SOURCE: Correct way to align timing marks
hi -- the timing marks on a twin cam are tricky!! heres how- turn the motor over to tdc on the bottom pulley,this will align two marks on the lower cog-----now on the top cog,it has an obvious mark near the teeth-- well disregard this for now!! the cog has a hole in it,in one of the spokes,well this goes at 12 o,clock and lines up with a mark you will see on the housing! now if you are right you will see the mark near the teeth is at around 4,oclock---i just did one and it is right--cheers
SOURCE: change the timimg belt on a 1998 hyundai accent
Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.
SOURCE: In order to replace the clutch on a Hyundai Atoz
Where is the overdrive switch on a 2003 Chevrolet Trailblazer
SOURCE: hyundai atoz beeping noise
if you leave a turn indicator on or the lights on or leave the key in the ignition and open the drivers door it will beep.if none of the above then the door sensor could be faulty.does it beep when you are driving??? then you have a fault if not no fault to worry about...
SOURCE: how to fix failed ignition system of 1998 hyundai atoz g4ha engine?
run the fault codes before you waste any more cash.
Testimonial: "thanks for the advice., however there's no fault code retrived when scanned."
172 views
Usually answered in minutes!
×