Question about 2004 Chevrolet TrailBlazer

1 Answer

Brake light works tail light does not and the bulb is new. I wiggel the connector snd sometimes the tail light comes on the brake light always works when i hit the braks, is this a common problem what should i replace

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,600 Answers

Clean the socket out, if ti's the pug type light use a piece of fine sad paper or thin Emery board to sand the contacts on the bulb and the socket. Also sand ground connection on the chassis of the car in trunk area. and try again socket may be worn out and have to be replaced.

Posted on Jun 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace left rear brake light bulb


1) Open trunk
2) Remove small round plastic access panel with a flat tip screw driver by prying open
3) Remove flat tip screw holding tail light assembly
4) Remove tail light assembly by pulling outward, careful not to break plastic guide/nub
5) Disconnect wiring connectors
6) Remove plastic housing access plate on back of tail light assembly by twisting/turning tabs until they click and then lift access plate from tail light assembly
7) When viewing the the bulbs, the turn signal bulb is the bottom left bulb
8) Install in reverse order, ensuring tail light seal seats properly during installation

Oct 13, 2014 | 1999 Audi A4

2 Answers

Tail lights/turn signals and driver brake lights work, passenger-side brake light doesn't


Find a multimerter or an ohmmeter and someone to work it and test the socket to see if electricity is getting to the bulb. Someone will need to push on the brake pedal whilst someone else tests it.
Sometimes a wire can break, or sometimes a metal contact inside the socket can go bad, or can bend in such a manner that the bulb no longer contacts it. Also, sometimes new bulbs are defective.
Be blessed.

Nov 19, 2013 | 2001 Dodge Grand Caravan

1 Answer

Tail lights work but not brake lights 93 toyota camry


The brake light side of the bulbs is powered by the brake switch and travels thru the turn signal switch.
If the third brake light works, I would guess the problem is in the turn signal switch.

Jul 02, 2012 | 1993 Toyota Camry

1 Answer

The brake lights do not want to work. i have changed the brake switch under the dash and the bulbs on the tail lights.still nothing. i also, changed fuses.


does the high mounted brake light work? the brake switch has 2 contacts one for the high mount (LT BLUE/BLACK) and one for the tail brake lights. The tail/brake light wire is LIGHT BLUE. the main connector between the brake light switch and the tail lights is C208 which is located behind the rear seat, left side. So if there is power coming out of the brake switch OK and no power at the tail lights, check that connector. Hope this helps.

Sep 23, 2011 | 1989 Pontiac Firebird

1 Answer

Only left tail light does not work. left break light works fine. All other lights work. New bulb, good fuse, and new connector that the bulb plugs into. I can ground the middle wire going into the...


poor ground, check the wire harness, this is the one that comes from front of vehicle to the rear and plugs into the wires that go to the rear lights. trace the wire coming out of the light itself and eventually you will see that it comes to a connector that attaches to the wiring harness.

Sep 03, 2010 | Ford Windstar Cars & Trucks

2 Answers

Rear tail lights not working


If both tail lights are not working it is likely to be a fuse or bad connection under the hood or a connector at the back see if you can trace the wires to a connector and see if it is dirlty or corroded.

Mar 02, 2010 | 1996 Dodge Dakota

3 Answers

1993 Supra tail lights not working


there is a switch located on the brake pedal right at the bend(just behind where your foot touches)

Oct 22, 2008 | 1993 Toyota Supra

3 Answers

Brake lights quit working


Tail lights acting insane?

We had the same issue with our 2000 Pontiac Montana. Brake lights, turn signal lights, running lights, back-up lights and emergency flasher didn’t work at all or operated at random. The cause: poorly designed aluminum contacts on the tail light circuit board and wiring harness connector arced over and disintegrated with normal use.

Pull the tail lamp assembly, remove the electrical connector and look for burned contacts on the connector plug and the connector socket (they call this long plastic piece with the socket the circuit board: it includes the four bulb sockets. Replace the circuit board and the wiring connector.

You can DIY this job with basic auto mechanical/electrical skills and tools. The two circuit boards and the two connectors set me back $230 (2009 cost) for new parts. The electrical contacts on the factory replacement parts are improved.

I needed a T-30 torx driver to remove the tail light assembly (you need this to change out bulbs, too), wire cutters, wire strippers, electrical tape and an electrical lug crimper to do the job.

Aug 02, 2008 | 2003 Pontiac Montana

Not finding what you are looking for?
2004 Chevrolet TrailBlazer Logo

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...