Question about 1997 Mazda B-Series

1 Answer

Running lights stop working on my97 mazda b-4000

My driving light don't work

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Mazda Expert
  • 242 Answers

The light switch is at fault or else you have a wiring issue..Check all fuses because some vehicles have Seperate fuses for certain seperate lights?..The light switch Is designed to work both running lights and headlights...Turn the switch halfway on and the running lights come on ...Then turn it all the way on and all lights work...If all fuses are good it should be a faulty light switch...

Posted on Feb 06, 2015


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 2359 Answers

SOURCE: Charge light, abs light, and rear light. Mazda 626 1993 2.5L

It can be as simple as the funny belt tensioner on the alternator!

I hope you got a simple volt meter to check the voltage.

12.8-13.6V is a health battery.

Get someone to help you to put tension on alt. belt.

If it does not look good then change it.

Double check all belts.

The should not give over 1/2" I like to keep them 1/3" of less.

Tighten all connections.

Pull spark plug cap one at at time to check for corrosion.

The coil can cause a lot of problem.

Spend time to grounding and secure all coil boot.

Good luck

Posted on Jul 15, 2009

  • 1627 Answers

SOURCE: Mazda daytime running lights


Posted on Oct 07, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1994 Blazer K1500 The 4-wheel drive stopped working. Lights don't light up to show it is going in, does nothing. Changed the actuator and still does not work. Any ideas?

under the battery there is a diaphram that has a cable that runs to the front differential, if you can squeeze in there and pull on that cable and make it work you would likely have a vacuum problem... they come disconnected from the back of the intake manifold some times, and have seen the vacuum lines come loose at the transfer case.. anyway there is a starting point!

Dec 08, 2011 | Cars & Trucks

1 Answer

99 b-4000. cel lean. o2/mass ok? miss fires driving or idel. cold before warming runs rough/stall/tries to stall. no vacuum leaks.with compressor running heat/ cold would here high pitch/ reving...

If you can find the PCV valve and it's associated plumbing, I promise that you'll find one of the rubber elbows that connects it to the intake manifold has rotted out and is leaking vacuum. This is a very common problem.

Mar 14, 2011 | 1999 Mazda B-Series

1 Answer

Mazda rx8, it ran fine and then while driving just cut out, the red key light came on and when stopped did nothing if try to start, it doesnt even turn, battery fine. the key light comes on for second or...

I was driving my rx8 earlier, and it just cut out, its never done it before, i tryed jump starting it but nothing happened. the battery isnt dead because the radio is still working, could it be the spark plugs ? could that stop the car from starting?

Sep 09, 2010 | 2004 Mazda RX-8

1 Answer

I have problem on lexus es 300 99 year, when i driving at 70 miles my rpm is going to 4000. My overdrive it does not work. I have check engine light and its code is knock sensor bank 2.

My Lexus es 300 most often when engine is warm will not shift in to last gear. Stop engine start it will shift ok when engine is cool. engine pings kock senores. When in gear at high speed the car runs like new?? Car run bad in hot weather. VSC light on. Red light looks a circle with red line through it comes on not always..

Sep 03, 2010 | 1999 Lexus ES 300

2 Answers

When I start up truck oil light is on when its warm it turns this a problem just bought it?

It seems the oil pump is weak. Do an oil and filter change now and every 3000-4000 miles useing only good quality oil.I would guess this engine has high miles.
If you want the light to stay out get a new high volume pump.But I would not worry about it.Just keep the oil and filter changed.

Nov 07, 2009 | 1986 Mazda B-Series

1 Answer

Speedometer, Odometer, Trip Odometer stopped working

yes the transmission speed sensor has most likely failed, to confirm this have a trouble code test run

Jul 05, 2009 | 1996 Nissan Pathfinder

1 Answer

1998 Mazda B4000 climate control fan

replace the blower resister mounted in the blower box

Jun 28, 2009 | 1998 Mazda B-Series

1 Answer

1987 Madza Protege, died while driving lights radio still working

I believe it still may be a weak battery. Try to give your car a jump and see if it starts

Jan 17, 2009 | 1995 Mazda Protege

1 Answer

2005 4x4 4000 mazda super cab

did you check your air mass sensor - meter??
that sounds like your problem.

May 28, 2008 | 2005 Mazda 2WD B Series Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides