Question about 2001 Toyota Corolla
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I can get you a diagram on monday but it goes from the alternator to the power steering pump then around the tensioner pulley then around the crank pulley then to the a/c compressor then pull on the tensioner to give you some slack and slip it on the waterpump.I hope that helps.Let me know if you still need the diagram
Posted on Nov 29, 2008
malibluert: YOUR IN LUCK! This series engine is simple and the references aren't hard to find. READY???????
IF you are just trying to reset the belt at the top and have not remover the crank pulley, bring the crank around to Top dead center on the # 1 cylinder,. It will read Zero degrees on the timing mark scale.
Up top, look at the cam gear closely You will see that there are 5 spokes which support the actual gear. Look closer and you will see that one of these spokes has a small hole in it about 3/4th of the way towards the outside of the gear. Position the gear to where that hole is at 12:00 PM. NOW, if you look thorough the hole, you should should see a small notch that the hole should be centered on. If not, move the gear until you can look through the hole and the notch falls dead center. At that point in time, you have the crank ant camshaft in perfect time with each other.
When you put the belt on, make sure that the side which is slack is the tensioner side. You should be able to slip the belt on, matching the teeth with the teeth on the gears to where one side is fairly tight and you can not roll the cam counter clockwise.
IF you are replacing the belt, you have the crank pulley off and you position the woodruff key straight up at 12:00 PM and the procedures are all the same other than that. when you set the tension. A good rule of thumb is to find the longest span of belt, and with your thumb and forefinger twist the belt. if it twists to 45 degrees toward the block, it's perfect. Any more or less, needs to be reset.
I hope my answer suffices. A picture wouldn't be any more clear.
Let me know how you did.
NOTE: This engine does NOT bend valves when a timing belt fails.
Posted on May 06, 2009
The 97 Corolla has three accessory belts. The alternator belt is the one you see when you look down on the passenger side standing near the front of the engine compartment. If fits over the alternator and the engine pulley. The belt beneath it is the a/c belt (if the car has a/c). It fits over the engine pulley and the a/c compressor. The power steering belt is toward the rear of the engine compartment, on the same side. It fits around the engine pulley and the power steering pump.
Replacing the alternator belt is not too difficult. Standing in front of the car and facing towards the rear, loosen the locking bolt under the right side of the alternator. Then loosen the alternator hinge bolt on top of the alternator. Now you are ready to loosen the alternator belt tensioner adjustment bolt, accessed under the alternator from the front. Turn the tensioner until the old belt is loose enough to remove, then turn it further so that the new belt will go on easily. Replace the belt and re-tension until you have about 1/4 in. to 1/8 in. of play in the belt, tighten the lock bolt and the hinge bolt, and run the engine. If the belt squeals it means you need more tension, but do not overtension. Recheck it after a few days.
Posted on Mar 23, 2010
Tips for a great answer:
Jul 05, 2011 | 2000 Dodge Neon
Feb 25, 2011 | 2000 Toyota Corolla
Feb 20, 2011 | 2000 Toyota Corolla
Feb 03, 2011 | 2005 Toyota Corolla
Nov 03, 2010 | 2000 Toyota Corolla
Jul 02, 2010 | 1999 Toyota Corolla
Oct 21, 2009 | 2000 Toyota Corolla
Oct 14, 2009 | 2000 Toyota Corolla
Sep 04, 2009 | 1994 Toyota Corolla
32 people viewed this question
Usually answered in minutes!