I recently replaced the master and slave cylinder for 1993 Rodeo clutch. While bleeding never got pressure in pedal, have fluid leaking need to know how the lines run around engine to find leak.
SOURCE: I have a 1996 Isuzu
Hello buiskit: My name is Roger and I will help you. If the fluid runs down the firewall or leaks down on the floor board or on your foot. The problem should be the clutch master cylinder. However should the fluid leak at the bell housing area.Then the problem is the slave cylinder. To replace the slave cylinder you will need to pull the transmission in order to replace the slave cylinder. Should you need further help please just ask. Please rate the answer. Thank You for using Fix Ya. Roger
SOURCE: 1992 ISUZU RODEO CLUTCH PROBLEM
could also be the host/tube connecting the master and slave together. Could be a small hole that sucks in air when you let off the clutch and pushing the fluid out on to a host that is so dirty or in such a dark place that you can't see the fluid seeping out on the hose
Good Luck
SOURCE: Low / Soft Clutch Pedal, 1995 Rodeo 2W 2.6L
my rodeo had the same problem i corrected it by bleeding the slave cylinder. and is located on the driver side on the gearbox you will find it if you follow the line from the master cylinder down to the gearbox and if that helps but happens again it might have to be replaced.
SOURCE: soft clutch 1992 isuzu rodeo
If the seals around the shafts of master and slave are tight, they may be concealing a leak with fluid bypassing the piston seals internal to the two assemblies. Either your master or slave cylinders need to be replaced ot have new seals installed. Once you find the culprit and have installed a replacement, you will have to bleed the lines to evacuate air trap in the lines.
SOURCE: Hi, I have a clutch hydraulic pressure build-up in
replace the intermediate unit , it controlls backflow and pressure, this should fix your prob
364 views
Usually answered in minutes!
×