Question about 1997 Chevrolet Venture

Open Question

Leaking oil seals on 1997 chevy venture van ?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 373 Answers

SOURCE: 2001 chevy venture oil sending unit

HI..
On a problem with oil pressure sensor leaking.
99% you need to replace the sensor with a new one.
Because if you can see the leak is not for the tread or gasket of the sensor.
If you can disconnect the the wire from the sensor.
and try to start you will see the leak coming from inside on the plastic, where the pins. of the sensor.

OK.. I hope this information work for you.
I work on Cars everyday.
Thank you fo use fixya.

Posted on Jul 13, 2008

Ad
  • 1 Answer

SOURCE: Thermostat in a 2003 chevy venture van

the bottom boult is hard but can be done need to use a 10 or 12 stubby wrench and take a pry bar and lighty pry heat shild away to get bottom bolt dont need to take it out all the way just loosen and slide down

Posted on Aug 17, 2008

  • 6 Answers

SOURCE: what is a oil sending unit on 99 chevy venture van?

easy to change u just need a special tool for removed on front of motor at right of oil filter its look like a coolant sensor or a little bottle with a connetor removed the connector and take the tool to remove

Posted on Oct 11, 2008

  • 1 Answer

SOURCE: Thermostat in a 2003 chevy venture van

no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.

Posted on Jan 27, 2009

billie17
  • 84 Answers

SOURCE: need to add 13-4a freon to my 2000 venture chevy van. Where is the pressure hose located?

passengers side under the hood.....by the firewall.....

Posted on May 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil leak on 2000 chevy venture


all mine leak, so
is it a flood,
or just a drip or ? a weep.
leaks come in vast degrees. some are very normal.
on all machines
we clean it 100% then find the leak source , ACTUAL.
then replace the part related to the actual. EG: seal or gaskets.
or cracks, or, defective covers that have porosisty issues.

Jul 14, 2014 | 2002 Chevrolet Venture Passanger

1 Answer

How to change oil on 1997 chevy venture


there is a drain plug on the bottom of the oil pan you remove to drain the oil its ether a 15mm or 14mm wrench while the oil pan is draining out unscrew the filter apply a thin coating of oil on the gasket of the new filter make sure the gasket from the old filter didn't stick to the engine install the drain plug and new filter add 4 quarts of new oil and run the car recheck for leaks and oil level that one holds 4 quarts or 4 and half not sure but 4 will be safe to start the engine

Mar 31, 2012 | 1997 Chevrolet Venture

1 Answer

I have a VERY BAD oil leak on my '97 Chevy Venture van. What all can it be ? Can I fix it myself ?


1st u must clean the engine of all grease and dirt, then run it until u can see the source of the oil leak, based on what is leaking will determine the difficulty of repair at home.

Oct 28, 2010 | 1997 Chevrolet Venture

1 Answer

I have a 1997 Chevy ventura van... Where is the


all you gotta do is follow the top radiator hose to motor,it;s where the hose meets the motor.

Dec 30, 2009 | 1997 Chevrolet Venture

2 Answers

05 chevy venture consuming 2 qts of oil every 500 miles. no visible smoke or oil puddles on the driveway. my van has only 90000 miles on it. the valve seals have been redone


To me that sounds pretty common with that many miles. With out changing piston rings also I wouldn't worry to much but make sure u change ur spark plugs as suggeste to avoid fouling.

Oct 02, 2009 | 2005 Chevrolet Venture

1 Answer

After driveing 1 mile frome cold start van just revs but wont accelerate


Check in your radiator if you don't have transmission fluid in it. And pull the tranny dip stick to see if you don't have water or foam on it. There is a tranny cooler coil inside the radiator to help keep the tranny oil cool. You may have this leaking into the water, if this is the case and you don't take care of it fast it will ruin the tranny too.
I hope this helps.
Sam

May 14, 2009 | 1997 Chevrolet Venture

2 Answers

Chevy Venture Overheating


Almost sounds like the same symptons as my van. Turns out the guage was not the problem. The van was in fact running hot because the electric radiator fans were not kicking in when the engine was hot. I replaced the relay switches for the fans. There are two of these in the fuse panel under the hood. There has been no problem with overheating since

Mar 15, 2009 | 1997 Chevrolet Venture

1 Answer

What is a oil sending unit on 99 chevy venture van?


easy to change u just need a special tool for removed on front of motor at right of oil filter its look like a coolant sensor or a little bottle with a connetor removed the connector and take the tool to remove

Oct 11, 2008 | 1999 Chevrolet Venture

Not finding what you are looking for?
1997 Chevrolet Venture Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...