Question about Ford E-350

1 Answer

How many bolts are on the starter?

I'm needing to replace starter on my 1999 Ford E-350 van with a 5.4 liter engine

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,959 Answers

There are 2 retaining bolts holding in the starter. http://www.chiltonlibrary.com/content/images/9119/images/91192g15.gif

Best of luck.
Greg

Posted on Jun 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove a starter from a 1999 dodge intrepid. 2.7 liter engine?


the starter is held on by 2 or 3 bolts

1. disconnect the positive cable from the battery
2. press on the brake for 10 sec. to drain all the power out of the vehicles main computer
3. locate the starter and disconnect the positive wire from the starter motor
4. disconnect the ground wire from the starter motor
5. remove the 2 or 3 bolts that hold the starter in ( remember the starter only goes in one way )
6. put in new starter
7. put in the bolts torque the bolts to 23 ft. pounds
8. replace the power to power bolt tighten up tight
9. replace the ground wire to the proper spot
10. return the positive battery wire to the proper spot
11. start the vehicle

Good Luck!

Sep 13, 2011 | 1999 Dodge Intrepid

1 Answer

Removal of starter off a e350 cargo van 7.3 liter diesel year 2000


DISCONECT BATTERY STARTING WITH NEGATIVE
REMOVED WIRES AT STARTER
REMOVED BOLTS HOLDING STARTER TO ENGINE
REPLACE IN REVERSAL

Jul 08, 2011 | 2007 Ford E-350 Super Duty Length XLT

1 Answer

97 i got 83 ford clubwagon,5.8,vin G,2bbl .smooth quite starts til 2000,started dragging,replaced it. grinds since then,5 starters..ruined 3 flywheels. auto zone. engine/trans always bolted tight.i gave...


Before spending any more money you need to check for excessive end play in the crankshaft and if that is the cause then the bearings need to be replaced.NOTE:Ford starters do NOT require shims,you want the gears to mesh deeply as possible,

Jul 28, 2010 | Ford Econoline Wagon Cars & Trucks

1 Answer

How do you change a starter in a 1995 ford E-250 van,5.8 engine,and 8 liters


Look Under Vehicle where the transmission mounts to the engine, you should see the stater mounted to the side. remove bolts 17mm i believe, remove 2 wires attached to starter

Apr 04, 2010 | Ford E-250 Cars & Trucks

1 Answer

Change starter 2005 chevy van express


first disconnect batt positive. jack vehicle up on passenger side. you can see starter at rear of engine. you may have to remove plastic around bellhousing to remove starter. There are two bolts holding starter in place.usually 15 mm socket. there is a small nut holding wire. 5/16 or 11/32 socket.. remove it. large nut usually 13mm socket. once removed just reverse procedure. leave comment if successful.

Mar 21, 2010 | 1999 Chevrolet C2500

1 Answer

Starter Motor Replacement


Try the autozone.com website. Go there and register. It doesn't cost anything and will give you access to an online repair manual for your van. The procedures for changing the starter can be found there. Hope this helps and best wishes.

Aug 08, 2009 | 1999 Plymouth Grand Voyager

3 Answers

I have a 1999 ford 350 econoline with a dead engine. I don't think it is the battery. How hard is it to change the starter myself?


Its pretty simple get a jack and jackstand to support the van locate the starter take out the two or three bolts drop the starter remove the cables and wires make sure you mark your wires so you know how to put them back on bolt the starter back on and your done. Good luck

Jul 10, 2009 | Ford E-350 Cars & Trucks

1 Answer

Replacement bolts for ford e-350 5.8 litre van


The best place to go would most likely be your local for dealership's parts and service dept. Granted, most auto parts stores tend to stock these bolts, but from time to time, I've found that they're not an exace match for the original factory equipment. You can usually rest assured that when you go to the dealership, you'll probably be getting bolts that came out of the same batch that was used to build these vehicles at the factor, ending the worry of wrong-sized bolts and cheap steel. Not only that, we're talking about a few bolts, so you shouldn't have to worry about it costing very much. Hope this proves to be useful and have a great night!

James

Nov 25, 2008 | 2002 Ford E350

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...