Question about 1984 Chevrolet Camaro

1 Answer

Bought the wrong 700r4?!

I bought a 700r4 that was bolted to a v6 91 rs camaro to replace with my v8 camaro. everyone said that it should be universal. well. the one that came off the camaro has a pointed top and the one that i bought has a flat top. and im talking about the bolt pattern by the way. anyway. i havent tried yet but im concerned if itll bolt up or not. i know for sure everything on the v6 tranny looks exactly like a 700r4 except for the bolt pattern. i know its not a 200r4 cuz i matched up the tranny pan with a diagram. please help! thanx

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 57 Answers

I believe the bolt pattern is the same that transmission should bolt up to your v-8 assuming it's a small block, the transmission should work fine, you may need to modify the shifter but everything else should be compatible, if your v-8 is carberated make sure you have the correct throttle link set up because correct tv cable adjustment is critical, the v-6 transmission may have a lighter stack up in the 3-4 drum so dont be to hard on it while in 3rd or 4th.

good luck

wesleyschacht@hotmail.com

Posted on Jun 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gauges in 92 camaro rs stopped working


Remove it..Probably installed incorrectly . Tach is probably incorrectly wired into the distributor harness and effecting rpm voltage to the speedometer and may possibly blown the voltage regulator to the gauge in the dash.

Sep 11, 2017 | 1992 Chevrolet Camaro

1 Answer

Gauges in 92 camaro


if mechacial check spring cable going transmission . check

Aug 21, 2017 | 1992 Chevrolet Camaro

1 Answer

I need to replace the starter on a 1992 Chevrolet Camaro RS with a V8 engine. Can you give me directions?


Remove neg battery cable. Then lift car up. Mark with tape or marker the wires connecting to starter/ solenoid. Then remove the two cables.
Then remove two bolts from starter and drop down or pull up by exhaust manifold if you cannot drop down through bottom.

Go to www.autozone.com and register for full free online repair manual with everything you could ever need for any vehicle

Sep 09, 2009 | 1992 Chevrolet Camaro

1 Answer

My 92 camaro rs v8 won't start.Replaced starter and bypassed VATS


if battery and conectors are very clean and tight,check for bad ground to engine from battery,,also fusable links off of starter or positive small post near fuses, important,,,is the alternator charging ? and have u tried a new battery? voltage should read 13.50 to 14.25 while running 12.5 to 12.65 when not running

Jun 29, 2009 | 1992 Chevrolet Camaro

1 Answer

700r4 not working


Is the fluid level correct.? Might help to change the filter and fluid. does fluid smell burnt.?

May 13, 2009 | 1985 Oldsmobile Delta 88

1 Answer

Cost of replacing fuel pump and filter on 92 camaro


parts around $60.00, labor is 4.5 hours, so here in Calif that job would go out the door at arount $600

May 07, 2009 | 1992 Chevrolet Camaro

2 Answers

Transmission


The transmission is a 700r4 not really a size for this. what you probably mean is what gears are in the differential, these should be either 3.73 or 2.73 depending if manual or auto. (owner of a 92 rs with a 305)

Mar 26, 2009 | 1992 Chevrolet Camaro

2 Answers

What is the bolt pattern on a 1989 Chevrolet Camaro RS V8?


It is 5 Lug o Unless it has the Newer Style Rims
o o and they are 6 Lug. I believe that
o o
these are 5 Lug though

Feb 07, 2009 | 1989 Chevrolet Camaro

Not finding what you are looking for?
Cars & Trucks Logo

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...