHECK BATTERY HAVE IT LOAD TESTED AND CHECK BATTERY CABLES FOR TIGHTNESS.TO KEEP FROM LOCKING OUT RADIO TURN IT OFF FIRST BEFORE YOU DISCONNECT NEGATIVE BATTERY CABLE.

Dec 25, 2010 | 2000 Dodge Neon

2 Answers

2005 RX8 heater is blowing cold air. Fluids are topped up.


You need to repair the heater core with a soldering gun.

If you do not have heat, or only have heat, IMHO it is most likey the AC/heater control unit. This is the part which has the AC/heat control buttons and knobs.

Easy Diagnosis:
The easiest way to verify this is to turn on the radio, press and hold the power on/off button and press and hold the scan-up button for a second (full second). The word "A/C TEMP" should appear on the left of the display and a number from 0 to 16 on the right. I suspect yours will have the number 0 (or 16 if heating only problem) displayed no matter where you turn the temperature control knob. If this is the case you could turn the temp. knob to full heat and see if it goes to 16 after pushing down or to the right on the knob.
In a working system, the number moves evenly in increments of 1, from 0 to 16 as you turn the temperature knob.

Easy Fix:
I was able to take mine out and solder 3 loose connections to fix it.

The beginning steps are the same as for any radio removal procedure and check for loose connections.

Dec 14, 2009 | 2005 Mazda RX-8

2 Answers

My 1995 Taurus wont fire in the morning


I agree i would change the fuel filter first its the least exspensive and can only do the car good anyways

Let us know how you get on

Regards
Steve

Dec 11, 2008 | 1995 Ford Taurus

Not finding what you are looking for?
2011 Toyota Camry Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8557 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...