Question about 2006 Ford F-250 Super Duty

1 Answer

Will not start

I have changed the fuel filters and it will not start

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Assuming it is a fuel issue, if you have an electric fuel pump like my F-250 Super Duty Diesel, make sure it is working. Start simple. Check the fuse to the fuel pump. If fuse OK, check the accident reset button (see owner's manual for location). End by pulling the fuel line, turn the key to the "on" postion and see if fuel flows. Be sure to catch the fuel in a container - don't want to make a mess. Good luck!
Tom

Posted on Feb 19, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 F350-7.3 4wheel drive is hard to start after changing fuel filter and fuel pump. Why is it hard to start?


indicates fuel leak back and fuel pressure drop
check filter installation for seal not sitting properly, loose fuel line fitting , pump installed correctly (flow wise ), filter installed correctly (flow wise)
air getting in to fuel lines
the thing you are looking for is indicated by the initial hard start but when started runs ok ( good fuel to the engine eventually) and then by the fact that if the engine is allowed to sit for a long period the problem returns meaning that the fuel pressure is not being held
could even be a problem fuel pressure regulator allowing the fuel to bypass ( no pressure =hard starting) then gets enough pressure to run ok but allows that pressure to drain off over time

Oct 29, 2016 | 1992 Ford F350

2 Answers

I changed my fuel filters on my 6.4 l f150 2008 now won't start .I cycled engine but smelled a faint smell and saw light smoke from under hood .charge batt.still won't spin .did started go out too


F350 6.4 L 2008 Wont Start after Fuel Filter Change - Ford Truck ...

www.ford-trucks.com > ... > Super Duty & Heavy Duty
Dec 8, 2011 - F350 6.4 L 2008 Wont Start after Fuel Filter Change Super Duty & Heavy Duty. ... My only suggestions are change them again or take it to Ford. ...Rancho 9000 shocks 1992 F150 XLT 2x4 Standard Cab Long Bed 302 ... Priming it now won't help, because the air bubbles are already past the fuel return line. 2008 won't start after fuel filter change!
Aug 5, 2012
Fuel Filter change problem
Jan 7, 2011
F-350 won't start after oil change and fuel filters changed ...
Dec 10, 2010
Need help fuel filter change now it wont start
Jul 2, 2010
More results from www.ford-trucks.com

Jan 25, 2016 | Cars & Trucks

1 Answer

How do i go about changing my fuel filter i got a new fuel filter for my 1995 dodge stealth SOHC 6cylnder basic model i know where its located n how to change it over but i heard that i need to find th...


The easiest way to relieve the fuel pressure is to start your engine and pull the Fuel Pump Relay - car should die. Now there is no fuel pressure. Turn the key to the off position and change out the fuel filter. Once the filter is changed, put the relay back in and prime the system - turn the key on (don't start) for a few seconds. Turn off, turn key on for a few seconds then start the car. Check for leaks by filter. Easy peasy. Hope this was helpful :-)

-Scott

Feb 14, 2015 | 1995 Dodge Stealth

1 Answer

How can I fix a no start issue? cranks but won't start


Uh oh, you may have had to bleed the air out of the fuel system after the filter change. You may damage the fuel pump ($$$$$) by cranking the engine with no fuel to lube the very high pressure fuel pump. It started a few times because there was still fuel in the pump. Now it's dry.

May 13, 2014 | 2010 Ford F-250 Super Duty

1 Answer

2010 ford mondeo diesel wont start after changing fuel filter, please help!


on a ford mondeo 08 the fuel filter is at the rear of car u take old filter put in new one fill with fuel put back together then put a pipe on feed [there might be a bleed niple on top that will be easier] suck till fuel comes out conect pipe back turn ignition on for 15 seconds 3 times to clear air then start done

May 20, 2012 | Cars & Trucks

1 Answer

Fuel is flowing from the tank to the engine, but will not start. Engine will start if fuel is provided through the air intake port at the air filter.


check fuel filter and fuel pump,if the filter clugged change it, if pump doesnt work change both pump and filter.

Oct 02, 2010 | 1993 Chevrolet Astro

2 Answers

How to change the fuel filter on a suzuki grand vitara 2.0td with RHZ engine


Fuel FIlter - Removal
  1. Relieve fuel system pressure.
  2. Remove or disconnect the following:
    Negative battery cable Fuel lines from the fuel filter Fuel filter
To install:
  1. Install or connect the following:
    Fuel filter and tighten the bracket bolt. Note the fuel flow directional arrow. Fuel lines to the fuel filter. Negative battery cable
  2. Start the engine and inspect the fuel filter connections for leaks.

  1. Before servicing the vehicle, refer to the Precautions section.
  2. Relieve fuel system pressure.
  3. Remove or disconnect the following:
    Negative battery cable Fuel lines from the fuel filter Fuel filter
To install:
  1. Install or connect the following:
    Fuel filter and tighten the bracket bolt. Note the fuel flow directional arrow. Fuel lines to the fuel filter. Negative battery cable
  2. Start the engine and inspect the fuel filter connections for leaks.
Fuel filter is incorporated in fuel pump assembly in fuel tank.

Hope this help.

May 15, 2010 | 2003 Suzuki Grand Vitara

2 Answers

Changed Fuel Filter with full service but engine not turning on


hello,if your old fuel filter is not dirty,install your fuel filter,sometimes fuel filter is defect even it"s new,hoping there is no fuel leak during your replacement of filter,ty

Apr 20, 2009 | Mercedes-Benz E320 Cars & Trucks

Not finding what you are looking for?
2006 Ford F-250 Super Duty Logo

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...