Question about 2011 Ferrari 458 Italia

Open Question

EPB failure warning

Warning light and noise is on

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Red Handbrake warning saying Apply handbrake and not starting


I familiar with this setup, but the car should start with the parking brake on. I could see it warning you if you try to move it with brake set, or maybe even shutting off engine then, but I would never think it would prevent engine from starting. Is this a stick shift or automatic. Make sure transmission is in neutral or park, clutch depressed.

Mar 21, 2015 | 2005 Renault Laguna 1.9

1 Answer

ABS brake noise at every braking; Also sometimes the warning lights(AWD Disabled) comes on while driving and other times the lights don' come on;;AWD still works tho.


Sounds like you need new brake pads , when the pads get worn it triggers the warning replace the brake pads reset the computer this should fix the noise and the warning lights.

Nov 20, 2013 | 2004 Buick Rendezvous

1 Answer

Wv polo warning lights


indicates battery failure or charging circuit failure
get it back to a service dealer for a warranty fix if it is only 1 month old

May 23, 2017 | 2012 Volkswagen Polo

1 Answer

Meaning of warning lights


Manufacturers spend billions of dollars a year refining their cars' on-board diagnostics systems. However, all of the sophisticated diagnostics in the world will do little good if you don't know what the warning lights mean.
Purpose
Modern automobiles have dozens of sensors to monitor engine, braking and chassis performance. Any deviation from the car's established limits will trigger a dashboard warning light.


Check Engine Light
Check engine lights can indicate failure of the emissions system, fuel injection system, faulty sensor feedback, overheating or lack of voltage, transmission failure, and engine knock ignition system failure.


Brake Lights
Almost all cars have two separate lights for the braking system: a red "ABS" (anti-lock braking system) light and "Brake Warning" light. The former indicates failure of the electronic anti-lock system, the latter a loss of fluid pressure in the brake system itself.


Dynamic Warnings
Many modern cars have traction or stability control systems that prevent and notify the driver of tire slippage. These lights can come in the form of amber "SLIP," "TC," or "TRACTION" lights (for spinning tires), or "ESC" (electronic stability control) lights for a sliding vehicle.


Safety Lights
Most cars have a diagrammatic warning that indicates a door that isn't all the way closed, a seat-belt warning light, and an "airbag disabled/enabled" light. Any or all of these will be red or amber.


Read more: Car OBD2 diagnostic tool

Jul 25, 2012 | Cars & Trucks

1 Answer

Well yesturday night coming from work my 1997 cadillac deville dashboard said TRANSMISSION HOT what can i do prevent this again? also my TRACTION CONTROL AND THE ABS SYSTEM lights are On and never turn...


I would open with a visit to a transmission shop. on a car that old you are looking at a rebuild which may well cost more than the car is worth. things, just like people, wear out and break down with age and use. after the transmission is rebuilt you are going to need an engine diagnostic to find out what is making the service engine light stay on. In the olden days cars just broke down with no warning, the silly thought behind the warning lights was that folks would get the cars seen to if they had advance warning of a coming failure. however the sad truth is that the lights just stay on warning of failure until the failure ad then the owner wonders why.

Jun 06, 2011 | Cadillac DeVille Cars & Trucks

1 Answer

How do you set up electric hand brake after fitting rear pads?(appears to be binding on).on s type jaguar.


Bulletin from Jaguar :

Electronic Park Brake (EPB)
Re-Calibration Procedure
2003 MY-ON
S-TYPE
M44998-ON

Issue:
On some 2003 MY-on S-TYPE vehicles, a customer may report a concern of premature
parking brake pad wear or the brakes binding. This condition can result if the electronic
park brake (EPB) system is not re-calibrated after the removal of the rear brake callipers
to replace the brake pads.
Action:
Should a customer express concern regarding the above, refer to the calibration
procedure detailed in this bulletin.

1. Reset the EB module:
a. Switch off the ignition.
b. Disconnect the battery for 30 seconds. For additional information, refer to STYPE
Workshop Manual Section 414-01.
c. Reconnect the battery.
2. Start the engine.
3. Firmly apply and release the foot brake five times.
4. Confirm that the message NOT CALIBRATED" or APPLY FOOT AND PARK
BRAKE" is displayed on the instrument cluster message center. This indicates that
the parking brake is in calibration mode.
5. Lightly press the foot brake pedal.
6. Apply the parking brake by using the EB switch.
7. Release the parking brake.
8. Release the foot brake.
9. Confirm that the brake warning lamp is no longer illuminated on the instrument
pack and that the NOT CALIBRATED" message is no longer displayed in the
message center.
10. Apply and release the EPB five times to ensure no error is present.
_____________________________________________________________________________

NB: It is also possible the actuator is bad though.

Jan 17, 2011 | Jaguar S-Type Cars & Trucks

1 Answer

Warning lights


have obd  scanner run on vehicle 

Sep 12, 2009 | 2000 Saab 9-3 Viggen

2 Answers

How do I change Rear Breaks on 2006 LR3 Land Rover- step by step please


try these websites www.autozone.com and www.alldatadiy.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your SUV wish you the best of luck Michigan Man.

Sep 10, 2009 | 2006 Land Rover Freelander

1 Answer

Brake light bulb failure warning light


brake fluid low, or brake pads need replacing.

Jan 28, 2009 | 1994 Volvo 940

1 Answer

Rear light failure warning light


the warning light desapeared and everthing works as before with no problem. Guess there must be a loose conection? Will see how long it will last......

Sep 18, 2008 | 1997 Toyota Camry

Not finding what you are looking for?
2011 Ferrari 458 Italia Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ferrari Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

902 Answers

yadayada
yadayada

Level 3 Expert

76132 Answers

Are you a Ferrari Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...