Question about 2007 Pontiac Montana
Where is the power/cigarette outlet in the 2007 pontiac Montana? I have found one in the very back of the van but we cannot find one in the front half and unfortunatly our owners manual is in French.
If your model has one in the front, its under the climate control panel.
You can go to Pontiac's website and download an owners manual in English.
Posted on Feb 17, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
the low port is between the engine and the radiator support and the high pressure port is by the cruise controll module
Posted on Sep 10, 2008
For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.
Posted on Feb 14, 2009
I went to bulldogsecurity.com and looked up the wiring diagram for this vehcle. However, prior to checking this part, I would check to see if you have a blown fuse. It doesn't hurt and only takes a few minutes. There should be a fuse for that either somewhere on the side of the dash or near the brake pedal area. If not it may be under the hood, but it should be inside the vehicle. You may have multiple fuse boxes. If it has (2) sliding doors it will have a wire for the auto doors in each kick panel (under the plastic trim/molding) when you open the door and look down you will see all of the trim/molding it should snap out or may be held in place with a screw or (2). Once you remove that you should see the wires. It says for the left side it is either light blue or black and the right side is definitely light blue. Trace this wire until you find out where it ends (the motor or switch to control the auto doors) Then test the switch/motor to see if it is bad.
Posted on Mar 02, 2009
Remove the wheel, remove the hub nut, remove the brake caliper and rotor, put your socket and extension through the hub flange onto the bearing retainer bolts, undo them, release the abs sensor connector if it has it, remove the bearing and hub flange as an assembly, put the new one on and go backwards from here. Torque the hub nut to 180 ft/lbs, your done.
Posted on Apr 08, 2009
Tips for a great answer:
Jun 17, 2016 | 2005 Pontiac Montana SV6
Jan 16, 2016 | 2006 Pontiac Montana SV6
Feb 17, 2015 | 2007 Pontiac Montana
Feb 17, 2014 | 2007 Pontiac Montana
May 18, 2012 | 2006 Pontiac Montana SV6
Mar 01, 2011 | 2004 Pontiac Montana
Nov 16, 2010 | Pontiac Montana SV6 Cars & Trucks
Oct 23, 2009 | 1999 Pontiac Montana
Mar 30, 2009 | 2005 Pontiac Montana SV6
Jan 30, 2009 | 2007 Pontiac Montana
120 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: