I already change the all new bush in both front lower arm, clean and change new rubber boot for ball joint, the same in on tie rod end, new brake pad, new cv rubber boot, but the knocking sound still remain the same, please advise...
SOURCE: knock in right front when turning my 84 chevy c10 truck
next move is upper suspension bush(on top of shocker.)
SOURCE: my 93 lebaron 4 door has a shake int the front end
If it's a slight to moderate shake, it could be a tire balance/front end alignment issue.
SOURCE: how do i remove the front drive shafts on a 97 mazda b2600 4wd to replace the cv boots?
When you did the ball joints you should have pulled the axles
I would guess that you know the axle nut has to come off & that
in most cases you break the bottom ball joint loose, so you can
get the axle out of the steering knuckle
So I will guess you can't get the axle out of the trans
You use a long pry par,3 foot or more & put the end against
a piece of wood, so as not to pry on the aluminum trans case
Then you pop it out with the pry bar.
You don't pry on the axle ,you use the side of the pry bar
to bang it with the end against the wood
Testimonial: "Got it! Thanks for your help."
110 views
Usually answered in minutes!
×