Check engine light fault code PO505

You will need to get a Good Mechanic to look at this. There are 3 completely different problems here so it will need to be properly checked out. I've listed the Trouble Code definitions below.
-The knock sensor looks for signs of the fuel igniting at the wrong point in the sequence.
-The Crankshaft position sensor checks the pistons are in the correct position for the engine electronics to be in the correct sequence.
-The Air Control system is a set of valves that adjust air flow through the engine when running at different speeds. (Slow needs less air, fast needs more air).
Knock Sensors and Crankshaft Position Sensors can be in some ridiculous places on an engine and usually need major surgery to get to them. Air control systems could be anything from a 'sticky' valve to a faulty sensor.

P0325 = Knock sensor (KS) 1, bank 1 - circuit malfunction
P0335 = Crankshaft position (CKP) sensor - circuit malfunction
P0505 = Idle Air Control System

All you need to do is use Google

Type: 1997 Honda OBD PO505

OBD -- before any code, will give you
hours of reading & studying on the internet

P0505 - Idle Control System Malfunctionhttp://engine-codes.com/p0505.htmlForum CodePossible causes- IACV-AAC valve harness is open or shorted
- IACV-AAC valve poor electrical connection
- Faulty IACV-AAC valve

Read more: http://engine-codes.com/p0505.html#ixzz1zVJIt34L

Not sure I know the main concern here

What was the steering issues your working on?

The PO505 is a Generic Code -for Idle Control
System Malfunction

Possibly the Idle Air Control (IAC) system is not functioning properly. The computer gets input from the air conditioning pressure switch, the power steering pressure switch, and the electrical load detector. The computer calculates the total load on the engine and sends a signal to the IAC to correct for it. One of the load detectors may be bad or the IAC may be malfunctioning. The computer could also be at fault but that would be very rare.

per this address "http://www.obd-codes.com/trouble_codes/" p0505 is a "IAC (Idle Air Control) System Malfunction" it gives some good suggestions to look at to find a solution for your problem.

Fix the idle control first, it may be causing the 2nd error code.

CODE PO505 - IDLE SPEED CONTROL SYSTEM MALFUNCTION.SOUND LIKE IDLE SPEED CONTROL ELECTRICAL CONNECTOR IS DISCONNECTED OR HAS FAILED.

po505 idle air control if this is the code all hondas do it eventully, small problem easy fix u have 2 choices either remove the idle air control motor and clean the inside of it u will find it's black and the spring inside is stuck clean it with carb cleaner or gum cutter any parts store will have this it's a dirty job it will work for awhile but to replace it is recommended its not expensive for a new one which u can get at any autoparts store autozone,advanced,napa etc. there is only 2 bolts in most cases maybe 3 i doubt it though if u go online t google and type in th eyear make and model and engine size in ur case it's a 3.0 v6 and look for idle air control locations u'll find it to do this job a shop will charge u anywhere from 100.00 for diag to retrive the code plus the part and the labor so about 250.00-375.00 it will only take u honestly maybe 15 minutes to perform only tools needed are a 10 millimeter wrench there is only 1 connector to disconnect and ur done if u do this u will still have the check engine light because u have not cleared it from the computer to do this just disconnect the negative battery terminal (the black one or has a neg sign - don't disconnect the positive side +)for 5 minutes then reconnect and the computer will have reset no more light. good luck it really is that easy

engine code PO505 is idle control system malfunction, check for vacuum leak