Torque settings for toyota run x 1600 16v vvr

Torque setting Toyota Land-cruiser 80 Series 4.5 1995-98
Engine code: 1FZ-FE, 1HD.
Stage 1: 20 Nm (Start tightening bolts from center to outwards)
Stage 2: 39 Nm
Stage 3: Rotate each bolt by 90 Degrees.
Stage 4: Further rotate each bolt by 90 Degrees

main bearing
tighting in the following stages:
22Nm then 44 Nm then 45 degree then 45 degree
big end bearing
20 Nm then 90 degree

Torque: 59 N-m (600 kgf-cm, 43 ft-lbf)

I AM LOOKING FOR CONROD BOLT TORQUE SETTING FOR A TOYOTA 2Z FORKLIFT

You actually have a torque wrench

I would just tighten down good

torque setting for quantum 2.7

it depends on the size of the screws. i recommend to set torque as 100lbs for new bolts, 90 for old bolts

If you have a vehicle application for the motor you can get a Haynes or Chilton manual from your local auto parts store. They usual run around $30.

1st stage 25Nm or 18.5Ft-Lb. 2nd stage 50Nm or 37Ft-Lb. 3rd stage 65Nm or 48 Ft-Lb Torqueing sequence: <-- Front 8 6 1 3 9 10 4 2 5 7

On the V-6 it's 25 Nm (18 ft lbs) on the first pull and then you rotate the next pull 90 degrees using a torque angle wrench.

Checking the specifications for the four cylinder:
25 Nm (18 ft lbs) on first pull and 90 degrees
on the second pull using a torque angle wrench.