Question about 2007 Pontiac Montana
I can not find the power/cigarette outlet in the 2007 Pontiac Montana. There is one in the very back of the van but I cannot find one in the front and unfortunatly the owners manual I have is in French.
Posted by Anonymous on
Power outlet at the bottom of the center console right at the floor. Recommend getting an extension/adapter so you can use it (conveniently) for multiple USB and stadard 12V devices.
Power outlet in the rear is on the LEFT side in the small hatch.
Posted on Jan 23, 2015
The front power outlet is below the tip out tray, in the centre dash console, near the floor. It may have a plastic cover installed. The rear one is located in the rear cargo compartment, on the right hand wall of the van.
Posted on Jan 07, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
the low port is between the engine and the radiator support and the high pressure port is by the cruise controll module
Posted on Sep 10, 2008
check the coolant level fiirst...if that is low it wont give you any heat.....to change the thermostat you have to follow the top radiator hose to the engine.at the send of it you will see a clamp take it loose...then you will see the thermostat housing its held in place by 2 bolts . once you remove them you have the thermostat....make sure you clean all the old gasket material off both the housing and mount.also make sure you get a new gasket.
Posted on Jan 29, 2009
For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.
Posted on Feb 14, 2009
Remove the wheel, remove the hub nut, remove the brake caliper and rotor, put your socket and extension through the hub flange onto the bearing retainer bolts, undo them, release the abs sensor connector if it has it, remove the bearing and hub flange as an assembly, put the new one on and go backwards from here. Torque the hub nut to 180 ft/lbs, your done.
Posted on Apr 08, 2009
Tips for a great answer:
Jun 17, 2016 | 2005 Pontiac Montana SV6
Jan 16, 2016 | 2006 Pontiac Montana SV6
Sep 22, 2015 | 2001 Pontiac Montana
Aug 29, 2015 | 2004 Pontiac Montana
Jul 30, 2014 | 2007 Pontiac Montana
Feb 17, 2014 | 2007 Pontiac Montana
Sep 20, 2012 | 2007 Pontiac Montana
May 18, 2012 | 2006 Pontiac Montana SV6
Mar 01, 2011 | 2004 Pontiac Montana
Feb 07, 2010 | 2007 Pontiac Montana
169 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: