Question about 1998 Pontiac Grand Prix

1 Answer

What is acc postion - 1998 Pontiac Grand Prix

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

It is the "Accessory" position of your ignition switch.

Posted on Apr 15, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cant get the key to start truck or go into acc postion to remove


Sounds like a couple waffers have broken inside and 1 of them is stuck preventing the cylinder from turning. The waffer is above the shear line.

You will need to remove the bottom cover of the instrument dash to access the ignition cylinder. On the bottom of the cylinder there will be a hole. When the cylinder is in the ACC position, it will provide an opening in that hole so you can depress the lock pin. When the pin is depressed you simply pull out the ignition cylinder as a whole. Since you cannot get to ACC you will need to drill into the little hole until you reach the pin. Then you will have to drill the pin too. After that it will slide right out.

A new ignition cylinder with new keys can be picked up for about $30 on ebay. You could take the new one to a locksmith and have them rekey it to your old keys for about $30.

Mar 12, 2014 | 1998 Toyota Tacoma

1 Answer

No power to my stearing colom 1991 ford bronco


Your 91 Bronco is equipped with a solenoid relay switch...trace your battery cables to locate this switch...on the positive side, a few inches from the battery on the inner fender...be sure all connections are tight and clean before replacing.

Feb 01, 2013 | 1991 Ford Bronco

1 Answer

Key will not stay in the active running postion. the car will start and run fine as long as i hold the key in the forward position. once i release the key is rocks into the a postion where the electricity...


Try spraying some penetrating oil into the key hole. If that does not help you will unfortunately have to replace the lock part of the ignition. To do this you have to strip all the cowling around the lock, insert the key and place it in the ACC position (most probably but could be another position). Look for a tongue or dowel that can be depressed so that the lock section can be pulled out of its housing.

Apr 21, 2011 | 1993 Mazda Navajo

1 Answer

Vehicle will not shift into park and ignition key is stuck in acc 1 postion


CHECK BRAKE LIGHT SWITCH FUSE OR BRAKE - TRANSMISSION SHIFT INTERLOCK SOLENOID FUSE.IF BOTH FUSES OKAY.THE PROBLEM COULD BE A BAD BRAKE LIGHT SWITCH OR A BAD BRAKE TRANSMISSION SHIFT INTERLOCK SOLENOID.YOUR IGNITION SWITCH IS BROKEN.MAKE SURE YOUR BATTERY IS 12.5 VOLTS.IF NOT YOU CANT SHIFT INTO PARK.

Aug 04, 2009 | 1996 Cadillac Seville CA Value

2 Answers

I lost my keys ..only set I had


Call a locksmith or talk to a chevy dealer.

Jul 29, 2009 | 1989 Chevrolet C1500

1 Answer

Afer turning off motor ignition key stops at acc


you need to adjust the brake shift interlock cable other wise known as the bsti solenoid

Apr 17, 2009 | 1999 Mazda Millenia

1 Answer

F 450 instrument cluster has no power and is inop need to trace wires to power source


Interior fuse box fuse no.33(15amp) supplies power in run/acc postion to BK/PK wire pin 19 of cluster.
Interior fuse box fuse no. 45(10 amp) supplies power in the start or run postion on the RD/YE wire pin 20 of cluster.
Interior fuse panel fuse no. 41(10amp) supplies power to the battery saver relay on LG/OG wire pin 11.
Interior fuse panel fuse no. 35(10amp) supplies power to interior lamp relay on BK/LG wire pin 12.
The last 2 are hot at all times.

Apr 11, 2009 | 2004 Ford Super Duty F 450

1 Answer

Key stuck


Under the steering colume the should be a small hole or a small cover that you can take out to reveal a small hole that you can reach up into and push on a silver cylinder type thing pulling it back towards you and that should release the key.

Jan 30, 2009 | 1998 Pontiac Grand Am

1 Answer

Key won't turn on in 96 4runner


stearing wheel in locked postion?

Dec 21, 2008 | 1996 Toyota 4Runner

Not finding what you are looking for?
1998 Pontiac Grand Prix Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...