Question about Cars & Trucks

Open Question

How to remove the seat from E-TON TXL 90 four wheeler

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove drivers seat 2000 gmc jimmy


four nuts 17 mm hold seat and track to vehicle floor, then unplug wiring harness from bottom of seat and remove from vehicle. Caution- seat may have to be adjusted fully forward to remove rear bolts.

Feb 15, 2015 | 2000 GMC Jimmy

1 Answer

How to Remove rear seat on ford telstar


rear seats are removable by lifting the catches at the rear base of the seats where they attach to the floor. There is one on each side, and you have to undo both catches at the same time from behind, and pivot the seat forward, then pull it back..and it will come out. Watch out though, as they seem to weigh a ton.
Other technical services, you can visit here

Sep 18, 2014 | Cars & Trucks

1 Answer

How do I remove the drivers seat in a 2000 Cadilac ?


I'm not positive about the DeVille, but I've removed seats from lots of other vehicles, and some of that may translate over here.

There should be four bolts (studs, really) going down through the floor from the seat mount frame. You should be able to find the four nuts under the vehicle's floor pan, after you jack up the driver's side and put jack stands under it (if it falls, it WILL crush you to death). Loosen those four nuts but don't remove them.

Now back inside, feel underneath the seat - find all the electrical connectors. Unplug them ALL. Doublecheck, triplecheck, make sure you get them ALL.

NOW you can remove the four nuts underneath the vehicle, tip the seat rearward to verify that you got ALL the electrical connectors, and remove it. It's HEAVY.

Jul 25, 2014 | 2000 Cadillac DeVille

1 Answer

How to remove drivers seat


There are four bolts underneath the seat. Unscrew them then lift the seat slowly, please take care when removing as there are some connections you may have to remove from the connectors before removing the seats.

Jul 15, 2014 | 2006 Renault Laguna 2.0

1 Answer

Removal of passenger seat on a 2006 ford fusion


there are four bolts.. 2 can be reached in the back seat and 2 up front just below the seat. remove four bolts and the seat should come right out. the bolts might be hidden under a plastic cover

Jul 18, 2012 | 2006 Ford Fusion

2 Answers

FRONT DRIVERS SEAT IS BROKEN HOW DO I REMOVE


There will be bolts going through brackets at or near each of the four corners. The bolts will be going into the floor. Carefully remove the four bolts and the seat will lift out. When you put a different seat in, make certain that the adjusters are aligned properly on each side of the seat when you start to bolt it in.

Sep 21, 2010 | 2000 Toyota Corolla

1 Answer

I have a 2002 Audi a4 and my mobile phone has fallen under the seat and into the air duct under the seat? help.


You will have to remove the seat. There should only be four bolts that hold it down two in the front and two in the rear. Remove the four bolts with I believe a 14mm socket or wrench lean seat backwards to access the vent under the seat might have to move carpet up to get full access.

Sep 06, 2009 | Audi A4 Cars & Trucks

1 Answer

Remove front seats to clean carpet


there are four (torx) T-40 screws on the four corners of the seat rails. Then disconnect the connectors under the seat and the seats can be removed.(Make sure that the key is off and out of the car before disconnecting the connectors under the seats.) If the key is turned on when a seat is disconnected then the airbag light will be illuminated and the airbags on that seat or both seats can be deactivated.

Jul 05, 2009 | 2004 Mini Cooper

1 Answer

Chevy 1993 half ton 4 wheel drive


Is your 4x4 light coming on? Does the shifter move smoothly into position? I have a 95 that I have just about had every proplem imaginable. Need morre info. John.

Jan 10, 2009 | 1986 Chevrolet K1500

4 Answers

Fuel Pump replacement


you have to remove the rear seats and roll back the carpet. if it is a seven seater you have to take out some ac ducts. then there are two access ports on each side of the floor. they are usually black and have four nuts holding them down you remove those and then you have access to the pump. you need some volvo special tools to remove it. volvo has recall 220 going right now and your fuel pump maybe covered under it. i would definitely talk to the dealership about it. because that would be no out of pocket cost to you

Oct 17, 2008 | 2004 Volvo XC90

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...