Question about Chevrolet Cars & Trucks
Why does the "transmission fluid hot light" come and go on and off? Allso, where do I add transmission fluid on a 2002 Chevy Silverado 2500 4X4-is it the same place where I put the dipstick for checking the level of the transmission fluid?
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There is a plug located where the right side axle shaft enters the transmission it is above the pan. To check the fluid level of the transmission the engine must be at operating temp and the vehicle must be level. The must be running and the transmission in park, the plug is then removed and if transmission fluid starts dripping/leaking out it is full. If not transmission fluid should be added till fluid starts leaking from the plug hole, then just reinsert the plug and tighten. Generally this is done with the vehicle on a lift in order to access the plug, you might be able to do this if you have enough room to access the plug remember the vehicle must be level.
Posted on Nov 23, 2008
Tire and wheel assembly Caliper and rotor Wheel speed sensor and brake hose mounting bracket bolt from the steering knuckle Electrical connection for the wheel speed sensor Front drive halfshaft assembly on four wheel drive models Hub and bearing assembly mounting bolts Hub and bearing assembly O-ring seal from the steering knuckle bore (2500 series)
Hub and bearing assembly Hub and bearing assembly mounting bolts. Tighten the bolts to 133 ft. lbs. (180 Nm). Front drive halfshaft assembly on four wheel drive models Electrical connection for the wheel speed sensor Wheel speed sensor and brake hose mounting bracket bolt to the steering knuckle. Tighten to 106 inch lbs. (12 Nm). Rotor Tire and wheel assembly.
Posted on Jan 19, 2010
I had a similar problem with
the Service 4 Wheel Drive light which came on intermittently then became more
consistent in the message center display. It would go into 4 wheel drive if the
message center did not display the Service 4 Wheel Drive message in the message
center, but not when the message was displayed. I found the transfer case
switch module in the dash was defective, and it has been working with no other
problems for three years.
Posted on Jul 22, 2010
Tips for a great answer:
Nov 28, 2013 | 1999 Chevrolet Silverado 1500
Feb 23, 2013 | 2001 Chevrolet Silverado
Feb 09, 2013 | 2001 Chevrolet Silverado 2500
Oct 12, 2012 | Cars & Trucks
May 20, 2011 | 2001 Chevrolet Silverado 2500HD
Mar 05, 2011 | 1994 Chevrolet Silverado 2500
Jan 02, 2011 | 2002 Chevrolet Silverado 2500HD
Jan 18, 2009 | 1995 Chevrolet Silverado 2500
Jul 15, 2008 | 1991 Chevrolet Silverado 2500
181 people viewed this question
Usually answered in minutes!