Question about 2005 Hyundai Santa Fe

1 Answer

Left turn signal keeps blowing fuse

Replaced both flashers, get dead short at light bulb sockets, disconected the turn signalswitch and stil have short.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 115 Answers

LEFT TURN SIGNAL SOCKET SHORTED TO GROUND!

Posted on Mar 29, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 566 Answers

SOURCE: 2004 hyundai accent flasher problem

this sound like your flasher unit/relay is faulty as both indicators and 4 way hazard lights are not working chech your h/book for location or look under neath the fuse/relay box cover ?there is usually a diagram of location of fuses//relay

Posted on Nov 05, 2008

  • 87 Answers

SOURCE: 2003 Hyundai Tiburon

The tiburon turn signals are controlled by a bcm (body control module) The bcm controls the ground to the signals. These always go bad and cause the signal to stick on or just not work. hope i was a help.

Posted on Mar 28, 2009

ghost4548
  • 776 Answers

SOURCE: 1997 Hyundai Accent is acting funny in the

There's only one relay, but two fuses, both located in the underhood fuse/relay box.

53ee18a.jpg Sounds like you have a wiring problem since sometime the left works and the right doesn't, then the right works then the left doesn't. Might be the multi-function switch on the steering column in combination with the connector M10-1, EM01, SE14 & 16.

Posted on Jun 28, 2009

  • 104 Answers

SOURCE: turn signals and hazard lights won't work. already

Check the Fuse box loacted inside the hood. Look for the guidance on the top of the fuse box for locating trun signal fuses.

Check whether they are good. If not replace with correct rating fuse. If the problem is not solved still, wiring harness has to be checked as the bulbs & flashers are replaced already.

Posted on Jun 05, 2010

  • 41 Answers

SOURCE: Keep blowing fuses for the wipers, have replaced

Get the wiper motor checked/serviced as it is likely drawing more current due either a ball bearing / bush defect or wear, or its armature is short circuiting

Posted on Oct 16, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Signal fuse keeps blowing


Does the fuse blow on both left and right sides,or just blows randomly or as soon as you put the new fuse in?
Does it have tilt steering?I would check the wiring in the steering column to start.

May 18, 2017 | Cars & Trucks

1 Answer

1996 Toyota corolla keeps blowing dome fuse


Check the cigar lighter for a coin in it.Children put coins in there and it blows the fuse.

Mar 09, 2016 | 1996 Toyota Corolla

2 Answers

My turn signal fuse blowed got new one now they dont work why


canada or USA, (diffr. laws, different wiring, even DRL up there)
station wagon or NOT?
THE TURNS FUSE BLEW OUT. 2nd time, 3rd,,,?????
that means the circuit is overloaded or shorted.! (prevents fire)
but did it blow a 2nd time, why not say so???

all 4 lamps dead. or stuck on, or flash odd. or what? dim?
does the cluster lamp flash, , in blink or emerg. mode?
wont work , means what, (dead or stuck on or dim)?????
do emergency flashers work? ,dead, stuck on what?
does car drive perfect day or night?
are any other things on car dead, of odd acting?
we see all this , 1st 5 min in a shop, zero here.
ive answered Forenza blinks here, many times.
ever search?

ill now answer by guessing USA non stationwagon and no DRL.
dash box fuse 4 kills blinkers

EF1 (engine fuse) 1 good?
dash fuse 14 and EF1 can kills emerg. flasher

so of Emergancy flash lamps blows fuse 14,(smaller of 2)
then the blinkers are in fact shorted.
does it?
if yes, then find out which side blows the fuse 3.
turns left blow or turns right blows.
so if say turns right blows, F4 fuse.
if true ?remove all bulbs front rear right bulbs.
does the fuse hold now,(means not blown)
then buy new lamps there. problem solved
bulbs can in fact short.
not just blow open.
Tell the full story and all this gets easy.
For sure emergency flash,

26123255-vhg5j1pxaeih5p05yacvrs2p-1-0.jpg

Mar 09, 2016 | 2007 Suzuki Forenza Sedan

1 Answer

Why does my turn signal/ hazard light fuse keep blowing out


you have a short in one of the light sockets or a worn wire from the wiring harness. could be the flasher assembly. are the turn signals different bulbs from the brake lights? Does using the brakes blow the fuse? (Rear lights or brake light switch on brake pedal). left or right turn signal blowing the fuse will tell which side has the short. 4 ways only, replace the relay.

May 21, 2015 | 2004 Jeep Grand Cherokee

1 Answer

Where is the flasher indicator located?


I'm not sure what you mean do you mean the emergency flasher
flasher-indicator-location-soz3sbv2bqs4rejfawoh5mfu-1-0.jpg
that's this what is happening exactly are the hazard flashers not working or is it the signals are not working or both ? before you spend any $$$ please check the fuses for both also go to every light bulb socket for the front parking/turn signals and the taillights and check for blown bulbs (if so if they are wet the lights leaking in water) if not change the bulbs and recheck again if bulbs are blowing out or fuses keep blowing the unit above may be shorted out inside for the hazards or the turn signal switch you can check by unplugging them and replacing the fuse then plug one in if the fuse blows you found the component that is the problem a wire may have broken off to so check each socket and a good length of the wires for breakage or the wires are exposed/bare copper touching the body blowing the fuse below is your turn signal switch to get to either one of these you must take off the plastic covers on the steering column everything that I have listed could be the cause here so the process of elimination will help you find the problem also check your owners manual or download it from ford for fuse location
flasher-indicator-location-soz3sbv2bqs4rejfawoh5mfu-1-2.jpg

Mar 27, 2015 | 2001 Ford Focus

1 Answer

1987 ford ranger turn signals keep blowing fuses. have changed flasher fuse and switch on column. just keeps blowing?


first thing i guess to understand what is going on here ,is a little back to basics on how turnsignals work , first item you have is power fuse then it's off to flasher module than it goes to the turnsignal switch on colum ,of course anywhere on it way to there the power could got to ground and cause the fuse to trip, now the power depending on Left or right selection , is directed to lights on both front and back of truck,thankfully rangers don't have em on the side) now any place in this pathway the wire could go to ground and blow the fuse, now to troubleshoot and narrow down the area that fault is located , (1) replace fuse with correct size and ck for proper fit in fusebox and start and operate truck for a few minutes DO not use turnsignals, ck fuse is it still good if so go to step 2 if not stop and ck wire conditions in steering colum and switch(2) start truck and try right hand turn signal only verify lights working ,Ok yes/no if not replace fuse and try left side same way, Ok yes /no if right or left side only blows fuses take ALL bulbS OUT of lights and try again , if fuse still blows then look for wire fault on that side of truck if fuse is still good then look carefull at light bulb sockets for rust and powered corrosion (ill bet an 87 has some ) you may need to replace bulb sockets , they do sell em in autoparts stores .

Jun 30, 2014 | 1987 Ford Ranger

1 Answer

Right front side turn signal does not work replaced all bulbs and checked fuses headlight flashers work when hazards are on front to back except driverside turn signal ,in dash right stays solid left


I don't believe it would be a bad ground for just one light. It could be a wire, a socket connector, or the bulb socket itself. See if the wire has power at the socket when signaling left, with key on. If there is power, probably a bad socket or connector. If no power, check for power coming from flasher-the wire going to front left, or driver's side. If you have power from the flasher, but nothing at the socket, the wire has probably broken.
Good luck.

Feb 06, 2013 | Cars & Trucks

1 Answer

Hazard and turn signals stoped working in my 2005 chrysler pacifica whats wrong with it


Just for the hell of it try pulling the flasher out of it's socket and see if it shorts out I would try another flasher othewise I wonder if you have a direct short in the steering column like in the turn signal switch

Dec 26, 2011 | 2005 Chrysler Pacifica

1 Answer

Why are my turn signals not working?


If they turn signal indicator merely turns on, rather than flash on the dashboard, this is indicative of a blown bulb on the exterior of the car. Check the fender, bumper and tail lights for a lamp that is out. If the turn signal lamp on the dash does NOT come on with a solid arrow? It could be anything from a blown fuse to a dead flasher module. Check fuses for turn/tail/stop light circuits in this case. If any are blown, replace. If the replacement blows the second it touches the panel socket, you may have a short in body harnesses. If it does not blow and you still have no turn signal indicator on dash, check/replace flasher module.

May 10, 2010 | 2001 Cadillac Sts

Not finding what you are looking for?
Cars & Trucks Logo

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...